Searched full:specifying (Results 1 – 25 of 632) sorted by relevance
12345678910>>...26
| /linux-6.12.1/Documentation/devicetree/bindings/mips/cavium/ |
| D | bootbus.txt | 32 - cavium,t-adr: A cell specifying the ADR timing (in nS).
34 - cavium,t-ce: A cell specifying the CE timing (in nS).
36 - cavium,t-oe: A cell specifying the OE timing (in nS).
38 - cavium,t-we: A cell specifying the WE timing (in nS).
40 - cavium,t-rd-hld: A cell specifying the RD_HLD timing (in nS).
42 - cavium,t-wr-hld: A cell specifying the WR_HLD timing (in nS).
44 - cavium,t-pause: A cell specifying the PAUSE timing (in nS).
46 - cavium,t-wait: A cell specifying the WAIT timing (in nS).
48 - cavium,t-page: A cell specifying the PAGE timing (in nS).
50 - cavium,t-rd-dly: A cell specifying the RD_DLY timing (in nS).
[all …]
|
| /linux-6.12.1/Documentation/ABI/stable/ |
| D | sysfs-driver-ib_srp | 10 * id_ext, a 16-digit hexadecimal number specifying the eight
14 * ioc_guid, a 16-digit hexadecimal number specifying the eight
17 * dgid, a 32-digit hexadecimal number specifying the
19 * pkey, a four-digit hexadecimal number specifying the
21 * service_id, a 16-digit hexadecimal number specifying the
25 * max_sect, a decimal number specifying the maximum number of
27 * max_cmd_per_lun, a decimal number specifying the maximum
29 * io_class, a hexadecimal number specifying the SRP I/O class.
33 * initiator_ext, a 16-digit hexadecimal number specifying the
53 * sg_tablesize, a number in the range 1..2048 specifying the
[all …]
|
| /linux-6.12.1/drivers/staging/vc04_services/vchiq-mmal/ |
| D | mmal-msg-format.h | 39 * FourCC specifying the color space of the video stream. See the
60 u32 encoding; /* FourCC specifying encoding of the elementary
63 u32 encoding_variant; /* FourCC specifying the specific
86 u32 encoding; /* FourCC specifying encoding of the elementary
89 u32 encoding_variant; /* FourCC specifying the specific
|
| /linux-6.12.1/drivers/pinctrl/qcom/ |
| D | pinctrl-msm.h | 49 * @intr_target_reg: Offset of the register specifying routing of the interrupts
61 * @intr_wakeup_present_bit: Offset in @intr_target_reg specifying the GPIO can generate
65 * @intr_target_width: Number of bits used for specifying interrupt routing target.
66 * @intr_target_kpss_val: Value in @intr_target_bit for specifying that the interrupt from
69 * @intr_polarity_bit: Offset in @intr_cfg_reg for specifying polarity of the interrupt.
70 * @intr_detection_bit: Offset in @intr_cfg_reg for specifying interrupt type.
71 * @intr_detection_width: Number of bits used for specifying interrupt type,
|
| /linux-6.12.1/Documentation/ABI/testing/ |
| D | configfs-usb-gadget-mass-storage | 25 ro Flag specifying access to the LUN shall be
29 removable Flag specifying that LUN shall be indicated as
31 cdrom Flag specifying that LUN shall be reported as
33 nofua Flag specifying that FUA flag
|
| D | sysfs-memory-page-offline | 7 written into this file. Input is a hex number specifying the
30 specifying the physical address of the page. The
|
| D | configfs-tsm | 104 Specifying the service provider via this attribute will create
121 Specifying an empty/null GUID (00000000-0000-0000-0000-000000)
123 part of the attestation report. Specifying a GUID request
|
| /linux-6.12.1/Documentation/devicetree/bindings/clock/ |
| D | st,stm32-rcc.txt | 21 between gated clocks and other clocks and an index specifying the clock to
37 Specifying gated clocks
67 Specifying other clocks
121 Specifying softreset control of devices
125 property, containing a phandle to the reset device node and an index specifying
|
| D | st,stm32mp1-rcc.yaml | 20 Specifying clocks
27 Specifying softreset control of devices
31 property, containing a phandle to the reset device node and an index specifying
|
| D | st,stm32h7-rcc.txt | 53 Specifying softreset control of devices
57 property, containing a phandle to the reset device node and an index specifying
|
| /linux-6.12.1/Documentation/devicetree/bindings/watchdog/ |
| D | aspeed,ast2400-wdt.yaml | 41 Specifying 'cpu' will only reset the processor on a timeout event.
