1 # SPDX-License-Identifier: GPL-2.0-only 2 # 3 # SCSI driver configuration for Acorn 4 # 5 config SCSI_ACORNSCSI_3 6 tristate "Acorn SCSI card (aka30) support" 7 depends on ARCH_ACORN && SCSI 8 select SCSI_SPI_ATTRS 9 help 10 This enables support for the Acorn SCSI card (aka30). If you have an 11 Acorn system with one of these, say Y. If unsure, say N. 12 13 config SCSI_ACORNSCSI_SYNC 14 bool "Support SCSI 2 Synchronous Transfers" 15 depends on SCSI_ACORNSCSI_3 16 help 17 Say Y here to enable synchronous transfer negotiation with all 18 targets on the Acorn SCSI card. 19 20 In general, this improves performance; however some SCSI devices 21 don't implement it properly, so the safe answer is N. 22 23 config SCSI_ARXESCSI 24 tristate "ARXE SCSI support" 25 depends on ARCH_ACORN && SCSI 26 help 27 Around 1991, Arxe Systems Limited released a high density floppy 28 disc interface for the Acorn Archimedes range, to allow the use of 29 HD discs from the then new A5000 on earlier models. This interface 30 was either sold on its own or with an integral SCSI controller. 31 Technical details on this NCR53c94-based device are available at 32 <http://www.cryton.demon.co.uk/acornbits/scsi_arxe.html> 33 Say Y here to compile in support for the SCSI controller. 34 35 config SCSI_CUMANA_2 36 tristate "CumanaSCSI II support" 37 depends on ARCH_ACORN && SCSI 38 help 39 This enables support for the Cumana SCSI II card. If you have an 40 Acorn system with one of these, say Y. If unsure, say N. 41 42 config SCSI_EESOXSCSI 43 tristate "EESOX support" 44 depends on ARCH_ACORN && SCSI 45 help 46 This enables support for the EESOX SCSI card. If you have an Acorn 47 system with one of these, say Y, otherwise say N. 48 49 config SCSI_POWERTECSCSI 50 tristate "PowerTec support" 51 depends on ARCH_ACORN && SCSI 52 help 53 This enables support for the Powertec SCSI card on Acorn systems. If 54 you have one of these, say Y. If unsure, say N. 55 56 comment "The following drivers are not fully supported" 57 depends on ARCH_ACORN 58 59 config SCSI_CUMANA_1 60 tristate "CumanaSCSI I support" 61 depends on ARCH_ACORN && SCSI 62 select SCSI_SPI_ATTRS 63 help 64 This enables support for the Cumana SCSI I card. If you have an 65 Acorn system with one of these, say Y. If unsure, say N. 66 67 config SCSI_OAK1 68 tristate "Oak SCSI support" 69 depends on ARCH_ACORN && SCSI 70 select SCSI_SPI_ATTRS 71 help 72 This enables support for the Oak SCSI card. If you have an Acorn 73 system with one of these, say Y. If unsure, say N. 74 75