| /linux-6.12.1/drivers/spi/ |
| D | spidev.c | 106 spidev_sync(struct spidev_data *spidev, struct spi_message *message) in spidev_sync() argument
111 mutex_lock(&spidev->spi_lock); in spidev_sync()
112 spi = spidev->spi; in spidev_sync()
119 mutex_unlock(&spidev->spi_lock); in spidev_sync()
124 spidev_sync_write(struct spidev_data *spidev, size_t len) in spidev_sync_write() argument
127 .tx_buf = spidev->tx_buffer, in spidev_sync_write()
129 .speed_hz = spidev->speed_hz, in spidev_sync_write()
135 return spidev_sync(spidev, &m); in spidev_sync_write()
139 spidev_sync_read(struct spidev_data *spidev, size_t len) in spidev_sync_read() argument
142 .rx_buf = spidev->rx_buffer, in spidev_sync_read()
[all …]
|
| D | spi-lantiq-ssc.c | 388 static int lantiq_ssc_setup(struct spi_device *spidev) in lantiq_ssc_setup() argument
390 struct spi_controller *host = spidev->controller; in lantiq_ssc_setup()
392 unsigned int cs = spi_get_chipselect(spidev, 0); in lantiq_ssc_setup()
396 if (spi_get_csgpiod(spidev, 0)) in lantiq_ssc_setup()
411 if (spidev->mode & SPI_CS_HIGH) in lantiq_ssc_setup()
432 struct spi_device *spidev, struct spi_transfer *t) in hw_setup_transfer() argument
722 static int transfer_start(struct lantiq_ssc_spi *spi, struct spi_device *spidev, in transfer_start() argument
797 static void lantiq_ssc_set_cs(struct spi_device *spidev, bool enable) in lantiq_ssc_set_cs() argument
799 struct lantiq_ssc_spi *spi = spi_controller_get_devdata(spidev->controller); in lantiq_ssc_set_cs()
800 unsigned int cs = spi_get_chipselect(spidev, 0); in lantiq_ssc_set_cs()
[all …]
|
| D | spi-ch341.c | 39 struct spi_device *spidev; member
208 ch341->spidev = spi_new_device(ctrl, &chip); in ch341_probe()
209 if (!ch341->spidev) in ch341_probe()
219 spi_unregister_device(ch341->spidev); in ch341_disconnect()
|
| D | Makefile | 13 obj-$(CONFIG_SPI_SPIDEV) += spidev.o
|
| /linux-6.12.1/drivers/nfc/st95hf/ |
| D | spi.c | 19 struct spi_device *spidev = spicontext->spidev; in st95hf_spi_send() local
37 result = spi_sync(spidev, &m); in st95hf_spi_send()
39 dev_err(&spidev->dev, "error: sending cmd to st95hf using SPI = %d\n", in st95hf_spi_send()
55 dev_err(&spidev->dev, "error: response not ready timeout\n"); in st95hf_spi_send()
74 struct spi_device *spidev = spicontext->spidev; in st95hf_spi_recv_response() local
92 ret = spi_sync(spidev, &m); in st95hf_spi_recv_response()
94 dev_err(&spidev->dev, "spi_recv_resp, data length error = %d\n", in st95hf_spi_recv_response()
116 ret = spi_sync(spidev, &m); in st95hf_spi_recv_response()
120 dev_err(&spidev->dev, "spi_recv_resp, data read error = %d\n", in st95hf_spi_recv_response()
138 struct spi_device *spidev = spicontext->spidev; in st95hf_spi_recv_echo_res() local
[all …]
|
| D | core.c | 250 struct device *dev = &st95context->spicontext.spidev->dev; in st95hf_send_recv_cmd()
316 dev_err(&st95context->spicontext.spidev->dev, in st95hf_echo_command()
324 dev_err(&st95context->spicontext.spidev->dev, "err: echo res is 0x%x\n", in st95hf_echo_command()
482 dev_err(&st95context->spicontext.spidev->dev, in st95hf_send_spi_reset_sequence()
511 dev_dbg(&st95context->spicontext.spidev->dev, in st95hf_por_sequence()
534 struct device *dev = &st95context->spicontext.spidev->dev; in iso14443_config_fdt()
777 spidevice = &stcontext->spicontext.spidev->dev; in st95hf_irq_thread_handler()
1081 spicontext->spidev = nfc_spi_dev; in st95hf_probe()
1217 dev_err(&spictx->spidev->dev, "sleep for semaphore interrupted by signal\n"); in st95hf_remove()
1225 dev_err(&spictx->spidev->dev, in st95hf_remove()
|
| D | spi.h | 31 struct spi_device *spidev; member
|
| /linux-6.12.1/Documentation/spi/ |
| D | spidev.rst | 15 #include <linux/spi/spidev.h>
33 The spidev driver contains lists of SPI devices that are supported for
36 The following are the SPI device tables supported by the spidev driver:
52 post a patch for spidev to the linux-spi@vger.kernel.org mailing list.
