Searched refs:OTP (Results 1 – 25 of 29) sorted by relevance
12
/linux-6.12.1/drivers/nvmem/ |
D | Kconfig | 44 tristate "Broadcom On-Chip OTP Controller support" 49 Say y here to enable read/write access to the Broadcom OTP 76 tristate "i.MX 6/7/8 On-Chip OTP Controller support" 80 This is a driver for the On-Chip OTP Controller (OCOTP) available on 88 tristate "i.MX On-Chip OTP Controller support" 93 This is a driver for the On-Chip OTP Controller (OCOTP) 97 tristate "i.MX8 SCU On-Chip OTP Controller support" 101 This is a driver for the SCU On-Chip OTP Controller (OCOTP) 117 tristate "Microchip LAN9662 OTP controller support" 121 This driver enables the OTP controller available on Microchip LAN9662 [all …]
|
/linux-6.12.1/drivers/mtd/nand/onenand/ |
D | Kconfig | 45 bool "OneNAND OTP Support" 49 Also, 1st Block of NAND Flash Array can be used as OTP. 51 The OTP block can be read, programmed and locked using the same 53 OTP block cannot be erased. 55 OTP block is fully-guaranteed to be a valid block.
|
/linux-6.12.1/Documentation/devicetree/bindings/nvmem/ |
D | vf610-ocotp.txt | 1 On-Chip OTP Memory for Freescale Vybrid 8 reg : Address and length of OTP controller and fuse map registers
|
D | lpc1850-otp.txt | 1 * NXP LPC18xx OTP memory 3 Internal OTP (One Time Programmable) memory for NXP LPC18xx/43xx devices.
|
D | brcm,ocotp.txt | 1 Broadcom OTP memory controller 8 - reg: Base address of the OTP controller.
|
/linux-6.12.1/Documentation/devicetree/bindings/regulator/ |
D | palmas-pmic.txt | 3 The tps659038 for the AM57x class have OTP spins that 5 is not a need to add the OTP spins to the palmas driver. The 35 For ti,palmas-pmic - smps12, smps123, smps3 depending on OTP, 50 ti,smps-range - OTP has the wrong range set for the hardware so override
|
/linux-6.12.1/drivers/misc/mchp_pci1xxxx/ |
D | Kconfig | 2 tristate "Microchip PCI1XXXX PCIe to GPIO Expander + OTP/EEPROM manager" 11 which also has registers to interface with the OTP and EEPROM.
|
/linux-6.12.1/Documentation/devicetree/bindings/net/ |
D | microchip,lan78xx.txt | 3 The LAN78XX devices are usually configured by programming their OTP or with 5 The Device Tree properties, if present, override the OTP and EEPROM.
|
/linux-6.12.1/Documentation/hwmon/ |
D | sht15.rst | 48 The humidity calibration coefficients are programmed into an OTP memory on the 67 flag to indicate not to reload from OTP (default to false).
|
D | mpq8785.rst | 34 over-temperature protection (OTP).
|
/linux-6.12.1/Documentation/ABI/testing/ |
D | debugfs-turris-mox-rwtm | 9 device's OTP. The message must be exactly 64 bytes
|
D | sysfs-platform-silicom | 27 OTP status:
|
/linux-6.12.1/drivers/mtd/chips/ |
D | Kconfig | 156 bool "Protection Registers aka one-time programmable (OTP) bits" 166 programmable (OTP) bits; when programmed, register bits cannot be 173 because the Lock Register bits themselves are OTP, when programmed, 178 in the programming of OTP bits will waste them.
|
/linux-6.12.1/Documentation/devicetree/bindings/mfd/ |
D | palmas.txt | 31 hardware, if not set will use muxing in OTP.
|
/linux-6.12.1/Documentation/w1/slaves/ |
D | w1_ds2406.rst | 15 These chips also provide 128 bytes of OTP EPROM, but reading/writing it is
|
/linux-6.12.1/Documentation/devicetree/bindings/input/ |
D | ti,palmas-pwrbutton.txt | 18 NOTE: This depends on OTP support and POWERHOLD signal configuration
|
/linux-6.12.1/Documentation/ABI/stable/ |
D | sysfs-bus-nvmem | 48 "OTP", "Battery backed", "FRAM".
|
/linux-6.12.1/arch/arm/boot/dts/synaptics/ |
D | berlin2cd-valve-steamlink.dts | 42 * less depending on leakage value in OTP), and buck2 likely used for
|
/linux-6.12.1/arch/arm/boot/dts/nxp/imx/ |
D | imx6q-gk802.dts | 54 /* SDMC DM2016 1024 bit EEPROM + 128 bit OTP */
|
/linux-6.12.1/drivers/platform/cznic/ |
D | Kconfig | 47 able to program SOC's OTP on board revisions 32+,
|
/linux-6.12.1/drivers/mtd/devices/ |
D | Kconfig | 73 bool "DataFlash OTP support (Security Register)" 77 one-time-programmable (OTP) data. The first half may be written
|
/linux-6.12.1/arch/powerpc/boot/dts/ |
D | wii.dts | 227 * requires refactoring the PIC1, GPIO and OTP nodes
|
/linux-6.12.1/Documentation/security/keys/ |
D | trusted-encrypted.rst | 47 Rooted to a one-time programmable key (OTP) that is generally burnt 49 DCP provides two keys that can be used as root of trust: the OTP key 51 the OTP key can be done via a module parameter (dcp_use_otp_key).
|
/linux-6.12.1/include/linux/mfd/ |
D | idt8a340_reg.h | 458 #define OTP 0xcf70 macro
|
/linux-6.12.1/drivers/pmdomain/amlogic/ |
D | meson-secure-pwrc.c | 125 SEC_PD(OTP, 0),
|
12