| /linux-6.12.1/drivers/spi/ |
| D | spi-mpc512x-psc.c | 35 #define psc_addr(mps, regname) ({ \ argument
37 switch (mps->type) { \
39 struct mpc52xx_psc __iomem *psc = mps->psc; \
44 struct mpc5125_psc __iomem *psc = mps->psc; \
88 struct mpc512x_psc_spi *mps = spi_controller_get_devdata(spi->controller); in mpc512x_psc_spi_activate_cs() local
94 sicr = in_be32(psc_addr(mps, sicr)); in mpc512x_psc_spi_activate_cs()
111 out_be32(psc_addr(mps, sicr), sicr); in mpc512x_psc_spi_activate_cs()
113 ccr = in_be32(psc_addr(mps, ccr)); in mpc512x_psc_spi_activate_cs()
118 bclkdiv = (mps->mclk_rate / speed) - 1; in mpc512x_psc_spi_activate_cs()
121 out_be32(psc_addr(mps, ccr), ccr); in mpc512x_psc_spi_activate_cs()
[all …]
|
| D | spi-mpc52xx-psc.c | 63 struct mpc52xx_psc_spi *mps = spi_controller_get_devdata(spi->controller); in mpc52xx_psc_spi_activate_cs() local
64 struct mpc52xx_psc __iomem *psc = mps->psc; in mpc52xx_psc_spi_activate_cs()
97 mps->bits_per_word = cs->bits_per_word; in mpc52xx_psc_spi_activate_cs()
107 struct mpc52xx_psc_spi *mps = spi_controller_get_devdata(spi->controller); in mpc52xx_psc_spi_transfer_rxtx() local
108 struct mpc52xx_psc __iomem *psc = mps->psc; in mpc52xx_psc_spi_transfer_rxtx()
109 struct mpc52xx_psc_fifo __iomem *fifo = mps->fifo; in mpc52xx_psc_spi_transfer_rxtx()
159 wait_for_completion(&mps->done); in mpc52xx_psc_spi_transfer_rxtx()
242 static int mpc52xx_psc_spi_port_config(int psc_id, struct mpc52xx_psc_spi *mps) in mpc52xx_psc_spi_port_config() argument
244 struct mpc52xx_psc __iomem *psc = mps->psc; in mpc52xx_psc_spi_port_config()
245 struct mpc52xx_psc_fifo __iomem *fifo = mps->fifo; in mpc52xx_psc_spi_port_config()
[all …]
|
| /linux-6.12.1/Documentation/devicetree/bindings/regulator/ |
| D | mps,mpq7920.yaml | 4 $id: http://devicetree.org/schemas/regulator/mps,mpq7920.yaml#
17 - mps,mpq7920
30 mps,switch-freq:
54 mps,buck-softstart:
61 mps,buck-phase-delay:
68 mps,buck-ovp-disable:
91 compatible = "mps,mpq7920";
95 mps,switch-freq = /bits/ 8 <1>;
104 mps,buck-ovp-disable;
105 mps,buck-phase-delay = /bits/ 8 <2>;
[all …]
|
| D | mps,mp886x.yaml | 4 $id: http://devicetree.org/schemas/regulator/mps,mp886x.yaml#
18 - mps,mp8867
19 - mps,mp8869
28 mps,fb-voltage-divider:
34 mps,switch-frequency-hz:
42 - mps,fb-voltage-divider
53 compatible = "mps,mp8869";
58 mps,fb-voltage-divider = <80 240>;
|
| D | mps,mp5416.yaml | 4 $id: http://devicetree.org/schemas/regulator/mps,mp5416.yaml#
17 - mps,mp5416
18 - mps,mp5496
56 compatible = "mps,mp5416";
|
| D | mps,mpq2286.yaml | 4 $id: http://devicetree.org/schemas/regulator/mps,mpq2286.yaml#
15 - mps,mpq2286
46 compatible = "mps,mpq2286";
|
| D | mps,mpq7932.yaml | 4 $id: http://devicetree.org/schemas/regulator/mps,mpq7932.yaml#
15 - mps,mpq7932
48 compatible = "mps,mpq7932";
|
| D | mp8859.txt | 4 - compatible: "mps,mp8859";
13 compatible = "mps,mp8859";
|
| /linux-6.12.1/drivers/pci/ |
| D | Kconfig | 228 MPS (Max Payload Size) and MRRS (Max Read Request Size) are PCIe
