Searched full:electrical (Results 1 – 25 of 85) sorted by relevance
1234
27 If some electrical strap or alternate resolution is desired,31 certain electrical driving levels.
21 * Table 4-1: Electrical Characteristics22 * ->DC Electrical Timing
23 slots) or electrical issues during the transmit/receive transition cannot35 Slave or to a non-implemented register) or electrical issue, no response
58 Clause 33 of the IEEE 802.3 standard defines the functional and electrical67 Clause 104 of the IEEE 802.3 standard delineates the functional and electrical
28 control power supplied to electrical devices.
30 systems are also I2C conformant. The electrical constraints are tighter
7 Due to electrical and mechanical constraints in certain platform designs
397 is a way for chip vendors producing some kind of electrical packages to use702 that your datasheet calls "GPIO mode", but actually is just an electrical757 software-control a few electrical properties of the pin that you would777 Here some electrical properties of the pin can be configured no matter823 - Registers (or fields within registers) that control electrical844 Electrical properties of the pin such as biasing and drive strength926 GPIO subsystem. It is just an electrical configuration used by that device
41 on the other side of the cable. Used for electrical quality
58 /* electrical parameter block */
101 /* electrical parameter block */
64 /* 1=Enable SERDES Electrical Idle */
13 This binding describes an electrical setup where setting an GPIO output
15 electrical signals for DSI.
16 * Faculty of Electrical Engineering (http://www.fel.cvut.cz)
27 meet both SMBus and I2C electrical constraints; and others which can't
62 - method to set electrical configuration for a given GPIO line90 GPIO electrical configuration93 GPIO lines can be configured for several electrical modes of operation by using249 supports more versatile control over electrical properties and can handle
66 the electrical configuration.
18 /* Pad Electrical Controls. */
119 There may be electrical problems on this board.
110 * Configure LEDs electrical polarity
15 is to help reduce electrical emission (EMI)
9 electrical characteristics of drivers and receivers for use in balanced