43 Specifying 'soc' will reset a configurable subset of the SoC's controllers
49 Specifying 'system' will reset all controllers on a timeout event, as if
52 Specifying 'none' will cause the timeout event to have no reset effect.
|
| /linux-6.12.1/Documentation/devicetree/bindings/pwm/ |
| D | pwm.txt | 1 Specifying PWM information for devices
13 pwm-specifier : array of #pwm-cells specifying the given PWM
40 Note that in the example above, specifying the "pwm-names" is redundant
|
| /linux-6.12.1/Documentation/devicetree/bindings/dma/stm32/ |
| D | st,stm32-mdma.yaml | 21 3. A 32bit mask specifying the DMA channel configuration
47 4. A 32bit value specifying the register to be used to acknowledge the request
49 5. A 32bit mask specifying the value to be written to acknowledge the request
|
| /linux-6.12.1/Documentation/devicetree/bindings/gpio/ |
| D | gpio.txt | 1 Specifying GPIO information for devices
46 Most controllers are specifying a generic flag bitfield in the last cell, so
180 you have chosen, and specifying from where the names are derived.
208 - gpio-hog: A property specifying that this child node represents a GPIO hog.
216 - input: A property specifying to set the GPIO direction as input.
217 - output-low A property specifying to set the GPIO direction as output with
219 - output-high A property specifying to set the GPIO direction as output with
|
| /linux-6.12.1/Documentation/devicetree/bindings/media/ |
| D | samsung,exynos4210-fimc.yaml | 15 fimc<n>, where <n> is an integer specifying the IP block instance.
80 An array specifying minimum image size in pixels at the FIMC input and
100 A bitmask specifying whether this IP has the input and the output
|
| /linux-6.12.1/Documentation/trace/ |
| D | hisi-ptt.rst | 139 set the filter by specifying the `filter` parameter which is required to start
158 Endpoint function can be specified in one trace. Specifying both Root Port
169 You can trace the TLP headers of certain types by specifying the `type`
184 to the Root Port or the PCIe core, by specifying the `direction` parameter.
210 You can change the format of the traced TLP headers by specifying the
275 adjust the size by specifying the `-m` parameter of the perf command.
|
| /linux-6.12.1/Documentation/devicetree/bindings/reset/ |
| D | st,sti-softreset.txt | 29 Specifying softreset control of devices
34 index specifying which channel to use, as described in reset.txt
|
| D | img,pistachio-reset.txt | 37 Specifying reset control of devices
42 index specifying which reset to use, as described in
|
| /linux-6.12.1/kernel/dma/ |
| D | Kconfig | 168 You can disable CMA by specifying "cma=0" on the kernel's command
183 You can set the size of pernuma CMA by specifying "cma_pernuma=size"
184 or set the node id and its size of CMA by specifying "numa_cma=
|
| /linux-6.12.1/Documentation/arch/arm64/ |
| D | pointer-authentication.rst | 64 specifies which keys are to be reinitialized; specifying 0 means "all
117 and PR_PAC_APDBKEY specifying which keys shall be affected by this prctl,
118 and the second being a bitmask of the same bits specifying whether the key
|
| /linux-6.12.1/Documentation/devicetree/bindings/pinctrl/ |
| D | qcom,tlmm-common.yaml | 35 Specifying the pin number and flags, as defined in
44 Specifying the interrupt-controller used to wake up the system when the
|
| /linux-6.12.1/Documentation/devicetree/bindings/powerpc/fsl/ |
| D | raideng.txt | 16 - ranges: standard ranges property specifying the translation
36 - ranges: standard ranges property specifying the translation
|
| /linux-6.12.1/arch/powerpc/include/asm/ |
| D | drmem.h | 56 * The property itself is a 32-bit value specifying the number of
70 * 32-bit value specifying the number of LMB sets followed by an
|
| /linux-6.12.1/Documentation/arch/x86/x86_64/ |
| D | 5level-paging.rst | 46 specifying hint address (with or without MAP_FIXED) above 47-bits.
56 Specifying high hint address on older kernel or on machine without 5-level
|
| /linux-6.12.1/Documentation/devicetree/bindings/phy/ |
| D | phy-miphy365x.txt | 11 an entry for each port sub-node, specifying the control
63 Specifying phy control of devices
|
12345678910>>...26