| /linux-6.12.1/drivers/net/wireless/intel/ipw2x00/ |
| D | Kconfig | 42 bool "Enable promiscuous mode"
45 Enables promiscuous/monitor mode support for the ipw2100 driver.
47 promiscuous mode via the Wireless Tool's Monitor mode. While in this
104 bool "Enable promiscuous mode"
107 Enables promiscuous/monitor mode support for the ipw2200 driver.
109 promiscuous mode via the Wireless Tool's Monitor mode. While in this
117 bool "Enable creation of a RF radiotap promiscuous interface"
|
| /linux-6.12.1/Documentation/networking/device_drivers/ethernet/intel/ |
| D | ice.rst | 562 trusted VF to request selective promiscuous mode on the Physical Function (PF).
569 NOTE: It's important to set the VF to trusted before setting promiscuous mode.
570 If the VM is not trusted, the PF will ignore promiscuous mode requests from the
572 new request to set the VF to promiscuous.
575 set the VF to promiscuous mode.
577 For promiscuous all::
582 For promiscuous Multicast::
588 "off," meaning that promiscuous mode for the VF will be limited. To set the
589 promiscuous mode for the VF to true promiscuous and allow the VF to see all
594 The vf-true-promisc-support private flag does not enable promiscuous mode;
[all …]
|
| D | i40e.rst | 80 promiscuous mode on the Physical Function (PF).
88 set the VF to promiscuous mode.
92 For promiscuous all:
96 For promiscuous Multicast:
101 "off",meaning that promiscuous mode for the VF will be limited. To set the
102 promiscuous mode for the VF to true promiscuous and allow the VF to see all
107 The vf-true-promisc-support priv-flag does not enable promiscuous mode; rather,
108 it designates which type of promiscuous mode (limited or true) you will get
109 when you enable promiscuous mode using the ip link commands above. Note that
112 device. The PF remains in limited promiscuous mode (unless it is in MFP mode)
[all …]
|
| /linux-6.12.1/drivers/net/ethernet/micrel/ |
| D | ksz884x.c | 1224 u8 promiscuous; member
1407 int promiscuous; member
3414 if (hw->promiscuous) in hw_setup()
5004 if (priv->promiscuous) in netdev_close()
5005 --hw->promiscuous; in netdev_close()
5074 hw->promiscuous = 0; in prepare_hardware()
5122 priv->promiscuous = 0; in netdev_open()
5298 struct ksz_hw *hw, int promiscuous) in dev_set_promiscuous() argument
5300 if (promiscuous != priv->promiscuous) { in dev_set_promiscuous()
5301 u8 prev_state = hw->promiscuous; in dev_set_promiscuous()
[all …]
|
| /linux-6.12.1/drivers/net/ieee802154/ |
| D | cc2520.c | 212 bool promiscuous; /* Flag for promiscuous mode */ member
484 if (priv->promiscuous) { in cc2520_tx()
567 if (!priv->promiscuous) { in cc2520_rx()
797 priv->promiscuous = on; in cc2520_set_promiscuous_mode()
|
| D | ca8210.c | 332 bool promiscuous; member
638 priv->promiscuous = false; in ca8210_reset_send()
1785 if (priv->promiscuous) in ca8210_skb_rx()
2342 priv->promiscuous = on; in ca8210_set_promiscuous_mode()
3067 priv->promiscuous = false; in ca8210_probe()
|
| D | adf7242.c | 281 bool promiscuous; member
798 lp->promiscuous = on; in adf7242_set_promiscuous_mode()
1052 adf7242_set_promiscuous_mode(lp->hw, lp->promiscuous); in adf7242_soft_reset()
|
| /linux-6.12.1/Documentation/networking/device_drivers/ethernet/ti/ |
| D | cpsw_switchdev.rst | 30 - optimized promiscuous mode: The P0_UNI_FLOOD (both ports) is enabled in
32 So, Ports in promiscuous mode will keep possibility of mcast and vlan
|
| /linux-6.12.1/Documentation/networking/device_drivers/fddi/ |
| D | defza.rst | 38 requested explicitly or if the CAM overflows. The promiscuous mode
|
| /linux-6.12.1/net/batman-adv/ |
| D | Kconfig | 64 configured to have promiscuous mode enabled in order to make
|
| /linux-6.12.1/drivers/net/wireless/st/cw1200/ |
| D | wsm.h | 1353 bool promiscuous; member
1363 if (arg->promiscuous) in wsm_set_rx_filter()
|
| D | debug.c | 129 if (priv->rx_filter.promiscuous) in cw1200_status_show()
|
| /linux-6.12.1/drivers/net/arcnet/ |
| D | Kconfig | 110 things as promiscuous mode, so packet sniffing is possible, and
|
| /linux-6.12.1/drivers/net/ethernet/cortina/ |
| D | gemini.h | 709 unsigned int promiscuous:1; member
|
| /linux-6.12.1/Documentation/networking/ |
| D | ipvlan.rst | 131 puts the NIC in promiscuous mode and degraded performance is a concern.
|
| D | bonding.rst | 1976 underlying device -- i.e. the bonding interface -- to promiscuous
2211 common to enable promiscuous mode on the device, so that all traffic
2213 The bonding driver handles promiscuous mode changes to the bonding
2218 the promiscuous mode setting is propagated to all slaves.
2221 promiscuous mode setting is propagated only to the active slave.
2232 promiscuous setting will be propagated to the new active slave.
|
| D | switchdev.rst | 443 promiscuous mode should allow the reception of all VLAN tags (including those
|
| /linux-6.12.1/drivers/net/ethernet/intel/ |
| D | e100.c | 564 promiscuous = (1 << 1), enumerator
1110 if (nic->flags & promiscuous || nic->loopback) { in e100_configure()
1585 nic->flags |= promiscuous; in e100_set_multicast_list()
1587 nic->flags &= ~promiscuous; in e100_set_multicast_list()
|
| /linux-6.12.1/drivers/net/ethernet/ibm/ |
| D | ibmvnic.h | 188 __be32 promiscuous; member
|
| /linux-6.12.1/Documentation/admin-guide/media/ |
| D | faq.rst | 180 into promiscuous mode so it accepts any packets from the PID
|
| /linux-6.12.1/drivers/net/ethernet/marvell/ |
| D | mv643xx_eth.c | 1871 goto promiscuous; in mv643xx_eth_program_multicast_filter()
1876 goto promiscuous; in mv643xx_eth_program_multicast_filter()
1905 promiscuous: in mv643xx_eth_program_multicast_filter()
|
| /linux-6.12.1/drivers/scsi/be2iscsi/ |
| D | be_cmds.h | 686 u8 promiscuous; member
|
| /linux-6.12.1/drivers/net/ethernet/freescale/ |
| D | ucc_geth.c | 1238 int promiscuous, u32 __iomem *upsmr_register) in init_rx_parameters() argument
1254 if (promiscuous) in init_rx_parameters()
|
| /linux-6.12.1/Documentation/networking/devlink/ |
| D | devlink-trap.rst | 487 the interface is not in promiscuous mode
|
| /linux-6.12.1/scripts/ |
| D | spelling.txt | 1240 promiscous||promiscuous
|