Searched refs:fired (Results 1 – 13 of 13) sorted by relevance
4 // This is a test to confirm that EPOLLERR is only fired once for an FD when8 // is correctly fired only once, when EPOLLONESHOT is set. send another packet9 // with MSG_ZEROCOPY. confirm that EPOLLERR is not fired. Rearm the FD and49 // rearm the FD and verify the EPOLLERR is fired again.
8 // is correctly fired only once, when EPOLLET is set. send another packet with9 // MSG_ZEROCOPY. confirm that EPOLLERR is correctly fired again only once.
9 // is correctly fired only once, when EPOLLET is set. send another packet with10 // MSG_ZEROCOPY. confirm that EPOLLERR is correctly fired again only once.
54 the fast_io_fail_tmo timer has not yet fired; "fail-fast"55 after the fast_io_fail_tmo timer has fired and before the56 "dev_loss_tmo" timer has fired; "lost" after the57 "dev_loss_tmo" timer has fired and before the port is finally
43 Description: The number of times the interrupt has fired since boot. This
51 The temperature above which trip point will be fired.
34 they are just fired using some simple included assembly trampoline code.
153 int fired; member
512 if (!event->fired) { in remote_event_wait()515 ret = wait_event_interruptible(*wq, event->fired); in remote_event_wait()525 event->fired = 0; in remote_event_wait()536 event->fired = 1; in remote_event_signal_local()545 if (event->fired && event->armed) in remote_event_poll()
630 event->fired = 1; in remote_event_signal()
284 inside the GPIO controller to figure out which line fired it. The irqchip294 to inquire the GPIO hardware to figure out which line has fired, but it
696 * eh_timed_out - The timer for the command has just fired
317 fired.