| /linux-6.12.1/arch/arm/boot/dts/intel/socfpga/ |
| D | socfpga_cyclone5_chameleon96.dts | 39 gpios = <&porta 14 GPIO_ACTIVE_LOW>;
45 gpios = <&porta 22 GPIO_ACTIVE_LOW>;
51 gpios = <&porta 25 GPIO_ACTIVE_LOW>;
|
| D | socfpga_arria5_socdk.dts | 34 gpios = <&porta 0 1>;
44 gpios = <&porta 17 1>;
49 gpios = <&porta 18 1>;
|
| D | socfpga_cyclone5_vining_fpga.dts | 63 gpios = <&porta 9 GPIO_ACTIVE_LOW>; /* HPS_GPIO9 */
85 snps,reset-gpio = <&porta 0 GPIO_ACTIVE_LOW>;
|
| D | socfpga_cyclone5_socrates.dts | 58 gpios = <&porta 28 1>;
|
| /linux-6.12.1/Documentation/devicetree/bindings/input/ |
| D | clps711x-keypad.txt | 18 row-gpios = <&porta 0 0>,
19 <&porta 1 0>;
|
| /linux-6.12.1/Documentation/devicetree/bindings/gpio/ |
| D | gpio-clps711x.txt | 20 gpio0 = &porta;
23 porta: gpio@80000000 {
|
| D | microchip,pic32-gpio.txt | 27 /* PORTA */
|
| D | snps,dw-apb-gpio.yaml | 125 porta: gpio-port@0 {
|
| /linux-6.12.1/sound/soc/codecs/ |
| D | cx2072x.c | 899 SOC_SINGLE("PortA HP Amp Switch", CX2072X_PORTA_PIN_CTRL, 7, 1, 0),
1099 SOC_DAPM_ENUM("PortA Mux", porta_dac_enum);
1190 SND_SOC_DAPM_MUX("PortA Mux", SND_SOC_NOPM, 0, 0, &porta_mux),
1195 SND_SOC_DAPM_REG(snd_soc_dapm_supply, "PortA Power",
1208 SND_SOC_DAPM_SWITCH("PortA Out En", SND_SOC_NOPM, 0, 0,
1217 SND_SOC_DAPM_OUTPUT("PORTA"),
1279 {"PortA Mux", "DAC1 Switch", "DAC1"},
1280 {"PortA Mux", "DAC2 Switch", "DAC2"},
1292 {"PortA Out En", "Switch", "PortA Mux"},
1296 {"PortA Mux", NULL, "PortA Power"},
[all …]
|
| /linux-6.12.1/drivers/media/pci/saa7164/ |
| D | saa7164-cards.c | 43 .porta = SAA7164_MPEG_DVB,
89 .porta = SAA7164_MPEG_DVB,
135 .porta = SAA7164_MPEG_DVB,
195 .porta = SAA7164_MPEG_DVB,
255 .porta = SAA7164_MPEG_DVB,
315 .porta = SAA7164_MPEG_DVB,
375 .porta = SAA7164_MPEG_DVB,
435 .porta = SAA7164_MPEG_DVB,
491 .porta = SAA7164_MPEG_DVB,
537 .porta = SAA7164_MPEG_DVB,
[all …]
|
| D | saa7164-core.c | 608 struct saa7164_port *porta, *portb, *portc, *portd, *porte, *portf; in saa7164_irq() local
619 porta = &dev->ports[SAA7164_PORT_TS1]; in saa7164_irq()
662 } else if (intid == porta->hwcfg.interruptid) { in saa7164_irq()
665 saa7164_irq_ts(porta); in saa7164_irq()
1362 if (saa7164_boards[dev->board].porta == SAA7164_MPEG_DVB) { in saa7164_initdev()
1364 printk(KERN_ERR "%s() Failed to register dvb adapters on porta\n", in saa7164_initdev()
1471 if (saa7164_boards[dev->board].porta == SAA7164_MPEG_DVB) in saa7164_finidev()
|
| /linux-6.12.1/drivers/media/pci/cx23885/ |
| D | cx23885-cards.c | 86 .porta = CX23885_ANALOG_VIDEO,
118 .porta = CX23885_ANALOG_VIDEO,
162 .porta = CX23885_ANALOG_VIDEO,
215 .porta = CX23885_ANALOG_VIDEO,
248 .porta = CX23885_ANALOG_VIDEO,
316 .porta = CX23885_ANALOG_VIDEO,
345 .porta = CX23885_ANALOG_VIDEO,
375 .porta = CX23885_ANALOG_VIDEO,
405 .porta = CX23885_ANALOG_VIDEO,
