Searched full:sensing (Results 1 – 25 of 172) sorted by relevance
1234567
| /linux-6.12.1/drivers/misc/mei/ |
| D | Kconfig | 62 tristate "Intel visual sensing controller device transport driver"
66 Intel SPI transport driver between host and Intel visual sensing
73 tristate "Intel visual sensing controller device with ME interface"
76 Intel MEI over SPI driver for Intel visual sensing controller
78 between IVSC for context sensing and IPU for typical media usage.
|
| /linux-6.12.1/Documentation/hwmon/ |
| D | max16065.rst | 100 Only if the chip supports current sensing and if
101 current sensing is enabled.
121 sensing and if current sensing is enabled.
126 sensing and if current sensing is enabled.
|
| /linux-6.12.1/Documentation/devicetree/bindings/sound/ |
| D | rt5663.txt | 27 The matrix row number of the impedance sensing table.
28 If the value is 0, it means the impedance sensing is not supported.
30 The matrix rows of the impedance sensing table are consisted by impedance
41 impedance in the impedance sensing function.
|
| /linux-6.12.1/drivers/input/mouse/ |
| D | sentelic.h | 3 * Finger Sensing Pad PS/2 mouse driver.
12 /* Finger-sensing Pad information registers */
20 /* Finger-sensing Pad control registers */
63 /* Finger-sensing Pad packet formating related definitions */
|
| /linux-6.12.1/Documentation/devicetree/bindings/input/ |
| D | iqs269a.yaml | 17 additional Hall-effect and inductive sensing capabilities.
43 Enables Hall-effect sensing on channels 6 and 7. In this case, keycodes
46 posed on channels 6 and 7 by Hall-effect sensing.
55 1: Low power (all sensing at a reduced reporting rate)
56 2: Ultra-low power (channel 0 proximity sensing)
57 3: Halt (no sensing)
178 Specifies the inductive sensing excitation frequency as follows (paren-
284 Represents a single sensing channel. A channel is active if defined and
364 sensing as follows:
375 Specifies the channel's sensing mode as follows:
[all …]
|
| D | iqs626a.yaml | 14 additional Hall-effect and inductive sensing capabilities.
44 1: Low power (all sensing at a reduced reporting rate)
45 2: Ultra-low power (ULP channel proximity sensing)
46 3: Halt (no sensing)
173 Represents a single sensing channel. A channel is active if defined and
269 sensing as follows:
281 Specifies the channel's sensing frequency as follows (parenthesized
299 description: Enables projected-capacitance sensing (ULP channel only).
377 Specifies the channel's sensing mode as follows:
394 Specifies the inductive sensing excitation frequency as follows
[all …]
|
| D | azoteq,iqs7222.yaml | 14 capacitive touch controllers that feature additional sensing capabilities.
326 description: Represents a conversion cycle serving two sensing channels.
366 description: Enables the bias voltage for use during inductive sensing.
372 Specifies the cycle's sensing mode as follows:
379 Hall-effect sensing.
384 Enables the current reference for use during various sensing modes.
407 Represents a single sensing channel. A channel is active if defined and
411 Hall-effect sensing with events reported on channel 10 only.
494 capacitive sensing as follows:
|
| /linux-6.12.1/drivers/thermal/tegra/ |
| D | Kconfig | 15 tristate "Tegra BPMP thermal sensing"
18 Enable this option for support for sensing system temperature of NVIDIA
|
| /linux-6.12.1/drivers/media/pci/intel/ivsc/ |
| D | Kconfig | 5 tristate "Intel Visual Sensing Controller"
12 This adds support for Intel Visual Sensing Controller (IVSC).
|
| /linux-6.12.1/Documentation/ABI/testing/ |
| D | sysfs-bus-iio-light-isl29018 | 19 0 Sensing IR from LED and ambient
20 1 Sensing IR from LED with ambient IR rejection
|
| /linux-6.12.1/drivers/iio/chemical/ |
| D | Kconfig | 55 temperature, pressure, humidity and gas sensing capability.
127 dioxide, relative humidity and temperature sensing capabilities.
