Searched full:mpps (Results 1 – 25 of 27) sorted by relevance
12
| /linux-6.12.1/arch/arm/boot/dts/qcom/ |
| D | pm8821.dtsi | 12 pm8821_mpps: mpps@50 {
|
| D | pm8018.dtsi | 27 pm8018_mpps: mpps@50 {
|
| D | pm8841.dtsi | 44 pm8841_mpps: mpps@a000 {
|
| D | pma8084.dtsi | 46 pma8084_mpps: mpps@a000 {
|
| D | pm8921.dtsi | 20 pm8921_mpps: mpps@50 {
|
| D | pm8058.dtsi | 31 pm8058_mpps: mpps@50 {
|
| D | pm8226.dtsi | 145 pm8226_mpps: mpps@a000 {
|
| D | pm8941.dtsi | 122 pm8941_mpps: mpps@a000 {
|
| D | qcom-apq8060-dragonboard.dts | 437 dragon_cm3605_mpps: cm3605-mpps-state {
|
| /linux-6.12.1/arch/arm64/boot/dts/qcom/ |
| D | pmi8994.dtsi | 23 pmi8994_mpps: mpps@a000 {
|
| D | pmi8950.dtsi | 60 pmi8950_mpps: mpps@a000 {
|
| D | pm8994.dtsi | 120 pm8994_mpps: mpps@a000 {
|
| D | pm8950.dtsi | 155 pm8950_mpps: mpps@a000 {
|
| D | pm8916.dtsi | 178 pm8916_mpps: mpps@a000 {
|
| D | apq8016-schneider-hmibsc.dts | 266 pm8916_mpps_leds: pm8916-mpps-state {
|
| D | apq8016-sbc.dts | 723 pm8916_mpps_leds: pm8916-mpps-state {
|
| D | msm8996-sony-xperia-tone.dtsi | 438 pm8994_mpps_defaults: pm8994-mpps-default-state {
|
| /linux-6.12.1/drivers/media/pci/cx18/ |
| D | cx18-av-core.c | 281 * 28.636360 MHz/13.5 Mpps * 256 = 0x21f.07b in cx18_av_std_setup()
341 * For a 13.5 Mpps clock and 15,625 Hz line rate, a line is in cx18_av_std_setup()
343 * specifies 12 luma clock periods or ~ 0.9 * 13.5 Mpps after in cx18_av_std_setup()
355 * (5.6 us + 2.25/2 us) * 13.5 Mpps + 4/2 clocks = 92.79 clocks in cx18_av_std_setup()
401 * For a 13.5 Mpps clock and 15,734.26 Hz line rate, a line is in cx18_av_std_setup()
403 * edge should happen 1.2 us * 13.5 Mpps ~= 16 pixels after the in cx18_av_std_setup()
417 * (5.3 us + 2.5/2 us) * 13.5 Mpps + 4/2 clocks = 90.425 clocks in cx18_av_std_setup()
|
| /linux-6.12.1/Documentation/devicetree/bindings/mfd/ |
| D | qcom-pm8xxx.yaml | 59 "mpps@[0-9a-f]+$":
|
| D | qcom,spmi-pmic.yaml | 201 "^mpps@[0-9a-f]+$":
|
| /linux-6.12.1/drivers/pinctrl/mvebu/ |
| D | pinctrl-armada-cp110.c | 24 * - In Armada7K (single CP) almost all the MPPs are available (except the
26 * - In Armada8K (dual CP) the MPPs are split into 2 parts, MPPs 0-31 from
27 * CPS, and MPPs 32-62 from CPM, the below flags (V_ARMADA_8K_CPM,
|
| D | pinctrl-dove.c | 268 * break other functions. If you require all mpps as gpio
|
| /linux-6.12.1/Documentation/devicetree/bindings/pinctrl/ |
| D | qcom,pmic-mpp.yaml | 166 pm8841_mpp: mpps@a000 {
|
| /linux-6.12.1/Documentation/networking/ |
| D | pktgen.rst | 229 pgset "ratep 1000000" set rate to 1Mpps
|
| /linux-6.12.1/drivers/iio/adc/ |
| D | qcom-pm8xxx-xoadc.c | 288 * matrix where they can be routed to any of the MPPs, not just
|
12