232 The following choices set the MPS and MRRS optimization strategy
245 Use the BIOS defaults; don't touch MPS at all. This is the same
252 Default choice; ensure that the MPS matches upstream bridge.
258 Use largest MPS that boot-time devices support. If you have a
260 will use the largest MPS that's supported by all devices. This
267 Use MPS and MRRS for best performance. Ensure that a given
268 device's MPS is no larger than its parent MPS, which allows us to
269 keep all switches/bridges to the max MPS supported by their
276 Set MPS = 128 for all devices. MPS configuration effected by the
[all …]
|
| /linux-6.12.1/drivers/hwmon/pmbus/ |
| D | Kconfig | 323 tristate "MPS MP2856"
325 If you say yes here you get hardware monitoring support for MPS
332 tristate "MPS MP2888"
334 If you say yes here you get hardware monitoring support for MPS
341 tristate "MPS MP2891"
343 If you say yes here you get hardware monitoring support for MPS
350 tristate "MPS MP2975"
352 If you say yes here you get hardware monitoring support for MPS
359 tristate "MPS MP2993"
361 If you say yes here you get hardware monitoring support for MPS
[all …]
|
| D | mp5023.c | 3 * Driver for MPS MP5023 Hot-Swap Controller
48 { .compatible = "mps,mp5023", },
65 MODULE_DESCRIPTION("PMBus driver for MPS MP5023 HSC");
|
| D | mpq8785.c | 3 * Driver for MPS MPQ8785 Step-Down Converter
71 { .compatible = "mps,mpq8785" },
88 MODULE_DESCRIPTION("PMBus driver for MPS MPQ8785");
|
| /linux-6.12.1/Documentation/devicetree/bindings/leds/backlight/ |
| D | mps,mp3309c.yaml | 4 $id: http://devicetree.org/schemas/leds/backlight/mps,mp3309c.yaml#
7 title: MPS MP3309C backlight
13 The Monolithic Power (MPS) MP3309C is a WLED step-up converter, featuring a
28 const: mps,mp3309c
41 mps,overvoltage-protection-microvolt:
46 mps,no-sync-mode:
64 compatible = "mps,mp3309c";
69 mps,overvoltage-protection-microvolt = <24000000>;
|
| /linux-6.12.1/drivers/net/wireless/quantenna/qtnfmac/pcie/ |
| D | pcie.c | 145 qtnf_debugfs_add_entry(bus, "mps", qtnf_dbg_mps_show); in qtnf_pcie_fw_boot_done()
156 int mps_p, mps_o, mps_m, mps; in qtnf_tune_pcie_mps() local
159 /* current mps */ in qtnf_tune_pcie_mps()
162 /* maximum supported mps */ in qtnf_tune_pcie_mps()
165 /* suggested new mps value */ in qtnf_tune_pcie_mps()
166 mps = mps_m; in qtnf_tune_pcie_mps()
169 /* parent (bus) mps */ in qtnf_tune_pcie_mps()
174 mps = min(mps_m, mps_p); in qtnf_tune_pcie_mps()
178 ret = pcie_set_mps(pdev, mps); in qtnf_tune_pcie_mps()
180 pr_err("failed to set mps to %d, keep using current %d\n", in qtnf_tune_pcie_mps()
[all …]
|
| /linux-6.12.1/Documentation/devicetree/bindings/ |
| D | trivial-devices.yaml | 275 - mps,mp2856
277 - mps,mp2857
279 - mps,mp2888
281 - mps,mp2891
283 - mps,mp2971
285 - mps,mp2973
287 - mps,mp2975
289 - mps,mp2993