162 dioxide, relative humidity and temperature sensing capabilities.
|
| /linux-6.12.1/Documentation/devicetree/bindings/hwmon/ |
| D | ti,lm87.yaml | 15 with remote diode temperature sensing.
31 remote temperature sensing channel. By default the pins
|
| /linux-6.12.1/Documentation/devicetree/bindings/power/supply/ |
| D | richtek,rt9467.yaml | 16 MOSFETs, input current sensing and regulation, high-accuracy voltage
18 integrated sensing resistors.
|
| /linux-6.12.1/Documentation/devicetree/bindings/iio/adc/ |
| D | aspeed,ast2600-adc.yaml | 25 • Integrate dividing circuit for battery sensing.
60 aspeed,battery-sensing:
|
| /linux-6.12.1/drivers/usb/phy/ |
| D | phy-gpio-vbus-usb.c | 3 * gpio-vbus.c - simple GPIO VBUS sensing driver for B peripheral devices
24 * A simple GPIO VBUS sensing driver for B peripheral only devices
260 /* Look up the VBUS sensing GPIO */ in gpio_vbus_probe()
281 * The VBUS sensing GPIO should have a pulldown, which will normally be in gpio_vbus_probe()
|
| D | Kconfig | 76 tristate "GPIO based peripheral-only VBUS sensing 'transceiver'"
82 Provides simple GPIO VBUS sensing for controllers with an
|
| /linux-6.12.1/Documentation/devicetree/bindings/thermal/ |
| D | mediatek,lvts-thermal.yaml | 14 a Sensing device - Thermal Sensing Micro Circuit Unit (TSMCU),
|
| /linux-6.12.1/drivers/iio/adc/ |
| D | aspeed_adc.c | 58 * circuit for battery sensing.
229 * Enable compensating sensing: in aspeed_adc_compensation()
239 * After enable compensating sensing mode need to wait some time for ADC stable in aspeed_adc_compensation()
297 * After enable battery sensing mode need to wait some time for adc stable in aspeed_adc_read_raw()
558 if (of_property_present(data->dev->of_node, "aspeed,battery-sensing")) { in aspeed_adc_probe()
571 "Failed to enable battery-sensing mode\n"); in aspeed_adc_probe()
|
| /linux-6.12.1/drivers/iio/light/ |
| D | Kconfig | 253 If you say yes here you get support for ambient light sensing and
254 proximity infrared sensing from Intersil ISL29018.
256 in lux, proximity infrared sensing and normal infrared sensing.
266 Proximity value via iio. The ISL29028 provides the concurrent sensing
|
| D | isl29018.c | 6 * sensing and infrared sensing.
232 /* Do proximity sensing with required scheme */ in isl29018_read_proximity_ir()
307 * Proximity Sensing Scheme: Bit 7. This bit programs the function
318 * 0 Sensing IR from LED and ambient
319 * 1 Sensing IR from LED with ambient IR rejection
|
| /linux-6.12.1/Documentation/devicetree/bindings/media/ |
| D | nxp,imx8-isi.yaml | 7 title: i.MX8 Image Sensing Interface
13 The Image Sensing Interface (ISI) combines image processing pipelines with
|
| /linux-6.12.1/drivers/iio/accel/ |
| D | mxc6255.c | 3 * MXC6255 - MEMSIC orientation sensing accelerometer
193 MODULE_DESCRIPTION("MEMSIC MXC6255 orientation sensing accelerometer driver");
|
| D | Kconfig | 583 tristate "Freescale MMA9551L Intelligent Motion-Sensing Platform Driver"
589 Intelligent Motion-Sensing Platform Driver.
632 tristate "Memsic MXC6255 Orientation Sensing Accelerometer Driver"
637 Sensing Accelerometer Driver.
|
| /linux-6.12.1/sound/firewire/tascam/ |
| D | tascam.h | 140 // sensing: 0x0b
143 // fader and knob, bitmasks for button and sensing.
|
| /linux-6.12.1/Documentation/arch/s390/ |
| D | common_io.rst | 20 and device sensing will be done on any of those devices. The subchannel to
76 When a device is un-ignored, device recognition and sensing is performed and
|
1234567