| /linux-6.12.1/Documentation/devicetree/bindings/mtd/partitions/ |
| D | brcm,trx.txt | 9 identification fields, CRC32 checksum and the locations of embedded partitions.
10 Its purpose is to store a few partitions in a format that can be distributed as
13 Container can hold up to 4 partitions. The first partition has to contain a
15 executing. Other partitions can be used for operating system purposes. This is
19 partitions have to be less than the 4GiB max size limit.
22 1) v1 which contains 3 partitions
23 2) v2 which contains 4 partitions
39 partitions {
|
| D | brcm,bcm963xx-cfe-nor-partitions.txt | 6 NVRAM partition, and the remainder in-between for one to two firmware partitions
12 - compatible : must be "brcm,bcm963xx-cfe-nor-partitions"
21 partitions {
22 compatible = "brcm,bcm963xx-cfe-nor-partitions";
|
| D | brcm,bcm963xx-imagetag.txt | 5 partitions or non standard bootloader partition sizes. For these a mixed layout
21 partitions {
22 compatible = "fixed-partitions";
|
| /linux-6.12.1/drivers/mtd/parsers/ |
| D | Kconfig | 6 This provides partitions parser for devices based on BCM47xx
60 Same flash, but 2 named partitions, the first one being read-only:
80 This provides partitions parser for BCM4908 family devices
81 that can have multiple "firmware" partitions. It takes care of
89 This provides partitions parser for Linksys devices based on Broadcom
91 two "firmware" partitions. Currently used firmware has to be detected
95 tristate "Parser for BCM963XX Image Tag format partitions"
101 and rootfs partitions.
103 header and creates up to two partitions, kernel and rootfs.
114 register MTD 'partitions' corresponding to each image detected,
[all …]
|
| /linux-6.12.1/Documentation/admin-guide/ |
| D | ldm.rst | 12 replacement for the MSDOS style partitions. It stores its information in a
14 partitions is limited only by disk space. The maximum number of partitions is
17 Any partitions created under the LDM are called "Dynamic Disks". There are no
18 longer any primary or extended partitions. Normal MSDOS style partitions are
23 partitions and filesystems without the need to reboot.
39 Below we have a 50MiB disk, divided into seven partitions.
66 The LDM Database may not store the partitions in the order that they appear on
103 discovered partitions. However, grub does not understand the LDM partitioning
|
| /linux-6.12.1/Documentation/driver-api/mmc/ |
| D | mmc-dev-parts.rst | 5 Device partitions are additional logical block devices present on the
8 As of this writing, MMC boot partitions as supported and exposed as
15 Read and write access is provided to the two MMC boot partitions. Due to
30 The boot partitions can also be locked read only until the next power on,
39 The boot partitions can also be locked permanently, but this feature is
|
| /linux-6.12.1/arch/arm/boot/dts/renesas/ |
| D | r7s72100-genmai.dts | 44 partitions {
45 compatible = "fixed-partitions";
120 partitions {
121 compatible = "fixed-partitions";
147 partitions {
148 compatible = "fixed-partitions";
|
| /linux-6.12.1/drivers/media/pci/mgb4/ |
| D | mgb4_core.c | 219 mgbdev->partitions[0].name = mgbdev->fw_part_name; in init_spi()
221 mgbdev->partitions[0].size = 0x950000; in init_spi()
222 mgbdev->partitions[0].offset = 0x1000000; in init_spi()
224 mgbdev->partitions[0].size = 0x400000; in init_spi()
225 mgbdev->partitions[0].offset = 0x400000; in init_spi()
227 mgbdev->partitions[0].mask_flags = 0; in init_spi()
231 mgbdev->partitions[1].name = mgbdev->data_part_name; in init_spi()
232 mgbdev->partitions[1].size = 0x10000; in init_spi()
233 mgbdev->partitions[1].offset = 0xFF0000; in init_spi()
