Searched refs:saves (Results 1 – 25 of 89) sorted by relevance
1234
171 struct index_save_layout *saves; member414 sil->saves[i].index_save = (struct layout_region) { in setup_sub_index()645 result = invalidate_old_save(layout, &layout->index.saves[i]); in discard_index_state_data()683 *lr++ = layout->index.saves[i].index_save; in make_layout_region_table()809 &layout->index.saves); in create_index_layout()867 isl = &layout->index.saves[i]; in find_latest_uds_index_save_slot()969 isl = &layout->index.saves[i]; in select_oldest_index_save_layout()1315 sil->saves[i].index_save = table->regions[i + 4]; in verify_sub_index()1316 result = verify_region(&sil->saves[i].index_save, next_block, in verify_sub_index()1321 next_block += sil->saves[i].index_save.block_count; in verify_sub_index()[all …]
9 Say y to enable the PPU power domain driver. This saves power
71 is not possible. This connection mode saves one wire and works with any SPI91 the previous wiring configuration but saves the use of a CS line.
32 with this calibration data. This saves the user from performing the
27 Say Y here to enable SPI transfer compression. It saves up
38 in advance saves time during the actual I/O.
25 The struct :c:type:`ipu3_uapi_4a_config` saves all configurable parameters.
29 in basic operation mode only saves and restores SROM registers
71 This timer saves power compared to the OMAP_MPU_TIMER, and has103 This option saves power, but assumes all drivers are
9 It has no MBR, so saves storage space. Bootloader can be easily accessed
38 use wireless feature, disabling this option saves memory. As
27 it saves extra target transaction;
39 data saved on each oops/panic. Pstore saves (possibly
43 This saves some memory since no intermediate buffering is
76 rightmost/bottommost block is the remainder. The dewarping map only saves
9 hardware saves some memory plus the register sets of the boot CPU before the
185 ; don't call ret_from_system_call as it saves r0, already done above
22 * This will be described as: UEFI saves the physical address of
128 @ point to writeable memory because the processor saves
106 GFXOFF is a feature found in most recent GPUs that saves power at runtime. The
104 saves a single dump. If an dump is not already stored by devlink
84 filesystem identifier that saves 8 bytes.
42 On kernel start, the kernel's EFI driver saves the location of the secret area
56 instead of going through the block device layer. This saves some memory
103 (GR) saves and restores in interruption handlers.