Searched full:sends (Results 1 – 25 of 1094) sorted by relevance
12345678910>>...44
| /linux-6.12.1/Documentation/networking/ |
| D | can_ucan_protocol.rst | 22 The driver sends device management commands on this endpoint
25 The device sends CAN data frames and CAN error frames
28 The driver sends CAN data frames on the out endpoint
303 error frames (see ``uapi/linux/can/error.h``) and sends it using the
318 - Once Bus OFF recover is completed the device sends an error frame
328 #) Host sends command ``UCAN_COMMAND_RESET``, subcmd 0
329 #) Host sends command ``UCAN_COMMAND_GET``, subcmd ``UCAN_COMMAND_GET_INFO``
330 #) Device sends ``UCAN_IN_DEVICE_INFO``
331 #) Host sends command ``UCAN_OUT_SET_BITTIMING``
332 #) Host sends command ``UCAN_COMMAND_START``, subcmd 0, mode ``UCAN_MODE_BERR_REPORT``
|
| /linux-6.12.1/Documentation/sound/cards/ |
| D | serial-u16550.rst | 18 sends the nonstandard MIDI command sequence F5 NN, where NN is the substream
37 module parameter is automatically set to 1. The driver sends the same data to
49 the outs module parameter is automatically set to 1. The driver sends
62 Out 3, and midiCnD8 to Out 4. Thus midiCnD15 sends the data to all 4 ports.
63 As a special case, midiCnD0 also sends to all ports, since it is not useful
|
| /linux-6.12.1/include/linux/avf/ |
| D | virtchnl.h | 98 /* The PF sends status change events to VFs using
196 * VF sends this request to PF with no parameters
217 * Version 1.0 VF sends this request to PF with no parameters
218 * Version 1.1 VF sends this request to PF with u32 bitmap of its capabilities
286 * VF sends this message to set up parameters for one TX queue.
304 * VF sends this message to set up parameters for one RX queue.
337 * VF sends this message to set parameters for all active TX and RX queues
365 * VF sends this message to request the PF to allocate additional queues to
412 * VF sends these message to enable or disable TX/RX queue pairs.
431 * VF sends this message in order to add one or more unicast or multicast
[all …]
|
| /linux-6.12.1/include/rdma/ |
| D | ib_cm.h | 374 * ib_send_cm_req - Sends a connection request to the remote node.
398 * ib_send_cm_rep - Sends a connection reply in response to a connection
409 * ib_send_cm_rtu - Sends a connection ready to use message in response
421 * ib_send_cm_dreq - Sends a disconnection request for an existing
434 * ib_send_cm_drep - Sends a disconnection reply to a disconnection request.
465 * ib_send_cm_rej - Sends a connection rejection message to the
486 * ib_send_cm_mra - Sends a message receipt acknowledgement to a connection
532 * ib_send_cm_sidr_req - Sends a service ID resolution request to the
553 * ib_send_cm_sidr_rep - Sends a service ID resolution reply to the
|
| /linux-6.12.1/drivers/net/ethernet/intel/idpf/ |
| D | virtchnl2.h | 461 * @max_sriov_vfs: The PF sends the maximum VFs it is requesting. The CP
478 * Dataplane driver sends this message to CP to negotiate capabilities and
591 * PF sends this message to CP to create a vport by filling in required
631 * PF sends this message to CP to destroy, enable or disable a vport by filling
694 * PF sends this message to set up parameters for one or more transmit queues.
773 * PF sends this message to set up parameters for one or more receive queues.
799 * PF sends this message to request additional transmit/receive queues beyond
863 * PF sends virtchnl2_vector_chunks struct to specify the vectors it is giving
881 * PF sends this message to request additional interrupt vectors beyond the
904 * PF sends this message to get or set RSS lookup table. Only supported if
[all …]
|
| /linux-6.12.1/Documentation/staging/ |
| D | rpmsg.rst | 73 sends a message across to the remote processor from the given endpoint.
93 sends a message across to the remote processor from a given endpoint,
119 sends a message across to the remote processor, using the src and dst
142 sends a message across to the remote processor from a given endpoint.
160 sends a message across to the remote processor from a given endpoint,
182 sends a message across to the remote processor, using source and
267 The following is a simple rpmsg driver, that sends an "hello!" message
|
| /linux-6.12.1/sound/soc/xilinx/ |
| D | Kconfig | 7 mode, IP receives audio in AES format, extracts PCM and sends
9 encapsulates PCM in AES format and sends AES data.
|
| /linux-6.12.1/Documentation/admin-guide/ |
| D | edid.rst | 18 - The monitor sends no or bogus EDID data.
19 - A KVM sends its own EDID data instead of querying the connected monitor.
|
| /linux-6.12.1/Documentation/hid/ |
| D | intel-ish-hid.rst | 194 independent. The sending side sends DMA_XFER message when the message is in
195 the respective host buffer (TX when host client sends, RX when FW client
196 sends). The recipient of DMA message responds with DMA_XFER_ACK, indicating
205 Here ISH acts as busmaster DMA controller. Hence when host sends DMA_XFER,
206 it's request to do host->ISH DMA transfer; when FW sends DMA_XFER, it means
243 - Host sends HOST_START_REQ_CMD, indicating that host ISHTP layer is up.
