/linux-6.12.1/drivers/scsi/pcmcia/ |
D | aha152x_stub.c | 67 static int synchronous = 1; variable 74 module_param(synchronous, int, 0); 172 s.synchronous = synchronous; in aha152x_config_cs()
|
/linux-6.12.1/drivers/gpu/drm/i915/display/ |
D | intel_fbdev.h | 18 void intel_fbdev_set_suspend(struct drm_device *dev, int state, bool synchronous); 25 static inline void intel_fbdev_set_suspend(struct drm_device *dev, int state, bool synchronous) in intel_fbdev_set_suspend() argument
|
/linux-6.12.1/Documentation/block/ |
D | kyber-iosched.rst | 6 reads and synchronous writes. Kyber will throttle requests in order to meet 15 Target latency for synchronous writes (in nanoseconds).
|
/linux-6.12.1/drivers/hsi/ |
D | Kconfig | 8 The "High speed synchronous Serial Interface" is 9 synchronous serial interface used mainly to connect
|
/linux-6.12.1/drivers/staging/most/Documentation/ |
D | driver_usage.txt | 20 another or in a network configuration. As a synchronous network, MOST 132 synchronous and isochrnous data) 165 Setting up synchronous channels to be mapped as an ALSA sound adapter is a two 199 When transceiving synchronous or isochronous data, the number of packets 205 When transmitting synchronous data the allocated channel width needs to be 210 The driver, then, calculates the synchronous threshold as follows: 220 This frame_size is the number of synchronous data within an USB 232 (subbuffer_size * packts_per_xact) bytes for synchronous data need to
|
/linux-6.12.1/Documentation/hid/ |
D | hid-transport.rst | 79 The terms "asynchronous" and "synchronous" in this document describe the 81 not perform any synchronous operations like waiting for acknowledgements or 84 On the other hand, synchronous channels can be implemented by the transport 105 - Control Channel (ctrl): The ctrl channel is used for synchronous requests and 111 Outgoing reports are usually sent on the ctrl channel via synchronous 142 channel provides synchronous GET/SET_REPORT requests. Plain reports are only 147 requested report ID on the ctrl channel as a synchronous acknowledgement. 168 A device must answer with a synchronous acknowledgement. However, HID core 173 multiple synchronous SET_REPORT requests. 320 be synchronous. A transport driver must not use ->wait() to complete such [all …]
|
/linux-6.12.1/sound/soc/fsl/ |
D | fsl_esai.c | 82 bool synchronous; member 264 bool tx = (clk_id <= ESAI_HCKT_EXTAL || esai_priv->synchronous); in fsl_esai_set_dai_sysclk() 299 ecr |= esai_priv->synchronous ? ESAI_ECR_ETI : ESAI_ECR_ERI; in fsl_esai_set_dai_sysclk() 519 ESAI_SAICR_SYNC, esai_priv->synchronous ? in fsl_esai_startup() 554 ret = fsl_esai_set_bclk(dai, esai_priv->synchronous || tx, bclk); in fsl_esai_hw_params() 563 if (!tx && esai_priv->synchronous) in fsl_esai_hw_params() 1035 esai_priv->synchronous = in fsl_esai_probe() 1039 if (esai_priv->synchronous) { in fsl_esai_probe()
|
D | fsl_sai.c | 58 return !sai->synchronous[dir] && sai->synchronous[adir]; in fsl_sai_dir_is_synced() 495 else if (!sai->synchronous[dir]) in fsl_sai_set_bclk() 800 sai->synchronous[TX] ? FSL_SAI_CR2_SYNC : 0); in fsl_sai_trigger() 802 sai->synchronous[RX] ? FSL_SAI_CR2_SYNC : 0); in fsl_sai_trigger() 1472 sai->synchronous[RX] = true; in fsl_sai_probe() 1473 sai->synchronous[TX] = false; in fsl_sai_probe() 1487 sai->synchronous[RX] = false; in fsl_sai_probe() 1488 sai->synchronous[TX] = true; in fsl_sai_probe() 1491 sai->synchronous[RX] = false; in fsl_sai_probe() 1492 sai->synchronous[TX] = false; in fsl_sai_probe()
|
D | fsl_ssi.c | 258 bool synchronous; member 776 tx2 = tx || ssi->synchronous; in fsl_ssi_set_bclk() 838 if (ssi->streams && ssi->synchronous) in fsl_ssi_hw_params() 862 tx2 = tx || ssi->synchronous; in fsl_ssi_hw_params() 1015 if (ssi->synchronous || fsl_ssi_is_ac97(ssi)) { in _fsl_ssi_set_dai_fmt() 1461 ssi->synchronous = true; in fsl_ssi_probe_from_dt() 1565 if (ssi->synchronous && !fsl_ssi_is_ac97(ssi)) { in fsl_ssi_probe()
|
/linux-6.12.1/Documentation/ABI/testing/ |
D | configfs-most | 23 (needed for synchronous and isochronous data) 78 (needed for synchronous and isochronous data) 133 (needed for synchronous and isochronous data) 199 (needed for synchronous and isochronous data)
