Searched full:thru (Results 1 – 25 of 225) sorted by relevance
123456789
| /linux-6.12.1/tools/lib/perf/include/internal/ |
| D | evlist.h | 66 * __perf_evlist__for_each_entry - iterate thru all the evsels
74 * evlist__for_each_entry - iterate thru all the evsels
82 * __perf_evlist__for_each_entry_reverse - iterate thru all the evsels in reverse order
90 * perf_evlist__for_each_entry_reverse - iterate thru all the evsels in reverse order
98 * __perf_evlist__for_each_entry_safe - safely iterate thru all the evsels
107 * perf_evlist__for_each_entry_safe - safely iterate thru all the evsels
|
| /linux-6.12.1/Documentation/devicetree/bindings/clock/ |
| D | stericsson,u8500-clks.yaml | 54 wants, possible values are 0 thru 31.
68 values are 0 thru 31.
82 it wants to control, possible values are 0 thru 31.
124 possible values are 0 thru 7, see the defines for the different
126 The third cell is a divider, legal values are 1 thru 63.
|
| /linux-6.12.1/tools/perf/util/ |
| D | config.h | 54 * perf_config_sections__for_each - iterate thru all the sections
62 * perf_config_items__for_each - iterate thru all the items
70 * perf_config_set__for_each - iterate thru all the config section-item pairs
|
| D | evlist.h | 267 * __evlist__for_each_entry - iterate thru all the evsels
275 * evlist__for_each_entry - iterate thru all the evsels
283 * __evlist__for_each_entry_continue - continue iteration thru all the evsels
291 * evlist__for_each_entry_continue - continue iteration thru all the evsels
315 * __evlist__for_each_entry_reverse - iterate thru all the evsels in reverse order
323 * evlist__for_each_entry_reverse - iterate thru all the evsels in reverse order
331 * __evlist__for_each_entry_safe - safely iterate thru all the evsels
340 * evlist__for_each_entry_safe - safely iterate thru all the evsels
|
| /linux-6.12.1/drivers/of/unittest-data/ |
| D | tests-phandle.dtsi | 40 phandle-map-pass-thru = <0x0 0xf0>;
47 phandle-map-pass-thru = <0x0 0xf0>;
|
| /linux-6.12.1/drivers/bus/ |
| D | qcom-ebi2.c | 44 * followed by write on the same CS. Valid values 0 thru 15.
48 * active for 1 extra cycle etc. Valid values 0 thru 15.
54 * so 1 thru 16 cycles.
56 * so 1 thru 16 cycles.
|
| /linux-6.12.1/arch/mips/include/asm/sn/ |
| D | ioc3.h | 405 #define SIO_IR_SA_INT 0x00000040 /* port A pass-thru intr */
406 #define SIO_IR_SA_TX_EXPLICIT 0x00000080 /* port A explicit TX thru */
417 #define SIO_IR_PP_INT 0x00040000 /* P port pass-thru intr */
418 #define SIO_IR_PP_INTA 0x00080000 /* PP context A thru */
419 #define SIO_IR_PP_INTB 0x00100000 /* PP context B thru */
|
| /linux-6.12.1/Documentation/ABI/testing/ |
| D | sysfs-platform-dptf | 143 settings 0x01 thru 0x1C)
145 settings 0x1E thru 0x3F)
|
| /linux-6.12.1/drivers/gpu/drm/panel/ |
| D | panel-ilitek-ili9322.c | 207 * to drive the physical display. Valid ranges are 3600 thru 6000 in 100
211 * voltage on the communications link. Valid ranges are 37 thru 100
215 * display. Valid ranges are 70 thru 132 percent in increments if two
226 * gamma correction for voltages V1 thru V8. Valid range 0..15
228 * gamma correction for voltages V1 thru V8. Valid range 0..15
246 * The negative and postive gamma values adjust the V1 thru V8 up/down
|
| /linux-6.12.1/Documentation/devicetree/bindings/virtio/ |
| D | mmio.yaml | 33 description: Required for devices making accesses thru an IOMMU.
|
| /linux-6.12.1/drivers/scsi/snic/ |
| D | vnic_resource.h | 29 RES_TYPE_PASS_THRU_PAGE, /* Pass-thru page */
|
| /linux-6.12.1/drivers/scsi/fnic/ |
| D | vnic_resource.h | 31 RES_TYPE_PASS_THRU_PAGE, /* Pass-thru page */
|
| /linux-6.12.1/arch/mips/include/asm/ |
| D | floppy.h | 45 * On MIPSes using vdma, this actually means that *all* transfers go thru
|
| /linux-6.12.1/include/linux/usb/ |
| D | phy.h | 69 /* for phys connected thru an ULPI interface, the user must
165 /* helpers for direct access thru low-level io interface */
|
| /linux-6.12.1/arch/arc/mm/ |
| D | ioremap.c | 43 * ARC hardware uncached region, this one still goes thru the MMU as caller
|
| /linux-6.12.1/drivers/net/ethernet/cisco/enic/ |
| D | vnic_resource.h | 37 RES_TYPE_PASS_THRU_PAGE, /* Pass-thru page */
|
| /linux-6.12.1/drivers/crypto/ccp/ |
| D | ccp-debugfs.c | 145 oboff += OSCNPRINTF(" Pass-Thru: %ld\n", in ccp5_debugfs_stats_read()
219 oboff += OSCNPRINTF(" Pass-Thru: %ld\n", in ccp5_debugfs_queue_read()
|
| /linux-6.12.1/include/linux/ |
| D | adb.h | 46 /* Messages sent thru the client_list notifier. You should NOT stop
|
| /linux-6.12.1/drivers/dma/ptdma/ |
| D | ptdma-debugfs.c | 63 seq_printf(s, " Pass-Thru: %ld\n", cmd_q->total_pt_ops); in pt_debugfs_queue_show()
|
| /linux-6.12.1/Documentation/driver-api/gpio/ |
| D | using-gpio.rst | 42 These devices will appear on the system as ``/dev/gpiochip0`` thru
|
| /linux-6.12.1/Documentation/arch/xtensa/ |
| D | atomctl.rst | 45 Values WB - Write Back WT - Write Thru BY - Bypass
|
| /linux-6.12.1/include/scsi/ |
| D | scsi_proto.h | 175 #define ATA_16 0x85 /* 16-byte pass-thru */
176 #define ATA_12 0xa1 /* 12-byte pass-thru */
|
| /linux-6.12.1/drivers/clk/versatile/ |
| D | clk-icst.c | 78 * CM1136JF-S User Guide" ARM DUI 0138E, page 3-13 thru 3-14. in vco_get()
123 * in bits 8 thru 10 according to the document in vco_get()
125 * ARM DUI 0157A, page 3-20 thru 3-23 and 4-10. in vco_get()
|
| /linux-6.12.1/drivers/gpu/drm/ |
| D | drm_color_mgmt.c | 50 * linear/pass-thru gamma table should be used. This is generally the
68 * unit/pass-thru matrix should be used. This is generally the driver
81 * linear/pass-thru gamma table should be used. This is generally the
|
| /linux-6.12.1/include/linux/amba/ |
| D | pl08x.h | 39 * number, PL08x have 16 possible signals in number 0 thru 15 so
|
123456789