Searched full:mx28 (Results 1 – 25 of 51) sorted by relevance
123
/linux-6.12.1/Documentation/devicetree/bindings/mfd/ |
D | mxs-lradc.txt | 5 for i.MX28 SoC 13 disabled. 5 wires is valid for i.MX28 SoC only. 35 Example for i.MX28 SoC:
|
/linux-6.12.1/Documentation/devicetree/bindings/clock/ |
D | imx28-clock.yaml | 7 title: Freescale i.MX28 Clock Controller 14 ID in its "clocks" phandle cell. The following is a full list of i.MX28
|
/linux-6.12.1/Documentation/devicetree/bindings/net/ |
D | qca,qca7000.txt | 38 /* Freescale i.MX28 SPI master*/ 75 /* Freescale i.MX28 UART */
|
D | microchip,enc28j60.txt | 28 Example (for NXP i.MX28 with pin control stuff for GPIO irq):
|
/linux-6.12.1/drivers/clocksource/ |
D | mxs_timer.c | 22 * The v1 on MX23 only gets 16 bits counter, while v2 on MX28 26 * another for clocksource. MX28 uses timrot 0 and 1, while MX23 43 * on MX28 while timrot2 on MX23.
|
/linux-6.12.1/arch/arm/mach-mxs/ |
D | Kconfig | 17 bool "Freescale MXS (i.MX23, i.MX28) support"
|
/linux-6.12.1/arch/arm/boot/dts/nxp/mxs/ |
D | mxs-pinfunc.h | 3 * Header providing constants for i.MX28 pinctrl bindings.
|
D | imx28-ts4600.dts | 13 model = "Technologic Systems i.MX28 TS-4600";
|
/linux-6.12.1/drivers/gpu/drm/mxsfb/ |
D | Kconfig | 20 i.MX28, i.MX6SX, i.MX7 and i.MX8M).
|
D | mxsfb_drv.h | 5 * i.MX23/i.MX28/i.MX6SX MXSFB LCD controller driver.
|
/linux-6.12.1/Documentation/devicetree/bindings/nvmem/ |
D | mxs-ocotp.yaml | 7 title: On-Chip OTP Memory for Freescale i.MX23/i.MX28
|
/linux-6.12.1/Documentation/devicetree/bindings/rtc/ |
D | fsl,stmp3xxx-rtc.yaml | 7 title: STMP3xxx/i.MX28 Time Clock Controller
|
/linux-6.12.1/Documentation/devicetree/bindings/spi/ |
D | mxs-spi.yaml | 7 title: Freescale MX233/MX28 SSP/SPI
|
/linux-6.12.1/Documentation/devicetree/bindings/crypto/ |
D | fsl-dcp.yaml | 7 title: Freescale DCP (Data Co-Processor) found on i.MX23/i.MX28
|
/linux-6.12.1/Documentation/networking/device_drivers/can/freescale/ |
D | flexcan.rst | 18 The older flexcan cores (integrated into the i.MX25, i.MX28, i.MX35
|
/linux-6.12.1/Documentation/devicetree/bindings/dma/ |
D | fsl,mxs-dma.yaml | 7 title: Freescale Direct Memory Access (DMA) Controller from i.MX23/i.MX28
|
/linux-6.12.1/Documentation/devicetree/bindings/arm/ |
D | fsl.yaml | 89 - description: i.MX28 based Boards 106 - description: i.MX28 Aries M28 SoM Board 112 - description: i.MX28 Aries M28EVK Board 118 - description: i.MX28 Armadeus Systems APF28Dev Board 124 - description: i.MX28 Crystalfontz CFA-10036 based Boards 134 - description: i.MX28 Crystalfontz CFA-10037 based Boards 143 - description: i.MX28 Duckbill 2 based Boards 152 - description: i.MX28 Eukrea Electromatique MBMX283LC Board 158 - description: i.MX28 Eukrea Electromatique MBMX287LC Board
|
/linux-6.12.1/drivers/rtc/ |
D | rtc-stmp3xxx.c | 125 int timeout = 5000; /* 3ms according to i.MX28 Ref Manual */ in stmp3xxx_wait_time() 127 * The i.MX28 Applications Processor Reference Manual, Rev. 1, 2010 in stmp3xxx_wait_time()
|
/linux-6.12.1/drivers/i2c/busses/ |
D | i2c-mxs.c | 106 * @dev_type: distinguish i.MX23/i.MX28 features 143 * For details, see i.MX233 [25.4.2 - 25.4.4] and i.MX28 [27.5.2 - 27.5.4]. in mxs_i2c_reset() 575 * The MX28 I2C IP block can only do PIO READ for transfer of to up in mxs_i2c_xfer_msg() 740 * The hardware (of the i.MX28 at least) seems to add 2 additional in mxs_i2c_derive_timing()
|
/linux-6.12.1/Documentation/devicetree/bindings/mtd/ |
D | gpmi-nand.yaml | 79 WARNING: on i.MX28 blockmark swapping cannot be disabled for the BootROM
|
/linux-6.12.1/drivers/mtd/nand/raw/gpmi-nand/ |
D | gpmi-regs.h | 169 /* MX28 uses this to detect READY. */
|
/linux-6.12.1/include/linux/spi/ |
D | mxs-spi.h | 5 * Freescale i.MX233/i.MX28 SPI controller register definition
|
/linux-6.12.1/Documentation/devicetree/bindings/pinctrl/ |
D | fsl,mxs-pinctrl.txt | 124 Valid values for i.MX28/i.MX23 pinmux-id are defined in
|
/linux-6.12.1/drivers/net/can/flexcan/ |
D | flexcan.h | 26 * MX28 FlexCAN2 03.00.04.00 yes yes no no no no 64
|
/linux-6.12.1/drivers/nvmem/ |
D | mxs-ocotp.c | 194 MODULE_DESCRIPTION("driver for OCOTP in i.MX23/i.MX28");
|
123