245 - Host sends HOST_ENUM_REQ_CMD (enumerate FW clients)
248 - For each FW ID found in that bitmap host sends
349 - Initially, the ISHTP driver sends a command, HOST_START_REQ_CMD, to the ISH bootloader. In respon…
351 …otloader, the ISHTP driver sends a LOADER_CMD_XFER_FRAGMENT command. After receiving another respo…
|
| /linux-6.12.1/Documentation/userspace-api/media/dvb/ |
| D | fe-diseqc-send-master-cmd.rst | 13 FE_DISEQC_SEND_MASTER_CMD - Sends a DiSEqC command
35 Sends the DiSEqC command pointed by :c:type:`dvb_diseqc_master_cmd`
|
| /linux-6.12.1/Documentation/virt/hyperv/ |
| D | vmbus.rst | 114 * Unidirectional: Either side sends a message and does not
116 * Request/response: One side (usually the guest) sends a message
122 sending a request. Hyper-V sends back the same transactionID in the
204 ring buffer transitions from empty to non-empty. If the guest sends
206 unnecessary. If a guest sends an excessive number of unnecessary
211 it sends a new message on the VMBus control path, or when a VMBus
281 The guest then tells Hyper-V to "send offers". Hyper-V sends an
|
| /linux-6.12.1/Documentation/driver-api/mei/ |
| D | iamt.rst | 45 When a local application sends a message addressed to the local Intel AMT host
89 and sends an event when the heartbeats stop.
91 configures the watchdog and sends the heartbeats.
|
| /linux-6.12.1/include/drm/intel/ |
| D | i915_gsc_proxy_mei_interface.h | 17 * @send: sends a proxy message from GSC FW to ME FW
24 * @send: Sends a proxy message to ME FW.
|
| /linux-6.12.1/Documentation/ABI/testing/ |
| D | sysfs-bus-fsi | 14 Sends an FSI BREAK command on a master's communication
24 Sends an FSI terminate command from the master to its
|
| /linux-6.12.1/Documentation/misc-devices/ |
| D | ibmvmc.rst | 152 RDMA of the HMC ID to the hypervisor, and then sends an Interface Open
154 hypervisor receives this information, it sends Add Buffer messages to the
156 connection. Finally, the hypervisor sends an Interface Open Response
181 and then sends a Signal Message. If a write() is attempted before VMC
185 state. When the hypervisor sends a message to the management, the data is
|
| /linux-6.12.1/Documentation/arch/sparc/ |
| D | adi.rst | 105 first. Hypervisor creates a sun4v error report and sends a
106 resumable error (TT=0x7e) trap to the kernel. The kernel sends
125 exception is sent to the kernel with TT=0x1a. The kernel sends
143 on a memory address, processor sends an MCD disabled trap. This
147 sends the task SIGSEGV signal with following info::
|
| /linux-6.12.1/include/linux/ |
| D | hil_mlc.h | 48 * is an IN or EXPECT, and then sends the given packet.
55 /* HILSE_OUT_LAST sends the given command packet to
60 /* HILSE_OUT_DISC sends the given command packet to
|
| D | spmi.h | 76 * @cmd: sends a non-data command sequence on the SPMI bus.
77 * @read_cmd: sends a register read command sequence on the SPMI bus.
78 * @write_cmd: sends a register write command sequence on the SPMI bus.
|
| /linux-6.12.1/Documentation/driver-api/md/ |
| D | md-cluster.rst | 240 performing resync finishes, it sends RESYNCING with an empty range to
263 2. Node 1 sends a NEWDISK message with uuid and slot number
275 8. If node 1 gets the lock, it sends METADATA_UPDATED after
277 9. If not (get "no-new-dev" lock), it fails the operation and sends
319 resync_finish() also sends a BITMAP_NEEDS_SYNC message which
367 This sends a RE_ADD message to all other nodes and then
|
| /linux-6.12.1/Documentation/userspace-api/ |
| D | tee.rst | 38 supplicants the communication goes in the other direction, the TEE sends
39 requests to the supplicant which then sends back the result.
|
| /linux-6.12.1/drivers/hwtracing/stm/ |
| D | Kconfig | 54 This is a kernel space trace source that sends kernel log
63 This is a kernel space trace source that sends periodic
|
| /linux-6.12.1/Documentation/driver-api/rapidio/ |
| D | rio_cm.rst | 69 Sends a connection request to a remote peer/channel.
71 Sends a data message through the specified channel.
83 If the specified channel is in the CONNECTED state, sends close notification
|
| /linux-6.12.1/Documentation/userspace-api/media/v4l/ |
| D | vidioc-encoder-cmd.rst | 39 ``VIDIOC_ENCODER_CMD`` sends a command to the encoder,
57 call sends an implicit START command to the encoder if it has not been
61 call of a streaming file descriptor sends an implicit immediate STOP to
|
| /linux-6.12.1/tools/perf/util/ |
| D | events_stats.h | 12 * when possible sends this number in a PERF_RECORD_LOST event. The number of
17 * The kernel discards mixed up samples and sends the number in a
|
| /linux-6.12.1/drivers/net/wireless/intel/iwlwifi/mei/ |
| D | sap.h | 49 * 1) Host sends %SAP_ME_MSG_START message with the physical address
59 * the host sends messages that let CSME know about the host's state.
60 * When the host driver is loaded, the host sends %SAP_MSG_NOTIF_WIFIDR_UP.
61 * When the host driver is unloaded, the host sends %SAP_MSG_NOTIF_WIFIDR_DOWN.
97 * granted, the hosts sends %SAP_MSG_NOTIF_HOST_OWNERSHIP_CONFIRMED.
116 * CSME sends filters to the host to let the host what inbound packets it must
153 * @supported_versions: The host sends to the CSME a zero-terminated array
|
12345678910>>...44