Searched full:compensated (Results 1 – 25 of 39) sorted by relevance
12
| /linux-6.12.1/include/linux/ |
| D | packing.h | 28 * @startbit: The index (in logical notation, compensated for quirks) where
31 * @endbit: The index (in logical notation, compensated for quirks) where
|
| /linux-6.12.1/arch/arm/mach-omap2/ |
| D | voltage.c | 46 * voltdm_get_voltage() - Gets the current non-auto-compensated voltage
49 * API to get the current non-auto-compensated voltage for a voltage domain.
174 * This API searches only through the non-compensated voltages int the
|
| /linux-6.12.1/Documentation/admin-guide/media/ |
| D | imx.rst | 95 - The VDIC subdev supports motion compensated de-interlacing, with three
199 will carry out motion-compensated de-interlace using "high motion" mode
277 The VDIC carries out motion compensated de-interlacing, with three
384 Motion Compensated De-interlace:
388 support motion-compensated de-interlacing (high motion mode only),
493 Compensated de-interlacing. The adv7180 must output sequential or
551 Compensated de-interlacing. The adv7180 must output sequential or
|
| /linux-6.12.1/lib/ |
| D | packing.c | 58 * @startbit: The index (in logical notation, compensated for quirks) where
61 * @endbit: The index (in logical notation, compensated for quirks) where
|
| /linux-6.12.1/Documentation/devicetree/bindings/regulator/ |
| D | renesas,raa215300.yaml | 15 and LPDDR4 memory power requirements. The internally compensated regulators,
|
| /linux-6.12.1/Documentation/usb/ |
| D | mtouchusb.rst | 17 Changed data sent to host from compensated to raw coordinates
|
| /linux-6.12.1/include/soc/at91/ |
| D | at91sam9_sdramc.h | 63 #define AT91_SDRAMC_TCSR (3 << 8) /* Temperature Compensated Self Refresh */
|
| D | at91sam9_ddrsdr.h | 82 #define AT91_DDRSDRC_TCSR (3 << 8) /* Temperature Compensated Self Refresh */
|
| /linux-6.12.1/drivers/iio/pressure/ |
| D | mpl115.c | 73 /* compensated pressure with 4 fractional bits */ in mpl115_comp_pressure()
|
| /linux-6.12.1/include/linux/fsl/ |
| D | ptp_qoriq.h | 89 #define BYP (1<<3) /* Bypass drift compensated clock */
|
| /linux-6.12.1/tools/perf/pmu-events/arch/arm64/thead/yitian710/sys/ |
| D | ali_drw.json | 311 "BriefDescription": "A Temperature Compensated Refresh(TCR) MRR command to DRAM.",
|
| /linux-6.12.1/arch/mips/dec/ |
| D | int-handler.S | 234 * simple and O(log n), so it gets compensated.
|
| /linux-6.12.1/drivers/power/supply/ |
| D | ab8500_fg.c | 864 * Returns battery capacity based on battery voltage that is not compensated
924 * ab8500_load_comp_fg_bat_voltage() - get load compensated battery voltage
928 * Returns compensated battery voltage (on success) else error code.
978 * ab8500_fg_load_comp_volt_to_capacity() - Load compensated voltage based capacity
981 * Returns battery capacity based on battery voltage that is load compensated
1087 * Return the capacity in mAh based on the load compensated battery voltage.
1564 * After that, use compensated voltage for a few in ab8500_fg_algorithm_discharging()
|
| /linux-6.12.1/drivers/input/keyboard/ |
| D | mpr121_touchkey.c | 201 * Capacitance on sensing input varies and needs to be compensated. in mpr121_phys_init()
|
| /linux-6.12.1/Documentation/hwmon/ |
| D | vt1211.rst | 84 external scaling resistors. This external scaling needs to be compensated for
|
| /linux-6.12.1/Documentation/driver-api/thermal/ |
| D | intel_dptf.rst | 214 which is compensated by adjusting Spread spectrum percent. This helps
|
| /linux-6.12.1/drivers/iio/magnetometer/ |
| D | mmc35240.c | 307 * @val: compensated output reading (unit is milli gauss)
|
| /linux-6.12.1/arch/m68k/fpsp040/ |
| D | bindec.S | 74 | compensated for by 'or-ing' in the INEX2 flag to
520 | If INEX is set, round error occurred. This is compensated
|
| /linux-6.12.1/drivers/media/i2c/ |
| D | rdacm21.c | 537 * This should be compensated by increasing the reverse channel in rdacm21_initialize()
|
| /linux-6.12.1/drivers/iio/common/ms_sensors/ |
| D | ms_sensors_i2c.c | 685 /* Temperature compensated pressure = D1 * SENS - OFF */ in ms_sensors_read_temp_and_pressure()
|
| /linux-6.12.1/drivers/net/ethernet/8390/ |
| D | ne2k-pci.c | 195 * mode results in doubled values, which can be detected and compensated for.
|
| /linux-6.12.1/drivers/net/wireless/intel/iwlegacy/ |
| D | 3945.c | 1345 * current "normal" temperature-compensated Tx power *idx* for in il3945_hw_reg_set_scan_power()
1346 * this rate (1Mb or 6Mb) to yield new temp-compensated scan power in il3945_hw_reg_set_scan_power()
1483 * update base (non-temp-compensated) power idx */ in il3945_hw_reg_set_new_power()
|
| /linux-6.12.1/drivers/i2c/busses/ |
| D | i2c-mxs.c | 742 * This is compensated for by subtracting the respective constants in mxs_i2c_derive_timing()
|
| /linux-6.12.1/drivers/net/ethernet/intel/ice/ |
| D | ice_type.h | 342 ICE_CLK_SRC_TCXO = 0, /* Temperature compensated oscillator */
|
| /linux-6.12.1/drivers/hwmon/ |
| D | sht15.c | 639 * This is the temperature compensated version as per section 4.2 of
|
12