Searched refs:ALARM (Results 1 – 11 of 11) sorted by relevance
| /linux-6.12.1/drivers/rtc/ |
| D | rtc-88pm860x.c | 51 #define ALARM (1 << 5) macro
61 mask = ALARM | ALARM_WAKEUP; in rtc_update_handler()
150 alrm->pending = (ret & (ALARM | ALARM_WAKEUP)) ? 1 : 0; in pm860x_rtc_read_alarm()
178 mask = ALARM | ALARM_WAKEUP | ALARM_EN; in pm860x_rtc_set_alarm()
181 mask = ALARM | ALARM_WAKEUP | ALARM_EN; in pm860x_rtc_set_alarm()
183 ALARM | ALARM_WAKEUP); in pm860x_rtc_set_alarm()
|
| D | Kconfig | 324 Say Y to enable support for the LP8788 RTC/ALARM driver.
|
| /linux-6.12.1/drivers/hwmon/ |
| D | adt7475.c | 40 ALARM = 9, enumerator
345 case ALARM: in voltage_show()
439 case ALARM: in temp_show()
716 if (sattr->nr == ALARM) in tach_show()
1098 static SENSOR_DEVICE_ATTR_2_RO(in0_alarm, voltage, ALARM, 0);
1102 static SENSOR_DEVICE_ATTR_2_RO(in1_alarm, voltage, ALARM, 1);
1106 static SENSOR_DEVICE_ATTR_2_RO(in2_alarm, voltage, ALARM, 2);
1110 static SENSOR_DEVICE_ATTR_2_RO(in3_alarm, voltage, ALARM, 3);
1114 static SENSOR_DEVICE_ATTR_2_RO(in4_alarm, voltage, ALARM, 8);
1118 static SENSOR_DEVICE_ATTR_2_RO(in5_alarm, voltage, ALARM, 31);
[all …]
|
| /linux-6.12.1/Documentation/hwmon/ |
| D | adt7462.rst | 35 corresponding high/low limit values. The ADT7462 will signal an ALARM if
|
| D | adt7470.rst | 35 limit values. The ADT7470 will signal an ALARM if any measured value exceeds
|
| D | adt7475.rst | 70 corresponding high/low limit values. The ADT747x will signal an ALARM if
|
| D | max31827.rst | 127 behavior for both settings is dependent on the Fault Queue setting. The ALARM
|
| D | lm85.rst | 118 corresponding high/low limit values. The LM85 will signal an ALARM if any
|
| /linux-6.12.1/arch/arm/boot/dts/st/ |
| D | ste-ab8505.dtsi | 46 interrupt-names = "60S", "ALARM";
|
| D | ste-ab8500.dtsi | 49 interrupt-names = "60S", "ALARM";
|
| /linux-6.12.1/Documentation/admin-guide/laptops/ |
| D | thinkpad-acpi.rst | 562 0x2313 ALARM: System is waking up from suspend because
564 0x2413 ALARM: System is waking up from hibernation because
574 0x6011 ALARM: battery is too hot
575 0x6012 ALARM: battery is extremely hot
576 0x6021 ALARM: a sensor is too hot
577 0x6022 ALARM: a sensor is extremely hot
|