Home
last modified time | relevance | path

Searched +full:drive +full:- +full:impedance +full:- +full:ohm (Results 1 – 9 of 9) sorted by relevance

/linux-6.12.1/Documentation/devicetree/bindings/phy/
Drockchip,rk3399-emmc-phy.yaml1 # SPDX-License-Identifier: GPL-2.0-only
3 ---
4 $id: http://devicetree.org/schemas/phy/rockchip,rk3399-emmc-phy.yaml#
5 $schema: http://devicetree.org/meta-schemas/core.yaml#
10 - Heiko Stuebner <heiko@sntech.de>
14 const: rockchip,rk3399-emmc-phy
22 clock-names:
25 drive-impedance-ohm:
28 Specifies the drive impedance in Ohm.
32 rockchip,enable-strobe-pulldown:
[all …]
/linux-6.12.1/Documentation/devicetree/bindings/pinctrl/
Dpincfg-node.yaml1 # SPDX-License-Identifier: GPL-2.0-only
3 ---
4 $id: http://devicetree.org/schemas/pinctrl/pincfg-node.yaml#
5 $schema: http://devicetree.org/meta-schemas/core.yaml#
10 - Linus Walleij <linus.walleij@linaro.org>
21 bias-disable:
25 bias-high-impedance:
27 description: high impedance mode ("third-state", "floating")
29 bias-bus-hold:
33 bias-pull-up:
[all …]
/linux-6.12.1/drivers/phy/rockchip/
Dphy-rockchip-emmc.c1 // SPDX-License-Identifier: GPL-2.0-only
5 * Copyright (C) 2016 Shawn Lin <shawn.lin@rock-chips.com>
20 * The higher 16-bit of this register is used for write protection
106 regmap_write(rk_phy->reg_base, in rockchip_emmc_phy_power()
107 rk_phy->reg_offset + GRF_EMMCPHY_CON6, in rockchip_emmc_phy_power()
111 regmap_write(rk_phy->reg_base, in rockchip_emmc_phy_power()
112 rk_phy->reg_offset + GRF_EMMCPHY_CON6, in rockchip_emmc_phy_power()
121 rate = clk_get_rate(rk_phy->emmcclk); in rockchip_emmc_phy_power()
146 rate - ideal_rate : ideal_rate - rate; in rockchip_emmc_phy_power()
155 dev_warn(&phy->dev, "Unsupported rate: %lu\n", rate); in rockchip_emmc_phy_power()
[all …]
/linux-6.12.1/drivers/phy/intel/
Dphy-intel-lgm-emmc.c1 // SPDX-License-Identifier: GPL-2.0
64 ret = regmap_update_bits(priv->syscfg, EMMC_PHYCTRL1_REG, PDB_MASK, in intel_emmc_phy_power()
67 dev_err(&phy->dev, "CALIO power down bar failed: %d\n", ret); in intel_emmc_phy_power()
75 rate = clk_get_rate(priv->emmcclk); in intel_emmc_phy_power()
78 dev_warn(&phy->dev, "Unsupported rate: %lu\n", rate); in intel_emmc_phy_power()
88 ret = regmap_update_bits(priv->syscfg, EMMC_PHYCTRL1_REG, PDB_MASK, in intel_emmc_phy_power()
91 dev_err(&phy->dev, "CALIO power down bar failed: %d\n", ret); in intel_emmc_phy_power()
102 ret = regmap_read_poll_timeout(priv->syscfg, EMMC_PHYSTAT_REG, in intel_emmc_phy_power()
106 dev_err(&phy->dev, "caldone failed, ret=%d\n", ret); in intel_emmc_phy_power()
111 ret = regmap_update_bits(priv->syscfg, EMMC_PHYCTRL2_REG, FRQSEL_MASK, in intel_emmc_phy_power()
[all …]
/linux-6.12.1/Documentation/devicetree/bindings/soc/rockchip/
Dgrf.yaml1 # SPDX-License-Identifier: GPL-2.0
3 ---
5 $schema: http://devicetree.org/meta-schemas/core.yaml#
10 - Heiko Stuebner <heiko@sntech.de>
15 - items:
16 - enum:
17 - rockchip,rk3288-sgrf
18 - rockchip,rk3566-pipe-grf
19 - rockchip,rk3568-pcie3-phy-grf
20 - rockchip,rk3568-pipe-grf
[all …]
/linux-6.12.1/arch/arm64/boot/dts/rockchip/
Drk3399-puma.dtsi1 // SPDX-License-Identifier: (GPL-2.0+ OR MIT)
6 #include <dt-bindings/pwm/pwm.h>
16 compatible = "gpio-leds";
17 pinctrl-names = "default";
18 pinctrl-0 = <&module_led_pin>;
20 module_led: led-0 {
23 linux,default-trigger = "heartbeat";
24 panic-indicator;
28 extcon_usb3: extcon-usb3 {
29 compatible = "linux,extcon-usb-gpio";
[all …]
Drk3399-base.dtsi1 // SPDX-License-Identifier: (GPL-2.0+ OR MIT)
6 #include <dt-bindings/clock/rk3399-cru.h>
7 #include <dt-bindings/gpio/gpio.h>
8 #include <dt-bindings/interrupt-controller/arm-gic.h>
9 #include <dt-bindings/interrupt-controller/irq.h>
10 #include <dt-bindings/pinctrl/rockchip.h>
11 #include <dt-bindings/power/rk3399-power.h>
12 #include <dt-bindings/thermal/thermal.h>
17 interrupt-parent = <&gic>;
18 #address-cells = <2>;
[all …]
/linux-6.12.1/sound/soc/codecs/
Dnau8825.c1 // SPDX-License-Identifier: GPL-2.0-only
8 * Co-author: Meng-Huang Kuo <mhkuo@nuvoton.com>
35 #define NUVOTON_CODEC_DAI "nau8825-hifi"
223 * nau8825_sema_acquire - acquire the semaphore of nau88l25
233 * this function returns -ETIME. If the sleep is interrupted by a signal,
234 * this function will return -EINTR. It returns 0 if the semaphore was
246 ret = down_timeout(&nau8825->xtalk_sem, timeout); in nau8825_sema_acquire()
248 dev_warn(nau8825->dev, "Acquire semaphore timeout\n"); in nau8825_sema_acquire()
250 ret = down_trylock(&nau8825->xtalk_sem); in nau8825_sema_acquire()
252 dev_warn(nau8825->dev, "Acquire semaphore fail\n"); in nau8825_sema_acquire()
[all …]
/linux-6.12.1/arch/arm/boot/dts/st/
Dste-ux500-samsung-janice.dts1 // SPDX-License-Identifier: GPL-2.0-only
3 * Devicetree for the Samsung Galaxy S Advance GT-I9070 also known as Janice.
6 /dts-v1/;
7 #include "ste-db8500.dtsi"
8 #include "ste-ab8500.dtsi"
9 #include "ste-dbx5x0-pinctrl.dtsi"
10 #include <dt-bindings/gpio/gpio.h>
11 #include <dt-bindings/leds/common.h>
12 #include <dt-bindings/input/input.h>
13 #include <dt-bindings/interrupt-controller/irq.h>
[all …]