432 .porta = CX23885_ANALOG_VIDEO,
[all …]
|
| /linux-6.12.1/arch/arm64/boot/dts/amd/ |
| D | elba-asic-common.dtsi | 67 cs-gpios = <0>, <0>, <&porta 1 GPIO_ACTIVE_LOW>,
68 <&porta 7 GPIO_ACTIVE_LOW>;
|
| /linux-6.12.1/sound/soc/sh/ |
| D | siu_dai.c | 110 /* portA, portB, SIU operate */ in siu_dai_start()
113 /* portA=256fs, portB=256fs */ in siu_dai_start()
116 /* portA's BRG does not divide SIUCKA */ in siu_dai_start()
126 /* portA: 32 bit/fs, master; portB: 32 bit/fs, master */ in siu_dai_start()
155 idx = 1; /* portA */ in siu_dai_spbAselect()
180 idx = 7; /* portA */ in siu_dai_spbBselect()
202 /* portA operates */ in siu_dai_open()
214 /* Unmute and configure portA */ in siu_dai_open()
|
| /linux-6.12.1/drivers/gpio/ |
| D | gpio-janz-ttl.c | 40 __be16 porta; member
86 port = &mod->regs->porta; in ttl_set_value()
132 iowrite16be(0x0000, &mod->regs->porta); in ttl_setup_device()
|
| /linux-6.12.1/arch/arm/boot/dts/cirrus/ |
| D | ep7209.dtsi | 16 gpio0 = &porta;
58 porta: gpio@80000000 { label
|
| /linux-6.12.1/include/dt-bindings/pinctrl/ |
| D | r7s9210-pinctrl.h | 22 #define PORTA 10 macro
|
| /linux-6.12.1/Documentation/devicetree/bindings/regulator/ |
| D | mps,mp886x.yaml | 57 enable-gpios = <&porta 1 GPIO_ACTIVE_LOW>;
|
| /linux-6.12.1/arch/arm64/boot/dts/hisilicon/ |
| D | hip05-d02.dts | 35 gpios = <&porta 8 GPIO_ACTIVE_LOW>;
|
| /linux-6.12.1/arch/arm/boot/dts/synaptics/ |
| D | berlin2cd-valve-steamlink.dts | 21 gpios = <&porta 6 GPIO_ACTIVE_HIGH>;
|
| /linux-6.12.1/drivers/scsi/ |
| D | aha152x.h | 42 #define PORTA (HOSTIOPORT1+0x1a) /* PORT A */ macro
253 /* On the AHA-152x board PORTA and PORTB contain
|
| /linux-6.12.1/sound/oss/dmasound/ |
| D | dmasound_atari.c | 1368 int porta; in AtaMixerIoctl() local
1371 porta = sound_ym.rd_data_reg_sel; in AtaMixerIoctl()
1373 return IOCTL_OUT(arg, porta & 0x40 ? 0 : 100); in AtaMixerIoctl()
1381 int porta; in AtaMixerIoctl() local
1385 porta = (sound_ym.rd_data_reg_sel & ~0x40) | in AtaMixerIoctl()
1387 sound_ym.wd_data = porta; in AtaMixerIoctl()
1389 return IOCTL_OUT(arg, porta & 0x40 ? 0 : 100); in AtaMixerIoctl()
|
| /linux-6.12.1/tools/firewire/ |
| D | nosy-dump.h | 59 uint32_t porta:2; member
|
| /linux-6.12.1/Documentation/translations/it_IT/process/ |
| D | 4.Coding.rst | 218 porta risolve più problemi di quanti non ne crei. Perché, dunque, non fare
219 un cambiamento se questo porta a nuove funzionalità a dieci sistemi per
427 fatti, ma devono essere giustificati. Quindi ogni patch che porta ad una
|
| /linux-6.12.1/Documentation/translations/it_IT/locking/ |
| D | locktypes.rst | 129 ottenere una priorità superiore. Di consequenza, bloccarsi sui semafori porta
154 continuerà a trattenere il blocco, quindi porta all'inedia anche gli scrittori
323 continuerà a trattenere il blocco, quindi porta all'inedia anche gli
|