Searched refs:ground (Results 1 – 25 of 31) sorted by relevance
12
| /linux-6.12.1/Documentation/hwmon/ |
| D | ntc_thermistor.rst | 56 -+- (ground)
68 -+- (ground)
80 -+----+- (ground)
92 -+- (ground)
|
| D | smsc47m192.rst | 108 to ground or Vcc. '1' indicates a diode fault.
|
| D | adm1026.rst | 96 voltage from the power lead rather than on the ground lead.
|
| /linux-6.12.1/drivers/extcon/ |
| D | extcon-intel-mrfld.c | 98 bool ground; in mrfld_extcon_get_id() local
122 ground = id & BCOVE_USBIDSTS_GND; in mrfld_extcon_get_id()
125 return ground ? INTEL_USB_ID_GND : INTEL_USB_ID_FLOAT; in mrfld_extcon_get_id()
127 return ground ? INTEL_USB_ID_FLOAT : INTEL_USB_ID_GND; in mrfld_extcon_get_id()
|
| /linux-6.12.1/drivers/iio/position/ |
| D | Kconfig | 28 and keyboard angle respect to horizon (ground).
|
| /linux-6.12.1/Documentation/devicetree/bindings/iio/ |
| D | mount-matrix.txt | 96 ground plane and positive towards magnetic North, (x) is in the ground plane,
98 perpendicular to the ground plane and positive upwards.
|
| /linux-6.12.1/arch/arm/boot/dts/rockchip/ |
| D | rk3288-veyron-sdmmc.dtsi | 40 * Builtin CD line is hooked to ground to prevent JTAG at boot
|
| /linux-6.12.1/drivers/auxdisplay/ |
| D | Kconfig | 234 0 : no connection (eg: connected to ground)
249 0 : no connection (eg: connected to ground)
264 0 : no connection (eg: connected to ground)
279 0 : no connection (eg: connected to ground)
294 0 : no connection (eg: connected to ground)
309 0 : no connection (eg: connected to ground)
|
| /linux-6.12.1/Documentation/w1/ |
| D | w1-generic.rst | 6 signal wire (plus ground, so two wires).
8 Devices communicate on the bus by pulling the signal to ground via an open
|
| /linux-6.12.1/arch/arm64/boot/dts/qcom/ |
| D | sc7180-trogdor-lazor.dtsi | 11 semtech,cs0-ground;
|
| /linux-6.12.1/arch/arm/boot/dts/marvell/ |
| D | kirkwood-openblocks_a7.dts | 84 * ground.
|
| /linux-6.12.1/Documentation/iio/ |
| D | ad7944.rst | 126 | ``in_voltage0_raw`` | Raw ADC voltage value (*IN+* referenced to ground sense).…
|
| /linux-6.12.1/Documentation/admin-guide/media/ |
| D | cec.rst | 336 The ground pin of the HDMI connector needs to be connected to a ground
373 and two female-female breadboard wires: one for connecting the HDMI ground
374 pin to a ground pin on the Raspberry Pi, and the other to connect the HDMI
|
| /linux-6.12.1/Documentation/misc-devices/ |
| D | lis3lv02d.rst | 95 fall to the ground is out of question...
|
| /linux-6.12.1/Documentation/ABI/testing/ |
| D | sysfs-bus-iio | 748 1kohm_to_gnd: connected to ground via an 1kOhm resistor,
749 2.5kohm_to_gnd: connected to ground via a 2.5kOhm resistor,
750 6kohm_to_gnd: connected to ground via a 6kOhm resistor,
751 20kohm_to_gnd: connected to ground via a 20kOhm resistor,
752 42kohm_to_gnd: connected to ground via a 42kOhm resistor,
753 90kohm_to_gnd: connected to ground via a 90kOhm resistor,
754 100kohm_to_gnd: connected to ground via an 100kOhm resistor,
755 125kohm_to_gnd: connected to ground via an 125kOhm resistor,
756 500kohm_to_gnd: connected to ground via a 500kOhm resistor,
757 640kohm_to_gnd: connected to ground via a 640kOhm resistor,
[all …]
|
| /linux-6.12.1/Documentation/sound/designs/ |
| D | channel-mapping-api.rst | 41 As a ground design, each PCM substream may contain a control element
|
| /linux-6.12.1/arch/arm64/boot/dts/rockchip/ |
| D | rk3399-gru.dtsi | 541 * hooked to ground. Because we specified "cd-gpios" below dw_mmc
796 * In our case the official card detect is hooked to ground
|
| D | rk3326-gameforce-chi.dts | 769 * pin 8 - ground. There is currently a userspace UART driver for this
|
| /linux-6.12.1/Documentation/input/devices/ |
| D | joystick-parport.rst | 87 Ground is quite easy. On PC's parallel port the ground is on any of the
88 pins from pin 18 to pin 25. So use any pin of these you like for the ground::
|
| /linux-6.12.1/arch/arm/boot/dts/microchip/ |
| D | at91-sama5d2_xplained.dts | 459 * connect it to ground to get an edge e.g.
|
| D | at91-sama5d2_icp.dts | 387 * connect it to ground to get an edge e.g.
|
| /linux-6.12.1/Documentation/arch/x86/ |
| D | cpuinfo.rst | 75 already stated, /proc/cpuinfo is not a dumping ground for useless
|
| /linux-6.12.1/Documentation/driver-api/ |
| D | edac.rst | 13 creating a common ground for discussion, terms and their definitions
|
| /linux-6.12.1/arch/arm/boot/dts/samsung/ |
| D | exynos5422-odroid-core.dtsi | 510 samsung,s2mps11-acokb-ground;
|
| /linux-6.12.1/arch/arm64/boot/dts/exynos/ |
| D | exynos5433-tm2-common.dtsi | 398 samsung,s2mps11-wrstbi-ground;
|
12