Searched full:hooked (Results 1 – 25 of 168) sorted by relevance
1234567
| /linux-6.12.1/Documentation/devicetree/bindings/media/cec/ |
| D | cec-gpio.yaml | 14 hooked up to a pull-up GPIO line and - optionally - the HPD line is hooked up
|
| /linux-6.12.1/Documentation/userspace-api/media/cec/ |
| D | cec-ioc-adap-g-phys-addr.rst | 66 has address 0.0.0.0. Every device that is hooked up to an input of the
67 TV has address a.0.0.0 (where 'a' is ≥ 1), devices hooked up to those in
|
| /linux-6.12.1/drivers/input/misc/ |
| D | stpmic1_onkey.c | 17 * @irq_falling: irq that we are hooked on to
18 * @irq_rising: irq that we are hooked on to
|
| D | Kconfig | 68 Say Y here if you have AD7142/AD7147 hooked to an I2C bus.
78 Say Y here if you have AD7142/AD7147 hooked to a SPI bus.
145 acceleration sensor hooked to an I2C bus.
745 Say Y here if you have ADXL345/6 hooked to an I2C bus.
755 Say Y here if you have ADXL345/6 hooked to a SPI bus.
|
| /linux-6.12.1/Documentation/devicetree/bindings/power/ |
| D | rockchip-io-domain.yaml | 18 If the regulator hooked up to a pin like SDMMC0_VDD is 3.3V then
19 bit 7 of GRF_IO_VSEL needs to be 0. If the regulator hooked up to
24 hooked up to the pins.
|
| /linux-6.12.1/drivers/gpu/drm/panthor/ |
| D | panthor_fw.h | 285 * we have 'SHARED' GPU mappings hooked up.
329 * we have 'SHARED' GPU mappings hooked up.
373 * we have 'SHARED' GPU mappings hooked up.
|
| /linux-6.12.1/Documentation/devicetree/bindings/display/ |
| D | dp-aux-bus.yaml | 14 are hooked up to them. This is the DP AUX bus. Over the DP AUX bus
|
| /linux-6.12.1/Documentation/devicetree/bindings/display/panel/ |
| D | panel-edp.yaml | 108 needed if HPD hooked up, either through a GPIO in the panel node or
109 hooked up directly to the eDP controller.
|
| /linux-6.12.1/Documentation/admin-guide/media/ |
| D | cec.rst | 58 - cec-gpio. If the CEC pin is hooked up to a GPIO pin then
147 are PS176 based and do NOT have the CEC pin hooked up, so only the three Club3D
152 likely to have the CEC pin hooked up, it looks like they changed the reference
363 If you haven't hooked up the HPD and/or 5V lines, then just delete those
|
| /linux-6.12.1/Documentation/devicetree/bindings/interrupt-controller/ |
| D | fsl,ls-msi.yaml | 11 is hooked to a parent interrupt controller: e.g: ARM GIC for ARM-based
|
| /linux-6.12.1/drivers/media/pci/zoran/ |
| D | videocodec.c | 190 zrdev_dbg(zr, "videocodec: hooked in as first element\n"); in videocodec_register()
195 zrdev_dbg(zr, "videocodec: hooked in after '%s'\n", in videocodec_register()
|
| /linux-6.12.1/Documentation/admin-guide/LSM/ |
| D | index.rst | 6 various security checks to be hooked by new kernel extensions. The name
|
| /linux-6.12.1/arch/arm/boot/dts/rockchip/ |
| D | rk3288-evb.dtsi | 166 * NOTE: vcc_sd isn't hooked up on v1.0 boards where power comes from
229 disable-wp; /* wp not hooked up */
|
| D | rk3288-veyron-sdmmc.dtsi | 40 * Builtin CD line is hooked to ground to prevent JTAG at boot
|
| /linux-6.12.1/net/ipv4/netfilter/ |
| D | iptable_raw.c | 3 * 'raw' table, which is the very first hooked in at PRE_ROUTING and LOCAL_OUT .
|
| /linux-6.12.1/include/drm/display/ |
| D | drm_dp_aux_bus.h | 21 * be hooked up there.
|
| /linux-6.12.1/arch/arc/mm/ |
| D | highmem.c | 35 * - Both fixmap/pkmap use a dedicated page table each, hooked up to swapper PGD
|
| /linux-6.12.1/Documentation/sound/soc/ |
| D | jack.rst | 69 These are all hooked together by the machine driver depending on the
|
| /linux-6.12.1/arch/arm/boot/dts/allwinner/ |
| D | sun6i-a31-colombus.dts | 64 /* The lcd panel i2c interface is hooked up via gpios */
|
| D | sun5i-a13-utoo-p66.dts | 62 /* The lcd panel i2c interface is hooked up via gpios */
|
| /linux-6.12.1/tools/tracing/rtla/src/ |
| D | timerlat_aa.c | 262 * hooked to the osnoise:nmi_noise event.
299 * hooked to the osnoise:irq_noise event.
399 * hooked to the osnoise:softirq_noise event.
432 * hooked to the osnoise:thread_noise event.
|
| /linux-6.12.1/arch/arc/include/asm/ |
| D | smp.h | 39 * Takes @cpu and @hwirq to which the arch-common ISR is hooked up
|
| /linux-6.12.1/arch/arm64/boot/dts/qcom/ |
| D | sc7280-herobrine-zombie.dtsi | 90 * - If a pin is not hooked up on Qcard, it gets no name.
|
| D | sc7280-herobrine-evoker.dtsi | 114 * - If a pin is not hooked up on Qcard, it gets no name.
|
| D | sc7280-chrome-common.dtsi | 85 * Chrome designs always boot from SPI flash hooked up to the qspi.
|
1234567