Home
last modified time | relevance | path

Searched +full:bd71837 +full:- +full:pmic (Results 1 – 15 of 15) sorted by relevance

/linux-6.12.1/Documentation/devicetree/bindings/regulator/
Drohm,bd71837-regulator.yaml1 # SPDX-License-Identifier: GPL-2.0-only OR BSD-2-Clause
3 ---
4 $id: http://devicetree.org/schemas/regulator/rohm,bd71837-regulator.yaml#
5 $schema: http://devicetree.org/meta-schemas/core.yaml#
7 title: ROHM BD71837 Power Management Integrated Circuit regulators
10 - Matti Vaittinen <mazziesaccount@gmail.com>
13 List of regulators provided by this controller. BD71837 regulators node
14 should be sub node of the BD71837 MFD node. See BD71837 MFD bindings at
15 Documentation/devicetree/bindings/mfd/rohm,bd71837-pmic.yaml
20 Note that if BD71837 starts at RUN state you probably want to use
[all …]
Drohm,bd71847-regulator.yaml1 # SPDX-License-Identifier: GPL-2.0-only OR BSD-2-Clause
3 ---
4 $id: http://devicetree.org/schemas/regulator/rohm,bd71847-regulator.yaml#
5 $schema: http://devicetree.org/meta-schemas/core.yaml#
10 - Matti Vaittinen <mazziesaccount@gmail.com>
15 Documentation/devicetree/bindings/mfd/rohm,bd71847-pmic.yaml
21 regulator-boot-on at least for BUCK5. LDO6 is supplied by it and it must
23 voltage monitoring for LDO5/LDO6 can cause PMIC to reset.
30 "^LDO[1-6]$":
37 regulator-name:
[all …]
/linux-6.12.1/Documentation/devicetree/bindings/mfd/
Drohm,bd71837-pmic.yaml1 # SPDX-License-Identifier: GPL-2.0-only OR BSD-2-Clause
3 ---
4 $id: http://devicetree.org/schemas/mfd/rohm,bd71837-pmic.yaml#
5 $schema: http://devicetree.org/meta-schemas/core.yaml#
7 title: ROHM BD71837 Power Management Integrated Circuit
10 - Matti Vaittinen <mazziesaccount@gmail.com>
13 BD71837MWV is programmable Power Management ICs for powering single-core,
14 dual-core, and quad-core SoCs such as NXP-i.MX 8M. It is optimized for low
17 Datasheet for BD71837 is available at
18 …/www.rohm.com/products/power-management/power-management-ic-for-system/industrial-consumer-applica…
[all …]
/linux-6.12.1/drivers/mfd/
Drohm-bd718x7.c1 // SPDX-License-Identifier: GPL-2.0-or-later
5 // ROHM BD71837MWV and BD71847MWV PMIC driver
8 // https://www.rohm.com/datasheet/BD71837MWV/bd71837mwv-e
14 #include <linux/mfd/rohm-bd718x7.h>
23 .gpio = -1,
30 .name = "bd718xx-pwrkey",
35 .name = "gpio-keys",
39 { .name = "bd71837-clk", },
40 { .name = "bd71837-pmic", },
45 .name = "gpio-keys",
[all …]
DKconfig1 # SPDX-License-Identifier: GPL-2.0-only
57 tristate "Active-semi ACT8945A"
62 Support for the ACT8945A PMIC from Active-semi. This device
63 features three step-down DC/DC converters and four low-dropout
79 sun4i-gpadc-iio and the hwmon driver iio_hwmon.
82 called sun4i-gpadc.
91 Support for the AS3711 PMIC from AMS
113 tablets etc. It has 4 DC/DC step-down regulators, 3 DC/DC step-down
118 bool "Analog Devices ADP5520/01 MFD PMIC Core Support"
144 over at91-usart-serial driver and usart-spi-driver. Only one function
[all …]
Drohm-bd71828.c1 // SPDX-License-Identifier: GPL-2.0-only
5 // ROHM BD71828/BD71815 PMIC driver
14 #include <linux/mfd/rohm-bd71815.h>
15 #include <linux/mfd/rohm-bd71828.h>
16 #include <linux/mfd/rohm-generic.h>
24 .gpio = -1,
31 .name = "bd71828-pwrkey",
35 DEFINE_RES_IRQ_NAMED(BD71815_INT_RTC0, "bd71815-rtc-alm-0"),
36 DEFINE_RES_IRQ_NAMED(BD71815_INT_RTC1, "bd71815-rtc-alm-1"),
37 DEFINE_RES_IRQ_NAMED(BD71815_INT_RTC2, "bd71815-rtc-alm-2"),
[all …]
/linux-6.12.1/drivers/regulator/
Dbd718x7-regulator.c1 // SPDX-License-Identifier: GPL-2.0
3 // bd71837-regulator.c ROHM BD71837MWV/BD71847MWV regulator driver
10 #include <linux/mfd/rohm-bd718x7.h>
51 * controlled by software - or by PMIC internal HW state machine. Whether
52 * regulator should be under SW or HW control can be defined from device-tree.