|
D | debugfs-scmi-raw | 5 Description: SCMI Raw synchronous message injection/snooping facility; write 6 a complete SCMI synchronous command message (header included) 72 Description: SCMI Raw synchronous message injection/snooping facility; write 73 a complete SCMI synchronous command message (header included)
|
D | sysfs-block-bcache | 97 What: /sys/block/<disk>/bcache/synchronous 101 For a cache, a boolean that allows synchronous mode to be 102 switched on and off. In synchronous mode all writes are ordered
|
/linux-6.12.1/drivers/net/ppp/ |
D | Kconfig | 24 synchronous PPP which can be used over digital ISDN lines for 28 synchronous lines, you should say Y (or M) here and to "Support 29 synchronous PPP", below. 193 a modem (not a synchronous or ISDN modem) to contact your ISP, you 204 Say Y (or M) here if you want to be able to use PPP over synchronous
|
/linux-6.12.1/drivers/scsi/ |
D | aha152x.c | 464 int synchronous; /* synchronous transferes enabled */ member 566 #define SYNCHRONOUS (HOSTDATA(shpnt)->synchronous) 764 SYNCHRONOUS = setup->synchronous; in aha152x_probe_one() 1777 if (!HOSTDATA(shpnt)->synchronous) in msgi_run() 3098 if ((setup->synchronous < 0) || (setup->synchronous > 1)) in checksetup() 3143 override.synchronous, in aha152x_init() 3164 override.synchronous, in aha152x_init() 3182 setup[setup_count].synchronous = aha152x[5]; in aha152x_init() 3192 setup[setup_count].synchronous = sync[0]; in aha152x_init() 3206 setup[setup_count].synchronous, in aha152x_init() [all …]
|
/linux-6.12.1/drivers/phy/sunplus/ |
D | Kconfig | 10 and synchronous signals, various power down modes including
|
/linux-6.12.1/drivers/siox/ |
D | Kconfig | 5 SIOX stands for Serial Input Output eXtension and is a synchronous
|
/linux-6.12.1/Documentation/trace/rv/ |
D | runtime-verification.rst | 84 to be *synchronous* if the processing of an event is attached to the system 89 file. In contrast, *synchronous online* method can react at the exact moment 97 *synchronous online* monitors will incur on lower overhead. 106 Shows that for Deterministic Automata models, the synchronous processing of
|
/linux-6.12.1/Documentation/devicetree/bindings/serial/ |
D | digicolor-usart.txt | 4 UART. USART also support synchronous serial protocols like SPI and I2S. Use
|
/linux-6.12.1/Documentation/driver-api/ |
D | xillybus.rst | 144 Xillybus pipes are configured (on the IP core) to be either synchronous or 145 asynchronous. For a synchronous pipe, write() returns successfully only after 156 has been requested by a read() call. On synchronous pipes, only the amount 159 In summary, for synchronous pipes, data between the host and FPGA is 172 A synchronous pipe can be configured to have the stream's position exposed 216 * synchronous: A non-zero value means that the pipe is synchronous. See 303 the "synchronous" attribute nonzero, since synchronous pipes don't allow data
|
/linux-6.12.1/Documentation/admin-guide/device-mapper/ |
D | dm-io.rst | 5 Dm-io provides synchronous and asynchronous I/O services. There are three 64 all of the synchronous versions, is a bitset (instead of a simple error value).
|
/linux-6.12.1/fs/nilfs2/ |
D | Kconfig | 16 synchronous write basis (unless there is no change). Users can
|
/linux-6.12.1/block/ |
D | Kconfig.iosched | 16 synchronous writes, it will self-tune queue depths to achieve that
|
/linux-6.12.1/mm/ |
D | page_io.c | 611 bool synchronous = sis->flags & SWP_SYNCHRONOUS_IO; in swap_read_folio() local 616 VM_BUG_ON_FOLIO(!folio_test_swapcache(folio) && !synchronous, folio); in swap_read_folio() 644 } else if (synchronous) { in swap_read_folio()
|
/linux-6.12.1/drivers/net/wan/ |
D | Kconfig | 37 Relay, synchronous Point-to-Point Protocol (PPP) and X.25. 189 8Mb/s (128K on V.24) using synchronous PPP, Cisco HDLC, raw HDLC, 236 tristate "Intel IXP4xx HSS (synchronous serial port) support"
|
/linux-6.12.1/Documentation/hwmon/ |
D | mpq8785.rst | 17 The MPQ8785 is a fully integrated, PMBus-compatible, high-frequency, synchronous
|