54 It used to be supported to define an SPI device using the "spidev" name.
55 For example, as .modalias = "spidev" or compatible = "spidev". But this
60 the spidev driver failing to probe.
64 To make the spidev driver bind to such a device, use the following::
66 echo spidev > /sys/bus/spi/devices/spiB.C/driver_override
67 echo spiB.C > /sys/bus/spi/drivers/spidev/bind
[all …]
|
| D | index.rst | 11 spidev
|
| /linux-6.12.1/drivers/net/ethernet/micrel/ |
| D | ks8851_spi.c | 51 struct spi_device *spidev; member
132 ret = spi_sync(kss->spidev, msg); in ks8851_wrreg16_spi()
159 if (kss->spidev->controller->flags & SPI_CONTROLLER_HALF_DUPLEX) { in ks8851_rdreg()
180 ret = spi_sync(kss->spidev, msg); in ks8851_rdreg()
183 else if (kss->spidev->controller->flags & SPI_CONTROLLER_HALF_DUPLEX) in ks8851_rdreg()
236 ret = spi_sync(kss->spidev, msg); in ks8851_rdfifo_spi()
284 ret = spi_sync(kss->spidev, msg); in ks8851_wrfifo_spi()
438 kss->spidev = spi; in ks8851_probe_spi()
|
| /linux-6.12.1/drivers/net/ethernet/adi/ |
| D | adin1110.c | 154 struct spi_device *spidev; member
220 ret = spi_sync_transfer(priv->spidev, &t, 1); in adin1110_read_reg()
233 dev_err_ratelimited(&priv->spidev->dev, "CRC error."); in adin1110_read_reg()
263 return spi_write(priv->spidev, &priv->data[0], header_len + write_len); in adin1110_write_reg()
348 ret = spi_sync_transfer(priv->spidev, &t, 1); in adin1110_read_fifo()
416 ret = spi_write(priv->spidev, &priv->data[0], round_len + header_len); in adin1110_write_fifo()
520 priv->cfg->name, spi_get_chipselect(priv->spidev, 0)); in adin1110_register_mdiobus()
597 dev_warn_ratelimited(&priv->spidev->dev, in adin1110_irq()
979 dev_err_ratelimited(&priv->spidev->dev, in adin1110_tx_work()
1090 reset_gpio = devm_gpiod_get_optional(&priv->spidev->dev, "reset", in adin1110_check_spi()
[all …]
|
| /linux-6.12.1/drivers/net/ethernet/vertexcom/ |
| D | mse102x.c | 83 struct spi_device *spidev; member
104 mses->spidev->irq); in mse102x_info_show()
109 mses->spidev->mode); in mse102x_info_show()
163 ret = spi_sync(mses->spidev, msg); in mse102x_tx_cmd_spi()
188 ret = spi_sync(mses->spidev, msg); in mse102x_rx_cmd_spi()
252 ret = spi_sync(mses->spidev, msg); in mse102x_tx_frame_spi()
278 ret = spi_sync(mses->spidev, msg); in mse102x_rx_frame_spi()
697 mses->spidev = spi; in mse102x_probe_spi()
|
| /linux-6.12.1/drivers/net/ethernet/davicom/ |
| D | dm9051.c | 100 struct spi_device *spidev; member
