Documentation/hwmon/ina2xx.rst

10     Addresses: I2C 0x40 - 0x4f
20     Addresses: I2C 0x40 - 0x4f
30     Addresses: I2C 0x40 - 0x4f
40     Addresses: I2C 0x40 - 0x4f
50     Addresses: I2C 0x40 - 0x4f
59 -----------
61 The INA219 is a high-side current shunt and power monitor with an I2C
65 The INA220 is a high or low side current shunt and power monitor with an I2C
68 The INA226 is a current shunt and power monitor with an I2C interface.
71 INA230 and INA231 are high or low side current shunt and power monitors
75 The shunt value in micro-ohms can be set via platform data or device tree at
76 compile-time or via the shunt_resistor attribute in sysfs at run-time. Please
81 Documentation/hwmon/sysfs-interface.rst. Internally the interval is the sum of
88 ---------------------
91 in0_input		Shunt voltage(mV) channel
92 in1_input		Bus voltage(mV) channel
93 curr1_input		Current(mA) measurement channel
94 power1_input		Power(uW) measurement channel
95 shunt_resistor		Shunt resistance(uOhm) channel
99 ------------------------------------------------
102 curr1_lcrit		Critical low current
103 curr1_crit		Critical high current
104 curr1_lcrit_alarm	Current critical low alarm
105 curr1_crit_alarm	Current critical high alarm
122    - Configure `shunt_resistor` before configure `power1_crit`, because power
124    - Because of the underlying register implementation, only one `*crit` setting