Searched full:spectrum (Results 1 – 25 of 240) sorted by relevance
12345678910
| /linux-6.12.1/drivers/net/ethernet/mellanox/mlxsw/ |
| D | Kconfig | 55 tristate "Mellanox Technologies Spectrum family support"
71 Spectrum/Spectrum-2/Spectrum-3/Spectrum-4 Ethernet Switch ASICs.
|
| D | spectrum_acl_bloom_filter.c | 10 #include "spectrum.h"
20 * blocks, eRP ID and region ID. In Spectrum-2 and above, region key is combined
31 /* Spectrum-2 and Spectrum-3 chunks */
57 * Spectrum-{2-3}. It is computed, Msbit first, for the Bloom filter
96 /* Spectrum-4 chunks */
99 /* In Spectrum-4, there is no padding. Each chunk size is 20 bytes.
122 /* For Spectrum-4, two hash functions are used, CRC-10 and CRC-6 based.
129 * Spectrum-4. It is computed, Msbit first, for the Bloom filter
168 * Spectrum-4. It is computed, Msbit first, for the Bloom filter
208 * key. The original keys layout is same for Spectrum-{2,3,4}.
[all …]
|
| D | spectrum_nve.h | 10 #include "spectrum.h"
33 u16 ul_rif_index; /* Reserved for Spectrum */
|
| D | cmd.h | 353 * Reserved on SwitchX/-2, Switch-IB/2, Spectrum-1
366 * Reserved on SwitchX/-2, Switch-IB/2, Spectrum-1
724 * Reserved when Spectrum-1/2/3, supported from Spectrum-4 and above.
725 * For Spectrum-4, firmware sets 128 for values between 1-128 and 256 for values
790 * Supported only by Spectrum-2+.
876 * Supported from Spectrum-2 and above.
883 * Valid for Spectrum only
890 * Valid for Spectrum only
899 * Valid for Spectrum only
938 * Reserved when SwitchX/-2, Switch-IB/2 and Spectrum-1.
[all …]
|
| D | reg.h | 88 * Note: Must be set for Spectrum.
320 * For Spectrum-2 when set_vid=0 and smpe_valid=1, the smpe will modify the vid.
334 * For Spectrum: use FID for both Dynamic and Static entries.
400 * For Spectrum-2 when set_vid=0 and smpe_valid=1, the smpe will modify the vid.
414 * For Spectrum: use FID for both Dynamic and Static entries.
459 * For Spectrum this value must be set to 0x1FFF
739 * Reserved on Spectrum.
815 * Reserved when SwitchX/-2 or Spectrum-1.
837 * Reserved when Spectrum-1.
847 * 2: ether_type2 - Reserved when Spectrum-1, supported by Spectrum-2
[all …]
|
| D | spectrum_mr_tcam.h | 7 #include "spectrum.h"
|
| D | spectrum_acl_flex_actions.h | 7 #include "spectrum.h"
|
| /linux-6.12.1/Documentation/devicetree/bindings/clock/ |
| D | ti,cdce925.yaml | 58 spectrum clocking parameters for a board
63 spread-spectrum:
67 spread-spectrum-center:
99 spread-spectrum = <4>;
100 spread-spectrum-center;
|
| D | mediatek,mt8186-fhctl.yaml | 7 title: MediaTek frequency hopping and spread spectrum clocking control
15 Spread spectrum clocking (SSC) is another function provided by this hardware.
35 description: The percentage of spread spectrum clocking for one PLL.
|
| /linux-6.12.1/Documentation/devicetree/bindings/clock/ti/ |
| D | dpll.txt | 43 "ssc-deltam" - DPLL supports spread spectrum clocking (SSC), contains
45 "ssc-modfreq" - DPLL supports spread spectrum clocking (SSC), contains
59 - ti,ssc-deltam : DPLL supports spread spectrum clocking, frequency
61 - ti,ssc-modfreq-hz : DPLL supports spread spectrum clocking, spread
62 spectrum modulation frequency
63 - ti,ssc-downspread : DPLL supports spread spectrum clocking, boolean
|
| /linux-6.12.1/drivers/media/dvb-frontends/ |
| D | cxd2820r.h | 35 * @spec_inv: Input spectrum inverted.
60 * @spec_inv: Spectrum inversion. Default: 0. Values: 0, 1.
89 /* Spectrum inversion.
|
| D | m88ds3103.h | 54 * @spec_inv: Input spectrum inversion.
