| /linux-6.12.1/arch/arm/boot/dts/sigmastar/ |
| D | mstar-infinity3.dtsi | 21 turbo-mode;
28 turbo-mode;
35 turbo-mode;
42 turbo-mode;
49 turbo-mode;
56 turbo-mode;
63 turbo-mode;
|
| /linux-6.12.1/Documentation/translations/zh_CN/scheduler/ |
| D | schedutil.rst | 68 4C-turbo; 如果可用并且使能了turbo
69 f_max := { 1C-turbo; 如果使能了turbo
76 我们选择4C turbo而不是1C turbo，以使其更持久性略微更强。
|
| /linux-6.12.1/Documentation/admin-guide/pm/ |
| D | intel_pstate.rst | 222 the so-called "turbo" frequency ranges). In other words, in the passive mode
238 will be referred to as the "turbo threshold" in what follows.
240 The P-states above the turbo threshold are referred to as "turbo P-states" and
241 the whole sub-range of P-states they belong to is referred to as the "turbo
247 Specifically, if software sets the P-state of a CPU core within the turbo range
248 (that is, above the turbo threshold), the processor is permitted to take over
249 performance scaling control for that core and put it into turbo P-states of its
253 the given core, even if it is within the turbo range, whereas all of the later
255 turbo range, even above the one set by software. In other words, on those
256 processors setting any P-state from the turbo range will enable the processor
[all …]
|
| D | intel-speed-select.rst | 75 Intel(R) SST-TF (feature turbo-freq) is supported
155 speed-select-turbo-freq:disabled
184 speed-select-turbo-freq:disabled
216 workload, disable turbo::
299 speed-select-turbo-freq:disabled
303 speed-select-turbo-freq:disabled
312 "speed-select-turbo-freq" (Intel(R) SST-TF) is supported at both performance
573 that turbo is disabled. To disable turbo, execute::
600 frequency as the turbo is disabled). The turbostat output::
731 This feature enables the ability to set different "All core turbo ratio limits"
[all …]
|
| /linux-6.12.1/arch/arm64/boot/dts/renesas/ |
| D | r8a779m3.dtsi | 16 /delete-property/ turbo-mode;
22 turbo-mode;
|
| D | r8a779m5.dtsi | 16 /delete-property/ turbo-mode;
22 turbo-mode;
|
| D | r8a779m1.dtsi | 16 /delete-property/ turbo-mode;
22 turbo-mode;
|
| /linux-6.12.1/Documentation/ABI/testing/ |
| D | sysfs-platform-msi-laptop | 46 Contains either 0 or 1 and indicates if turbo mode is turned
47 on. In turbo mode power LED is orange and processor is
49 only possible to toggle turbo mode state by pressing Fn+F10,
51 If user presses Fn+F10 too frequent, turbo mode state is not
|
| /linux-6.12.1/Documentation/scheduler/ |
| D | schedutil.rst | 68 4C-turbo; if available and turbo enabled
69 f_max := { 1C-turbo; if turbo enabled
76 We pick 4C turbo over 1C turbo to make it slightly more sustainable.
|
| /linux-6.12.1/drivers/iio/adc/ |
| D | ad7944.c | 63 struct gpio_desc *turbo; member
537 adc->turbo = devm_gpiod_get_optional(dev, "turbo", GPIOD_OUT_LOW); in ad7944_probe()
538 if (IS_ERR(adc->turbo)) in ad7944_probe()
539 return dev_err_probe(dev, PTR_ERR(adc->turbo), in ad7944_probe()
544 if (adc->turbo && adc->always_turbo) in ad7944_probe()
|
| /linux-6.12.1/arch/arm/boot/dts/samsung/ |
| D | exynos4412-prime.dtsi | 16 /delete-property/turbo-mode;
|
| D | exynos4212.dtsi | 132 turbo-mode;
|
| D | exynos4412.dtsi | 158 turbo-mode;
|
| /linux-6.12.1/drivers/misc/ |
| D | xilinx_sdfec.c | 411 struct xsdfec_turbo turbo; in xsdfec_set_turbo() local
415 err = copy_from_user(&turbo, arg, sizeof(turbo)); in xsdfec_set_turbo()
419 if (turbo.alg >= XSDFEC_TURBO_ALG_MAX) in xsdfec_set_turbo()
422 if (turbo.scale > XSDFEC_TURBO_SCALE_MAX) in xsdfec_set_turbo()
429 turbo_write = ((turbo.scale & XSDFEC_TURBO_SCALE_MASK) in xsdfec_set_turbo()
431 turbo.alg; in xsdfec_set_turbo()
|
| /linux-6.12.1/drivers/net/wireless/ath/ath5k/ |
| D | reset.c | 672 u32 turbo, mode, clock, bus_flags; in ath5k_hw_nic_wakeup() local
675 turbo = 0; in ath5k_hw_nic_wakeup()
792 turbo = AR5K_PHY_TURBO_MODE; in ath5k_hw_nic_wakeup()
794 turbo |= AR5K_PHY_TURBO_SHORT; in ath5k_hw_nic_wakeup()
825 ath5k_hw_reg_write(ah, turbo, AR5K_PHY_TURBO); in ath5k_hw_nic_wakeup()
|
| /linux-6.12.1/arch/arm/mach-pxa/ |
| D | sleep.S | 116 @ ensure x1 for run and turbo mode with memory clock
128 @ note, turbo is not preserved over sleep so there is no
|
| /linux-6.12.1/arch/arm64/boot/dts/apple/ |
| D | t600x-common.dtsi | 319 turbo-mode;
325 turbo-mode;
331 turbo-mode;
|
| /linux-6.12.1/Documentation/userspace-api/media/dvb/ |
| D | frontend-property-satellite-systems.rst | 74 In addition to all parameters valid for DVB-S, turbo code supports the
|
| /linux-6.12.1/drivers/opp/ |
| D | opp.h | 113 bool turbo; member
|
| D | debugfs.c | 155 debugfs_create_bool("turbo", S_IRUGO, d, &opp->turbo); in opp_debug_create_one()
|
| /linux-6.12.1/arch/arm/mm/ |
| D | proc-mohawk.S | 353 mrc p14, 0, r4, c6, c0, 0 @ clock configuration, for turbo mode
371 mcr p14, 0, r4, c6, c0, 0 @ clock configuration, turbo mode.
|
| D | proc-xsc3.S | 425 mrc p14, 0, r4, c6, c0, 0 @ clock configuration, for turbo mode
443 mcr p14, 0, r4, c6, c0, 0 @ clock configuration, turbo mode.
|
| /linux-6.12.1/Documentation/hwmon/ |
| D | oxp-sensors.rst | 85 Read Write. Read this attribute to check the status of the turbo/silent
|
| /linux-6.12.1/Documentation/input/devices/ |
| D | bcm5974.rst | 19 :Copyright: |copy| 2005 Frank Arnold (frank@scirocco-5v-turbo.de)
|
| /linux-6.12.1/Documentation/iio/ |
| D | ad4000.rst | 35 CS mode, 3-wire turbo mode
|