291 - mps,mp5920
293 - mps,mp5990
[all …]
|
| /linux-6.12.1/Documentation/devicetree/bindings/mfd/ |
| D | mps,mp2629.yaml | 4 $id: http://devicetree.org/schemas/mfd/mps,mp2629.yaml#
22 - mps,mp2629
23 - mps,mp2733
56 compatible = "mps,mp2629";
|
| /linux-6.12.1/Documentation/hwmon/ |
| D | mp5023.rst | 8 * MPS MP5023
14 Publicly available at the MPS website : https://www.monolithicpower.com/en/mp5023.html
23 This driver implements support for Monolithic Power Systems, Inc. (MPS)
|
| D | mp5990.rst | 8 * MPS MP5990
14 Publicly available at the MPS website : https://www.monolithicpower.com/en/mp5990.html
23 This driver implements support for Monolithic Power Systems, Inc. (MPS)
|
| D | mp5920.rst | 8 * MPS MP5920
14 Publicly available at the MPS website : https://www.monolithicpower.com/en/mp5920.html
24 This driver implements support for Monolithic Power Systems, Inc. (MPS)
|
| D | mp2856.rst | 8 * MPS MP2856
12 * MPS MP2857
23 This driver implements support for Monolithic Power Systems, Inc. (MPS)
|
| D | mp2891.rst | 8 * MPS mp2891
14 Publicly available at the MPS website : https://www.monolithicpower.com/en/mp2891.html
23 This driver implements support for Monolithic Power Systems, Inc. (MPS)
|
| /linux-6.12.1/drivers/regulator/ |
| D | mpq7920.c | 3 // mpq7920.c - regulator driver for mps mpq7920
218 if (of_property_read_bool(np, "mps,buck-ovp-disable")) { in mpq7920_parse_cb()
224 ret = of_property_read_u8(np, "mps,buck-phase-delay", &val); in mpq7920_parse_cb()
232 ret = of_property_read_u8(np, "mps,buck-softstart", &val); in mpq7920_parse_cb()
252 ret = of_property_read_u8(np, "mps,switch-freq", &freq); in mpq7920_parse_dt()
306 { .compatible = "mps,mpq7920"},
|
| /linux-6.12.1/drivers/net/ethernet/meta/fbnic/ |
| D | fbnic_mac.c | 28 unsigned int cls, unsigned int mps) in fbnic_init_mps() argument
32 /* Currently all MPS masks are identical so just use the first one */ in fbnic_init_mps()
35 val |= FIELD_PREP(FBNIC_QM_TNI_TCM_CTL_MPS, mps) | in fbnic_init_mps()
44 int readrq, mps, cls; in fbnic_mac_init_axi() local
57 mps = ilog2(fbd->mps) - 6; in fbnic_mac_init_axi()
58 mps = clamp(mps, 0, 3); in fbnic_mac_init_axi()
65 fbnic_init_mps(fbd, FBNIC_QM_TNI_TCM_CTL, cls, mps); in fbnic_mac_init_axi()
80 fbnic_init_mps(fbd, FBNIC_QM_RNI_RDE_CTL, cls, mps); in fbnic_mac_init_axi()
81 fbnic_init_mps(fbd, FBNIC_QM_RNI_RCM_CTL, cls, mps); in fbnic_mac_init_axi()
|
| /linux-6.12.1/drivers/mfd/ |
| D | mp2629.c | 22 .of_compatible = "mps,mp2629_adc",
26 .of_compatible = "mps,mp2629_charger",
63 { .compatible = "mps,mp2629"},
|
| /linux-6.12.1/include/uapi/linux/ |
| D | atmmpc.h | 78 #define MPS 1 macro
91 #define HOLDING_TIME_DEFAULT 1200 /* same as MPS-p7 */
107 #define DATA_PLANE_PURGE 208 /* Data plane purge because of egress cache hit miss or dead MPS */
|