99 * @spec_inv: Spectrum inversion. Default: 0.
|
| /linux-6.12.1/Documentation/ABI/testing/ |
| D | sysfs-platform-dptf | 134 (RO) Presents SSC (spread spectrum clock) information for EMI
140 [7:0] Sets clock spectrum spread percentage:
147 spectrum clock
153 (Spread spectrum clock) range
|
| /linux-6.12.1/tools/testing/selftests/drivers/net/mlxsw/spectrum/ |
| D | q_in_vni_veto.sh | 48 check_fail $? "802.1ad bridge with VxLAN in Spectrum-1 not rejected"
52 check_err $? "802.1ad bridge with VxLAN in Spectrum-1 rejected without extack"
|
| /linux-6.12.1/tools/testing/selftests/drivers/net/mlxsw/ |
| D | mlxsw_lib.sh | 21 echo "Couldn't determine Spectrum chip revision." \
45 log_test_xfail $src:$caller "(Spectrum-$rev only)"
|
| D | qos_max_descriptors.sh | 64 # 200Mbps. On Spectrum-2, writing a value close to zero instead of zero works
65 # well, but the performance on Spectrum-1 is unpredictable. Thus, do not run the
66 # test on Spectrum-1.
|
| D | tc_sample.sh | 434 # Output traffic class is not supported on Spectrum-1.
480 # Output traffic class occupancy is not supported on Spectrum-1.
524 # Egress sampling not supported on Spectrum-1.
553 # Policy-based sampling is not supported on Spectrum-1.
582 # Policy-based sampling is not supported on Spectrum-1.
634 # Policy-based sampling is not supported on Spectrum-1.
|
| /linux-6.12.1/Documentation/driver-api/thermal/ |
| D | intel_dptf.rst | 214 which is compensated by adjusting Spread spectrum percent. This helps
241 Set the FIVR spread spectrum clocking percentage
244 Enable/disable of the FIVR spread spectrum clocking feature
309 Sets DLVR spread spectrum percent value.
312 Specifies how frequencies are spread using spread spectrum.
|
| /linux-6.12.1/Documentation/virt/hyperv/ |
| D | coco.rst | 49 points on a spectrum spanning the degree of guest enlightenment needed to run
50 as a CoCo VM. Fully-enlightened mode is one end of the spectrum. A full
51 implementation of paravisor mode is the other end of the spectrum, where all
55 does not go this far, and is somewhere in the middle of the spectrum. Some
67 guest enlightenments required" end of the spectrum.
|
| /linux-6.12.1/Documentation/misc-devices/ |
| D | apds990x.rst | 26 might vary quite much depending the spectrum of the light source.
69 on the light spectrum etc.
|
| /linux-6.12.1/Documentation/devicetree/bindings/ata/ |
| D | imx-sata.yaml | 60 fsl,no-spread-spectrum:
62 description: if present, disable spread-spectrum clocking on the SATA link.
|
| /linux-6.12.1/drivers/gpu/drm/amd/pm/swsmu/inc/pmfw_if/ |
| D | smu11_driver_if_sienna_cichlid.h | 906 // SECTION: Clock Spread Spectrum
908 // GFXCLK PLL Spread Spectrum
913 // GFXCLK DFLL Spread Spectrum
918 // UCLK Spread Spectrum
922 // FCLK Spread Spectrum
949 // UCLK Spread Spectrum
1267 // SECTION: Clock Spread Spectrum
1269 // GFXCLK PLL Spread Spectrum
1274 // GFXCLK DFLL Spread Spectrum
1279 // UCLK Spread Spectrum
[all …]
|
| /linux-6.12.1/sound/soc/codecs/ |
| D | tda7419.c | 451 SOC_ENUM("Spectrum Analyzer Q Factor", soc_enum_sa_q_factor),
452 SOC_ENUM("Spectrum Analyzer Reset Mode", soc_enum_reset_mode),
453 SOC_ENUM("Spectrum Analyzer Source", soc_enum_sa_src),
454 SOC_SINGLE("Spectrum Analyzer Run Switch", TDA7419_SA_CLK_AC_REG,
456 SOC_SINGLE("Spectrum Analyzer Reset Switch", TDA7419_SA_CLK_AC_REG,
|
| /linux-6.12.1/drivers/gpu/drm/amd/display/dc/clk_mgr/dce120/ |
| D | dce120_clk_mgr.c | 48 * dce121_clock_patch_xgmi_ss_info() - Save XGMI spread spectrum info
51 * Reads from VBIOS the XGMI spread spectrum info and saves it within
|
| /linux-6.12.1/drivers/phy/starfive/ |
| D | phy-jh7110-pcie.c | 65 /* Configuare spread-spectrum mode: down-spread-spectrum */ in phy_usb3_mode_set()
|
12345678910