Home
last modified time | relevance | path

Searched full:vmon (Results 1 – 25 of 51) sorted by relevance

123

/linux-6.12.1/drivers/regulator/
Dda9063-regulator.c88 struct reg_field vmon; member
154 struct regmap_field *vmon; member
225 return regmap_field_write(regl->vmon, enable ? 1 : 0); in da9063_set_xvp()
610 .vmon = BFIELD(DA9063_BB_REG_MON_REG_4, DA9063_BCORE1_MON_EN),
617 .vmon = BFIELD(DA9063_BB_REG_MON_REG_4, DA9063_BCORE2_MON_EN),
624 .vmon = BFIELD(DA9063_BB_REG_MON_REG_4, DA9063_BPRO_MON_EN),
631 .vmon = BFIELD(DA9063_BB_REG_MON_REG_4, DA9063_BMEM_MON_EN),
638 .vmon = BFIELD(DA9063_BB_REG_MON_REG_4, DA9063_BIO_MON_EN),
645 .vmon = BFIELD(DA9063_BB_REG_MON_REG_4, DA9063_BPERI_MON_EN),
653 .vmon = BFIELD(DA9063_BB_REG_MON_REG_4, DA9063_BCORE1_MON_EN),
[all …]
/linux-6.12.1/Documentation/devicetree/bindings/sound/
Dmaxim,max98925.yaml28 vmon-slot-no:
50 Interleave mode provides a means to output VMON and IMON data from two
68 vmon-slot-no:
95 vmon-slot-no = <1>;
Dcs35l32.txt29 0 = Left/right channels VMON[11:0], IMON[11:0], VPMON[7:0].
30 1 = Left/right channels VMON[11:0], IMON[11:0], STATUS.
31 2 = (Default) left/right channels VMON[15:0], IMON [15:0].
Dmax98373.txt13 - maxim,vmon-slot-no : slot number used to send voltage information
36 maxim,vmon-slot-no = <0>;
Dadi,max98388.yaml31 adi,vmon-slot-no:
74 adi,vmon-slot-no = <0>;
Dti,tas27xx.yaml48 ti,vmon-slot-no:
78 ti,vmon-slot-no = <2>;
Dti,tas2770.yaml47 ti,vmon-slot-no:
85 ti,vmon-slot-no = <2>;
Dcs35l35.txt125 - cirrus,vmon : 3 8 bit values to set the depth, location, and frame
126 of the VMON monitor signal.
174 cirrus,vmon = /bits/ 8 <0x03 0x00 0x00>;
Dadi,max98396.yaml42 adi,vmon-slot-no:
137 adi,vmon-slot-no = <0>;
Dcs35l36.txt49 - cirrus,vmon-pol-inv : Boolean to determine Amplifier will invert the
50 polarity of outbound VMON feedback data
/linux-6.12.1/Documentation/hwmon/
Dzl6100.rst214 in2_label "vmon"
215 in2_input Measured voltage on VMON (ZL2004) or VDRV (ZL9101M,
218 in2_lcrit Critical minimum VMON/VDRV Voltage.
219 in2_crit Critical maximum VMON/VDRV voltage.
220 in2_lcrit_alarm VMON/VDRV voltage critical low alarm.
221 in2_crit_alarm VMON/VDRV voltage critical high alarm.
223 vmon attributes are supported on ZL2004, ZL8802,
Disl68137.rst493 in2_label "vmon"
494 in2_input Scaled VMON voltage read from the VMON pin
538 in2_label "vmon"
539 in2_input Scaled VMON voltage read from the VMON pin
583 in2_label "vmon"
584 in2_input Scaled VMON voltage read from the VMON pin
/linux-6.12.1/sound/soc/codecs/
Dcs35l41.c264 "Zero", "ASPRX1", "ASPRX2", "VMON", "IMON",
564 SND_SOC_DAPM_SUPPLY("VMON", CS35L41_PWR_CTRL2, 12, 0, NULL, 0),
570 SND_SOC_DAPM_ADC("VMON ADC", NULL, SND_SOC_NOPM, 0, 0),
601 {"ASP TX1 Source", "VMON", "VMON ADC"},
609 {"ASP TX2 Source", "VMON", "VMON ADC"},
617 {"ASP TX3 Source", "VMON", "VMON ADC"},
625 {"ASP TX4 Source", "VMON", "VMON ADC"},
642 {"DSP1", NULL, "VMON"},
648 {"VMON ADC", NULL, "VMON"},
