Searched refs:creates (Results 1 – 25 of 315) sorted by relevance
12345678910>>...13
5 The zram module creates RAM based block devices named /dev/zram<id>26 zram01.sh: creates general purpose ram disks with ext4 filesystems27 zram02.sh: creates block device for swap
35 the driver creates an out-fence to be able to notify, through37 Out-fences are fences that the driver creates.47 When a driver needs to send an out-fence userspace it creates a sync_file.
7 The pktcdvd module (packet writing driver) creates
29 creates a request for setting a new-powercap. The
17 Description: Writing a number 'N' to this file creates the number of50 Description: Writing a number 'N' to this file creates the number of112 Description: Writing a number 'N' to this file creates the number of126 Description: Writing a number 'N' to this file creates the number of148 Description: Writing a number 'N' to this file creates the number of234 Description: Writing a number 'N' to this file creates the number of314 Description: Writing a number 'N' to this file creates the number of
35 The line above creates three chips. The first one will expose 8 lines,50 Each mockup chip creates its own subdirectory in /sys/kernel/debug/gpio-mockup/.
59 HTE subsystem creates debugfs attributes at ``/sys/kernel/debug/hte/``.60 It also creates line/signal-related debugfs attributes at
7 The sample driver creates an mdev device that simulates a serial port over a PCI12 This step creates a dummy device, /sys/devices/virtual/mtty/mtty/
22 This driver creates a new I2C bus for any DS28E17 device detected. I2C buses65 The driver creates sysfs files /sys/bus/w1/devices/19-<id>/speed and
326 * The PMIC on V1.0A HW generates 1.6V instead of 1.8V which creates335 * The PMIC on V1.0A HW generates 1.6V instead of 1.8V which creates
10 * conditional of P0()'s if-statement creates a control dependency
32 The driver creates the following sysfs entries for systems management59 The driver creates the following sysfs entries for systems management software
28 The network device creates two net-device interfaces.
26 Device driver creates a "health reporter" per each error/health type.58 To handle devlink health diagnose and health dump requests, devlink creates a
15 NILFS2 creates a number of checkpoints every few seconds or per
6 is a fixed divider that creates a 1 kHz clock from the 32 kHz osc.
13 Creating a net_cls cgroups instance creates a net_cls.classid file.
17 its capabilities, and creates device files accordingly.
25 magic value. This driver does that and creates subpartitions for103 header and creates up to two partitions, kernel and rootfs.133 This driver reads partitions table, parses it and creates MTD
55 The "mkdir func1" above creates the pci-epf-ntb function device that will87 The PCI endpoint framework also automatically creates a sub-directory in the
59 The "mkdir func1" above creates the pci-epf-ntb function device that will91 The PCI endpoint framework also automatically creates a sub-directory in the
59 The driver creates two debugfs entries per device.
23 This misc driver creates /dev/pci-endpoint-test.<num> for every
69 basically creates the pipes that enable virtualization management117 is loaded. It first creates and initializes the CRQ. Next, an exchange of149 state, EIO will be returned for the ioctl(). The device driver creates a
17 The new jack code creates embedded jack kcontrols for each jack that