234 mgbdev->partitions[1].mask_flags = MTD_CAP_NORFLASH; in init_spi()
[all …]
|
| /linux-6.12.1/arch/arm/boot/dts/marvell/ |
| D | armada-390-db.dts | 92 partitions {
93 compatible = "fixed-partitions";
123 partitions {
124 compatible = "fixed-partitions";
|
| D | armada-385-db-88f6820-amc.dts | 103 partitions {
104 compatible = "fixed-partitions";
137 partitions {
138 compatible = "fixed-partitions";
|
| /linux-6.12.1/drivers/mtd/maps/ |
| D | impa7.c | 47 static const struct mtd_partition partitions[] = variable
88 mtd_device_register(impa7_mtd[i], partitions, in init_impa7()
89 ARRAY_SIZE(partitions)); in init_impa7()
|
| /linux-6.12.1/arch/arm64/boot/dts/marvell/ |
| D | armada-7040-db.dts | 91 partitions {
92 compatible = "fixed-partitions";
162 partitions {
163 compatible = "fixed-partitions";
194 partitions {
195 compatible = "fixed-partitions";
|
| D | armada-8040-db.dts | 80 partitions {
81 compatible = "fixed-partitions";
246 partitions {
247 compatible = "fixed-partitions";
282 partitions {
283 compatible = "fixed-partitions";
|
| /linux-6.12.1/arch/arm/boot/dts/ti/omap/ |
| D | am335x-moxa-uc-2100-common.dtsi | 191 partitions {
192 compatible = "fixed-partitions";
197 partitions@0 {
202 partitions@1 {
207 partitions@2 {
|
| /linux-6.12.1/arch/arm/boot/dts/qcom/ |
| D | qcom-ipq4018-jalapeno.dts | 78 partitions {
79 compatible = "fixed-partitions";
139 partitions {
140 compatible = "fixed-partitions";
|
| /linux-6.12.1/fs/ufs/ |
| D | Kconfig | 9 Unixes can create and mount hard disk partitions and diskettes using
11 these partitions; if you also want to write to them, say Y to the
36 Say Y here if you want to try writing to UFS partitions. This is
37 experimental, so you should back up your UFS partitions beforehand.
|
| /linux-6.12.1/Documentation/devicetree/bindings/mtd/ |
| D | samsung-s3c2410.txt | 20 Each child device node may optionally contain a 'partitions' sub-node,
40 partitions {
41 compatible = "fixed-partitions";
|
| /linux-6.12.1/arch/arm/boot/dts/broadcom/ |
| D | bcm5301x-nand-cs0.dtsi | 16 partitions {
17 compatible = "brcm,bcm947xx-cfe-partitions";
|
| D | bcm53016-meraki-mr32.dts | 128 partitions {
132 * [ 1.721667] 1 bcm47xxpart partitions found on MTD device brcmnand.0
133 * [ 1.727962] Creating 1 MTD partitions on "brcmnand.0":
137 compatible = "fixed-partitions";
|
| D | bcm47081-tplink-archer-c5-v2.dts | 97 partitions {
98 compatible = "tplink,safeloader-partitions";
99 partitions-table-offset = <0xe50000>;
|
| /linux-6.12.1/fs/nls/ |
| D | Kconfig | 47 DOS/Windows partitions correctly. This does apply to the filenames
59 DOS/Windows partitions correctly. This does apply to the filenames
71 DOS/Windows partitions correctly. This does apply to the filenames
84 DOS/Windows partitions correctly. This does apply to the filenames
100 DOS/Windows partitions correctly. This does apply to the filenames
115 DOS/Windows partitions correctly. This does apply to the filenames
126 DOS/Windows partitions correctly. This does apply to the filenames
137 DOS/Windows partitions correctly. This does apply to the filenames
148 DOS/Windows partitions correctly. This does apply to the filenames
159 DOS/Windows partitions correctly. This does apply to the filenames
[all …]
|
| /linux-6.12.1/arch/mips/boot/dts/brcm/ |
| D | bcm97xxx-nand-cs1-bch4.dtsi | 12 partitions {
13 compatible = "fixed-partitions";
|
| D | bcm97xxx-nand-cs1-bch24.dtsi | 12 partitions {
13 compatible = "fixed-partitions";
|
| /linux-6.12.1/arch/arm/boot/dts/aspeed/ |
| D | openbmc-flash-layout.dtsi | 3 partitions {
4 compatible = "fixed-partitions";
|
| D | openbmc-flash-layout-128.dtsi | 3 partitions {
4 compatible = "fixed-partitions";
|