654 {"VMON ADC", NULL, "VSENSE"},
Dcs35l36.c604 "Zero Fill", "ASPRX1", "VMON", "IMON", "ERRVOL", "VPMON", "VBSTMON"
682 SND_SOC_DAPM_ADC("VMON ADC", NULL, CS35L36_PWR_CTRL2, 12, 0),
696 {"VMON ADC", NULL, "VSENSE"},
699 {"ASPTX1SRC", "VMON", "VMON ADC"},
704 {"ASPTX2SRC", "VMON", "VMON ADC"},
709 {"ASPTX3SRC", "VMON", "VMON ADC"},
714 {"ASPTX4SRC", "VMON", "VMON ADC"},
719 {"ASPTX5SRC", "VMON", "VMON ADC"},
724 {"ASPTX6SRC", "VMON", "VMON ADC"},
1477 "cirrus,vmon-pol-inv"); in cs35l36_handle_of_data()
Dtas2770.c167 SND_SOC_DAPM_SIGGEN("VMON"),
179 {"VSENSE", "Switch", "VMON"},
635 rc = fwnode_property_read_u32(dev->fwnode, "ti,vmon-slot-no", in tas2770_parse_dt()
639 "ti,vmon-slot-no"); in tas2770_parse_dt()
Dmax98926.c56 { 0x22, 0x00 }, /* DOUT Configuration VMON */
301 /* set VMON slots */ in max98926_set_sense_data()
535 if (!of_property_read_u32(i2c->dev.of_node, "vmon-slot-no", &value)) { in max98926_i2c_probe()
537 dev_err(&i2c->dev, "vmon slot number is wrong:\n"); in max98926_i2c_probe()
Dmax98373.c80 SND_SOC_DAPM_SIGGEN("VMON"),
316 { "VI Sense", "Switch", "VMON" },
377 /* Enable IMON VMON DC blocker */ in max98373_probe()
471 if (!device_property_read_u32(dev, "maxim,vmon-slot-no", &value)) in max98373_slot_config()
Dtas2562.c568 SND_SOC_DAPM_SIGGEN("VMON"),
581 {"VSENSE", "Switch", "VMON"},
705 ret = fwnode_property_read_u32(dev->fwnode, "ti,vmon-slot-no", in tas2562_parse_dt()
709 "ti,vmon-slot-no"); in tas2562_parse_dt()
Dmax98925.c59 { 0x22, 0x00 }, /* DOUT Configuration VMON */
277 /* set VMON slots */ in max98925_set_sense_data()
580 if (!of_property_read_u32(i2c->dev.of_node, "vmon-slot-no", &value)) { in max98925_i2c_probe()
582 dev_err(&i2c->dev, "vmon slot number is wrong:\n"); in max98925_i2c_probe()
Dcs35l45.c303 "VMON", "IMON", "ERR_VOL",
337 "VMON", "IMON", "ERR_VOL",
444 SND_SOC_DAPM_ADC("VMON", NULL, SND_SOC_NOPM, 0, 0),
489 { name" Source", "VMON", "VMON" }, \
509 { "VMON", NULL, "VMON_SRC" },
515 { "VMON", NULL, "VMON_EN" },
Dtas2780.c114 SND_SOC_DAPM_SIGGEN("VMON"),
125 {"VSENSE", "Switch", "VMON"},
583 ret = fwnode_property_read_u32(dev->fwnode, "ti,vmon-slot-no", in tas2780_parse_dt()
Dcs35l32.c131 SND_SOC_DAPM_SWITCH("VMON ADC", CS35L32_PWRCTL2, 7, 1, &vmon_ctl),
140 {"VMON ADC", NULL, "VSENSE"},
144 {"SDOUT", "Switch", "VMON ADC"},
Dcs35l33.c317 SND_SOC_DAPM_ADC("VMON", NULL,
336 {"VMON", NULL, "MON"},
339 {"SDOUT", NULL, "VMON"},
567 * scan tx_mask: vmon(2 slots); imon (2 slots); in cs35l33_set_tdm_slot()
589 dev_dbg(component->dev, "VMON enabled in slots %d-%d", in cs35l33_set_tdm_slot()
1057 "ERROR: VMON Overflow Interrupt\n"); in cs35l33_irq_thread()
/linux-6.12.1/arch/arm64/boot/dts/qcom/
Dsdm845-oneplus-enchilada.dts49 vmon-slot-no = <1>;
/linux-6.12.1/drivers/hwmon/pmbus/
Dzl6100.c339 * an extra voltage (VMON for ZL2004, ZL8802 and ZLS4009, in zl6100_probe()
340 * VDRV for ZL9101M and ZL9117M). Report it as vmon. in zl6100_probe()

123