Searched +full:feedback +full:- +full:pull +full:- +full:up +full:- +full:r1 +full:- +full:ohms (Results 1 – 3 of 3) sorted by relevance
| /linux-6.12.1/Documentation/devicetree/bindings/regulator/ |
| D | rohm,bd71847-regulator.yaml | 1 # SPDX-License-Identifier: GPL-2.0-only OR BSD-2-Clause
3 ---
4 $id: http://devicetree.org/schemas/regulator/rohm,bd71847-regulator.yaml#
5 $schema: http://devicetree.org/meta-schemas/core.yaml#
10 - Matti Vaittinen <mazziesaccount@gmail.com>
15 Documentation/devicetree/bindings/mfd/rohm,bd71847-pmic.yaml
21 regulator-boot-on at least for BUCK5. LDO6 is supplied by it and it must
30 "^LDO[1-6]$":
37 regulator-name:
38 pattern: "^ldo[1-6]$"
[all …]
|
| D | rohm,bd71837-regulator.yaml | 1 # SPDX-License-Identifier: GPL-2.0-only OR BSD-2-Clause
3 ---
4 $id: http://devicetree.org/schemas/regulator/rohm,bd71837-regulator.yaml#
5 $schema: http://devicetree.org/meta-schemas/core.yaml#
10 - Matti Vaittinen <mazziesaccount@gmail.com>
15 Documentation/devicetree/bindings/mfd/rohm,bd71837-pmic.yaml
21 regulator-boot-on at least for BUCK6 and BUCK7 so that those are not
31 "^LDO[1-7]$":
38 regulator-name:
39 pattern: "^ldo[1-7]$"
[all …]
|
| /linux-6.12.1/drivers/regulator/ |
| D | bd718x7-regulator.c | 1 // SPDX-License-Identifier: GPL-2.0
3 // bd71837-regulator.c ROHM BD71837MWV/BD71847MWV regulator driver
10 #include <linux/mfd/rohm-bd718x7.h>
51 * controlled by software - or by PMIC internal HW state machine. Whether
52 * regulator should be under SW or HW control can be defined from device-tree.
103 * Note for next hacker - these PMICs have a register where the HW state can be
104 * read. If assuming RUN appears to be false in your use-case - you can
123 ret = regmap_read(rdev->regmap, rdev->desc->enable_reg, &val); in bd71837_get_buck34_enable_hwctrl()
138 * guarantee minimum of 1ms sleep - it shouldn't matter if we in voltage_change_done()
143 ret = regmap_clear_bits(rdev->regmap, BD718XX_REG_MVRFLTMASK2, in voltage_change_done()
[all …]
|