243 struct spi_device *spi = db->spidev; in dm9051_irq_flag()
507 db->regmap_dm = devm_regmap_init_spi(db->spidev, ®configdm); in dm9051_map_init()
512 db->regmap_dmbulk = devm_regmap_init_spi(db->spidev, ®configdmbulk); in dm9051_map_init()
518 struct device *dev = &db->spidev->dev; in dm9051_map_chipid()
555 dev_dbg(&db->spidev->dev, "Use random MAC address\n"); in dm9051_map_etherdev_par()
946 struct spi_device *spi = db->spidev; in dm9051_open()
1005 free_irq(db->spidev->irq, db); in dm9051_stop()
1109 struct spi_device *spi = db->spidev; in dm9051_mdio_register()
1181 db->spidev = spi; in dm9051_probe()
|
| /linux-6.12.1/arch/arm64/boot/dts/freescale/ |
| D | imx8mm-mx8menlo.dts | 77 spidev@0 {
83 spidev@1 {
|
| /linux-6.12.1/drivers/staging/greybus/ |
| D | spilib.c | 447 struct spi_device *spidev; in gb_spi_setup_device() local
478 spidev = spi_new_device(ctlr, &spi_board); in gb_spi_setup_device()
479 if (!spidev) in gb_spi_setup_device()
|
| /linux-6.12.1/tools/spi/ |
| D | Makefile | 30 ln -sf $(CURDIR)/../../include/uapi/linux/spi/spidev.h $@
|
| /linux-6.12.1/arch/arm/boot/dts/microchip/ |
| D | at91-gatwick.dts | 107 spidev@0 {
|
| /linux-6.12.1/arch/loongarch/boot/dts/ |
| D | loongson-2k1000-ref.dts | 93 spidev@0 {
|
| /linux-6.12.1/arch/arm/boot/dts/nxp/imx/ |
| D | imx53-m53menlo.dts | 136 spidev@0 {
142 spidev@1 {
|
| D | imx6ull-dhcor-maveo-box.dts | 64 spidev@0 {
|
| /linux-6.12.1/drivers/net/dsa/sja1105/ |
| D | sja1105_spi.c | 39 struct spi_device *spi = priv->spidev; in sja1105_xfer()
291 dev_err(&priv->spidev->dev, in static_config_buf_prepare_for_upload()
319 struct device *dev = &priv->spidev->dev; in sja1105_static_config_upload()
|
| D | sja1105.h | 260 struct spi_device *spidev; member
|
| D | sja1105_main.c | 251 struct device *dev = &priv->spidev->dev; in sja1105_init_mii_settings()
1136 struct device *dev = &priv->spidev->dev; in sja1105_parse_rgmii_delays()
1190 struct device *dev = &priv->spidev->dev; in sja1105_parse_ports_node()
1241 struct device *dev = &priv->spidev->dev; in sja1105_parse_dt()
3261 struct device *dev = &priv->spidev->dev; in sja1105_check_device_id()
3328 priv->spidev = spi; in sja1105_probe()
|
| /linux-6.12.1/arch/arm/boot/dts/intel/socfpga/ |
| D | socfpga_cyclone5_socdk.dts | 155 spidev@0 {
|
| /linux-6.12.1/Documentation/admin-guide/gpio/ |
| D | gpio-aggregator.rst | 77 This is useful in industrial control, and is not unlike e.g. spidev, which
|