98 * We assume PMIC is in RUN state because SW running and able to query the
100 * them we just return a constant. BD71837 BUCK3 and BUCK4 are exceptions as
103 * Note for next hacker - these PMICs have a register where the HW state can be
104 * read. If assuming RUN appears to be false in your use-case - you can
123 ret = regmap_read(rdev->regmap, rdev->desc->enable_reg, &val); in bd71837_get_buck34_enable_hwctrl()
[all …]
Drohm-regulator.c1 // SPDX-License-Identifier: GPL-2.0
5 #include <linux/mfd/rohm-generic.h>
21 if (ret != -EINVAL) in set_dvs_level()
35 return -EINVAL; in set_dvs_level()
37 for (i = 0; i < desc->n_voltages; i++) { in set_dvs_level()
38 /* NOTE to next hacker - Does not support pickable ranges */ in set_dvs_level()
39 if (desc->linear_range_selectors_bitfield) in set_dvs_level()
40 return -EINVAL; in set_dvs_level()
41 if (desc->n_linear_ranges) in set_dvs_level()
48 i <<= ffs(desc->vsel_mask) - 1; in set_dvs_level()
[all …]
DKconfig1 # SPDX-License-Identifier: GPL-2.0-only
38 managed regulators and simple non-configurable regulators.
64 the netlink mechanism. User-space applications can subscribe to these events
65 for real-time updates on various regulator events.
75 They provide two I2C-controlled DC/DC step-down converters with
101 tristate "Active-semi act8865 voltage regulator"
106 This driver controls a active-semi act8865 voltage output
110 tristate "Active-semi ACT8945A voltage regulator"
113 This driver controls a active-semi ACT8945A voltage regulator
114 via I2C bus. The ACT8945A features three step-down DC/DC converters
[all …]
/linux-6.12.1/arch/arm64/boot/dts/freescale/
Dimx8mq-pico-pi.dts1 // SPDX-License-Identifier: GPL-2.0+
9 /dts-v1/;
12 #include <dt-bindings/interrupt-controller/irq.h>
15 model = "TechNexion PICO-PI-8M";
16 compatible = "technexion,pico-pi-imx8m", "fsl,imx8mq";
19 stdout-path = &uart1;
22 pmic_osc: clock-pmic {
23 compatible = "fixed-clock";
24 #clock-cells = <0>;
25 clock-frequency = <32768>;
[all …]
Dimx8mq-phanbell.dts1 // SPDX-License-Identifier: (GPL-2.0 OR MIT)
3 * Copyright 2017-2019 NXP
6 /dts-v1/;
9 #include <dt-bindings/interrupt-controller/irq.h>
13 compatible = "google,imx8mq-phanbell", "fsl,imx8mq";
16 stdout-path = &uart1;
24 pmic_osc: clock-pmic {
25 compatible = "fixed-clock";
26 #clock-cells = <0>;
27 clock-frequency = <32768>;
[all …]
Dimx8mm-ucm-som.dtsi1 // SPDX-License-Identifier: (GPL-2.0+ OR MIT)
5 /dts-v1/;
8 #include <dt-bindings/leds/common.h>
18 stdout-path = &uart3;
22 compatible = "pwm-backlight";
24 brightness-levels = <0 255>;
25 num-interpolated-steps = <255>;
26 default-brightness-level = <222>;
31 compatible = "gpio-leds";
32 pinctrl-names = "default";
[all …]
Dimx8mq-librem5-devkit.dts1 // SPDX-License-Identifier: GPL-2.0+
3 * Copyright 2018-2019 Purism SPC
6 /dts-v1/;
8 #include "dt-bindings/input/input.h"
9 #include <dt-bindings/interrupt-controller/irq.h>
10 #include <dt-bindings/leds/common.h>
11 #include "dt-bindings/pwm/pwm.h"
12 #include "dt-bindings/usb/pd.h"
17 compatible = "purism,librem5-devkit", "fsl,imx8mq";
19 backlight_dsi: backlight-dsi {
[all …]
Dimx8mq-librem5.dtsi1 // SPDX-License-Identifier: GPL-2.0+
3 * Copyright 2018-2020 Purism SPC
6 /dts-v1/;
8 #include "dt-bindings/input/input.h"
9 #include <dt-bindings/interrupt-controller/irq.h>
10 #include <dt-bindings/leds/common.h>
11 #include "dt-bindings/pwm/pwm.h"
12 #include "dt-bindings/usb/pd.h"
18 chassis-type = "handset";
20 backlight_dsi: backlight-dsi {
[all …]
/linux-6.12.1/drivers/clk/
DKconfig1 # SPDX-License-Identifier: GPL-2.0
59 Low-Noise JESD204B Compliant Clock Jitter Cleaner With Dual Loop PLLs
88 These multi-function devices have two fixed-rate oscillators, clocked at 32KHz each.
97 This driver supports the hi655x PMIC clock. This
98 multi-function device has one fixed-rate oscillator, clocked
129 be pre-programmed to support other configurations and features not yet
178 This driver supports TI CDCE706 programmable 3-PLL clock synthesizer.
181 tristate "Clock Driver for TI TPS68470 PMIC"
186 This driver supports the clocks provided by the TPS68470 PMIC.
196 For example, the CDCE925 contains two PLLs with spread-spectrum
[all …]