Searched full:multiplexers (Results 1 – 25 of 29) sorted by relevance
12
| /linux-6.12.1/drivers/net/mdio/ |
| D | Kconfig | 210 comment "MDIO Multiplexers"
217 multiplexers which connect one of several child MDIO busses
229 the amlogic g12a SoC. The multiplexers connects either the external
244 tristate "Broadcom BCM6368 MDIO bus multiplexers"
249 This module provides a driver for MDIO bus multiplexers found in
255 tristate "Broadcom iProc based MDIO bus multiplexers"
260 This module provides a driver for MDIO bus multiplexers found in
266 tristate "GPIO controlled MDIO bus multiplexers"
270 This module provides a driver for MDIO bus multiplexers that
288 tristate "MMIO device-controlled MDIO bus multiplexers"
[all …]
|
| /linux-6.12.1/drivers/mux/ |
| D | Kconfig | 13 tristate "Analog Devices ADG792A/ADG792G Multiplexers"
16 ADG792A and ADG792G Wide Bandwidth Triple 4:1 Multiplexers
18 The driver supports both operating the three multiplexers in
25 tristate "Analog Devices ADGS1408/ADGS1409 Multiplexers"
43 multiplexers, which in that case will be operated in parallel.
|
| /linux-6.12.1/Documentation/devicetree/bindings/mux/ |
| D | mux-controller.yaml | 15 several parallel multiplexers. Presumably there will be at least one
17 control several multiplexers for a single consumer.
140 * parallel 4-way multiplexers controlled by the same two GPIO-lines.
|
| D | adi,adg792a.txt | 1 Bindings for Analog Devices ADG792A/G Triple 4:1 Multiplexers
|
| D | gpio-mux.yaml | 14 multiplexers, if the same pins control more than one multiplexer.
|
| D | reg-mux.yaml | 13 Define register bitfields to be used to control multiplexers. The parent
|
| /linux-6.12.1/Documentation/devicetree/bindings/i2c/ |
| D | i2c-mux-gpmux.yaml | 59 However, I2C transactions to devices behind all I2C multiplexers connected
66 The properties of mux-locked and parent-locked multiplexers are discussed
|
| D | i2c-mux-ltc4306.txt | 19 multiplexers on the bus and the devices behind them use same I2C addresses.
|
| D | i2c-mux.yaml | 17 For i2c multiplexers/switches that have child nodes that are a mixture of both
|
| D | i2c-mux-pca954x.yaml | 63 necessary for example, if there are several multiplexers on the bus and
|
| /linux-6.12.1/drivers/iio/multiplexer/ |
| D | Kconfig | 7 menu "Multiplexers" menu
|
| /linux-6.12.1/Documentation/devicetree/bindings/clock/st/ |
| D | st,clkgen-mux.txt | 3 This binding supports only simple indexed multiplexers, it does not
|
| /linux-6.12.1/include/linux/platform_data/ |
| D | mlxcpld.h | 11 /* Platform data for the CPLD I2C multiplexers */
|
| /linux-6.12.1/Documentation/devicetree/bindings/sound/ |
| D | simple-audio-mux.yaml | 13 Simple audio multiplexers are driven using gpios, allowing to select which of
|
| /linux-6.12.1/Documentation/admin-guide/media/ |
| D | imx.rst | 68 - Two video multiplexers for selecting among multiple sensor inputs
113 multiplexers, but the internal IPUv3 topology downstream from there
151 multiplexers as described below.
154 two video multiplexers. Both CSI0 and CSI1 can receive any virtual
155 channel, as selected by the video multiplexers.
165 These are the video multiplexers. They have two or more sink pads to
|
| /linux-6.12.1/Documentation/devicetree/bindings/media/ |
| D | video-mux.yaml | 14 Video multiplexers allow to select between multiple input ports. Video
|
| /linux-6.12.1/sound/soc/codecs/ |
| D | tlv320aic31xx.h | 49 #define AIC31XX_CLKMUX AIC31XX_REG(0, 4) /* Clock clock Gen muxing, Multiplexers*/
62 #define AIC31XX_CLKOUTMUX AIC31XX_REG(0, 25) /* Clock setting register 9, Multiplexers */
|
| /linux-6.12.1/drivers/media/platform/ |
| D | Kconfig | 62 This driver provides support for N:1 video bus multiplexers.
|
| /linux-6.12.1/Documentation/devicetree/bindings/clock/ti/davinci/ |
| D | pll.txt | 5 an multiplexers for various clock signals.
|
| /linux-6.12.1/Documentation/devicetree/bindings/clock/ |
| D | ingenic,cgu.yaml | 11 typically includes a variety of PLLs, multiplexers, dividers & gates in order
|
| /linux-6.12.1/Documentation/devicetree/bindings/gpio/ |
| D | gpio-pca95xx.yaml | 13 Bindings for the family of I2C GPIO multiplexers/expanders: NXP PCA95xx,
|
| /linux-6.12.1/Documentation/devicetree/bindings/iio/adc/ |
| D | xilinx-xadc.txt | 43 multiplexers for simultaneous sampling.
|
| /linux-6.12.1/Documentation/iio/ |
| D | ad7380.rst | 98 Inputs ``AinX0`` of multiplexers correspond to the first half of IIO channels (i.e
|
| /linux-6.12.1/drivers/media/pci/bt8xx/ |
| D | bttv-cards.c | 2180 …Tetra : 4 Conexant Fusion 878A, no audio, video input set with analog multiplexers GPIO controlled…
2188 …/*Set the GPIO[18]->GPIO[21] as output pin.==> drive the video inputs through analog multiplexers*/
4552 * video multiplexers to provide up to 16 video inputs. These
4553 * multiplexers are controlled by the lower 8 GPIO pins of the
4554 * bt878. The multiplexers probably Pericom PI5V331Q or similar.
4589 /*Just set the right path in the analog multiplexers : channel 1 -> 4 ==> Analog Mux ==> MUX0*/ in picolo_tetra_muxsel()
|
| /linux-6.12.1/drivers/spi/ |
| D | Kconfig | 1217 This adds support for SPI multiplexers. Each SPI mux will be
|
12