Searched refs:decrease (Results 1 – 25 of 65) sorted by relevance
123
| /linux-6.12.1/drivers/gpu/drm/amd/display/modules/inc/ |
| D | mod_info_packet.h | 68 struct frame_duration_op decrease; member
|
| /linux-6.12.1/drivers/gpu/drm/amd/display/modules/info_packet/ |
| D | info_packet.c | 575 info_packet->sb[4] = (param->increase.support << 6 | param->decrease.support << 7); in mod_build_adaptive_sync_infopacket_v2()
577 info_packet->sb[6] = param->decrease.frame_duration_hex; in mod_build_adaptive_sync_infopacket_v2()
|
| /linux-6.12.1/arch/arm/boot/dts/intel/socfpga/ |
| D | socfpga_arria5_socdk.dts | 92 * adjust the falling times to decrease the i2c frequency to 50Khz
|
| D | socfpga_cyclone5_socdk.dts | 96 * adjust the falling times to decrease the i2c frequency to 50Khz
|
| D | socfpga_arria10_socdk.dtsi | 131 * adjust the falling times to decrease the i2c frequency to 50Khz
|
| /linux-6.12.1/Documentation/leds/ |
| D | leds-mt6370-rgb.rst | 16 can increase or decrease the brightness of the RGB LED via an I2C interface.
|
| /linux-6.12.1/Documentation/hwmon/ |
| D | sht15.rst | 51 measurement and decrease power consumption, while losing on precision.
|
| D | w83793.rst | 91 if tempX_input < thermal_cruiseX - toleranceX, the chip will decrease
|
| D | w83792d.rst | 159 (3) If the temperature goes below the low limit, PWM duty cycle will decrease
|
| /linux-6.12.1/drivers/ras/ |
| D | Kconfig | 22 a failed system increases, then availability will decrease.
|
| /linux-6.12.1/Documentation/scheduler/ |
| D | schedutil.rst | 39 will decrease to reflect the fraction of time each task spends on the CPU
102 highest. UTIL_EST filters to instantly increase and only decay on decrease.
|
| /linux-6.12.1/Documentation/sound/soc/ |
| D | pops-clicks.rst | 52 is heard when the gain increase or decrease changes the mean audio signal
|
| /linux-6.12.1/arch/arm/boot/dts/st/ |
| D | stm32mp135f-dhcor-dhsbc.dts | 387 st,decrease-hs-slew-rate;
405 st,decrease-hs-slew-rate;
|
| D | stm32mp135f-dk.dts | 528 st,decrease-hs-slew-rate;
542 st,decrease-hs-slew-rate;
|
| /linux-6.12.1/fs/ocfs2/ |
| D | Kconfig | 78 this option for debugging only as it is likely to decrease
|
| /linux-6.12.1/drivers/net/ethernet/wiznet/ |
| D | Kconfig | 70 Performance may decrease compared to explicitly selected bus mode.
|
| /linux-6.12.1/arch/mips/cavium-octeon/ |
| D | Kconfig | 10 workarounds will cause a slight decrease in performance on
|
| /linux-6.12.1/arch/sparc/lib/ |
| D | M7memcpy.S | 278 sub %o2, 16, %o2 ! decrease count by 16
291 subcc %o2, 8, %o2 ! decrease count by 8
372 subcc %o2, 8, %o2 ! decrease count by 8
386 subcc %o2, 4, %o2 ! decrease count by 4
618 subcc %o3, 8, %o3 ! decrease count by 8
|
| /linux-6.12.1/Documentation/networking/ |
| D | net_dim.rst | 52 compared in a similar fashion - increase == "better" and decrease == "worse".
55 increase in the interrupt rate is considered "worse" and a decrease is
|
| D | xfrm_device.rst | 19 can radically increase throughput and decrease CPU utilization. The XFRM
|
| /linux-6.12.1/Documentation/PCI/ |
| D | sysfs-pci.rst | 79 echoed into it, it will then return '5'. Echoing a '0' into it will decrease
|
| /linux-6.12.1/Documentation/driver-api/media/ |
| D | v4l2-device.rst | 128 decrease the refcount manually as well by calling:
|
| /linux-6.12.1/Documentation/ABI/testing/ |
| D | sysfs-fs-f2fs | 183 needs to decrease this value to reduce the space overhead.
535 decrease. If you write "0" here, you can initialize
543 decrease. If you write "0" here, you can initialize
551 doesn't decrease. If you write "0" here, you can initialize
|
| /linux-6.12.1/Documentation/RCU/ |
| D | UP.rst | 27 element B. This situation can greatly decrease the life expectancy of
|
| /linux-6.12.1/Documentation/mm/ |
| D | zsmalloc.rst | 263 objects and release zspages. In these cases, it is recommended to decrease
|
123