| /linux-6.12.1/include/dt-bindings/regulator/ |
| D | qcom,rpmh-regulator.h | 14 * by LDO and SMPS type regulators.
16 * allowed. This mode corresponds to PFM for SMPS
27 * corresponds to PWM for SMPS and BOB type
|
| /linux-6.12.1/Documentation/devicetree/bindings/regulator/ |
| D | palmas-pmic.txt | 36 smps45, smps457, smps7 depending on variant, smps6, smps[8-9],
50 ti,smps-range - OTP has the wrong range set for the hardware so override
80 ti,smps-range = <1>;
|
| D | qcom,rpmh-regulator.yaml | 22 It is used for clock buffers, low-voltage switches, and LDO/SMPS regulators
124 "^(smps|ldo|lvs|bob)[0-9]+$":
128 description: smps/ldo regulator nodes(s).
|
| D | qcom,rpm-regulator.yaml | 90 # based on realtime current draw, only for pm8921 smps and ftsmps
|
| /linux-6.12.1/net/mac80211/ |
| D | ht.c | 509 ieee80211_smps_mode_to_smps_mode(enum ieee80211_smps_mode smps) in ieee80211_smps_mode_to_smps_mode() argument
511 switch (smps) { in ieee80211_smps_mode_to_smps_mode()
524 enum ieee80211_smps_mode smps, const u8 *da, in ieee80211_send_smps_action() argument
533 /* 27 = header + category + action + smps mode */ in ieee80211_send_smps_action()
547 switch (smps) { in ieee80211_send_smps_action()
551 smps = IEEE80211_SMPS_OFF; in ieee80211_send_smps_action()
570 /* we have 13 bits, and need 6: link_id 4, smps 2 */ in ieee80211_send_smps_action()
572 u16_encode_bits(status_link_id << 2 | smps, in ieee80211_send_smps_action()
|
| /linux-6.12.1/arch/arm/boot/dts/nxp/imx/ |
| D | imx7d-flex-concentrator.dts | 100 * ADC1_IN0: SMPS - 5V output monitor (voltage divider: 1/0.2806)
176 * SMPS - AC input monitor based on zero crossing.
181 "", "", "", "", "smps-ac-monitor", "", "usb-hub-reset", "",
258 /* SMPS - AC input monitor (high = failure) */
|
| /linux-6.12.1/Documentation/devicetree/bindings/mfd/ |
| D | stericsson,db8500-prcmu.yaml | 97 for 1.2V I/O. SMPS means System Management Power Source.
104 for 1.8V I/O. SMPS means System Management Power Source.
111 for 0.87 thru 1.875V I/O. SMPS means System Management Power Source.
|
| /linux-6.12.1/drivers/net/wireless/intel/iwlwifi/fw/api/ |
| D | datapath.h | 111 * @THERMAL_DUAL_CHAIN_REQUEST: firmware request for SMPS mode,
399 * enum iwl_thermal_dual_chain_req_events - firmware SMPS request event
403 * (static SMPS)
411 * struct iwl_thermal_dual_chain_request - SMPS request
|
| /linux-6.12.1/drivers/net/wireless/intel/iwlwifi/mvm/ |
| D | utils.c | 272 * iwl_mvm_update_smps - Get a request to change the SMPS mode
276 * @smps_request: The request to change the SMPS mode.
279 * Get a requst to change the SMPS mode,
293 /* SMPS is irrelevant for NICs that don't have at least 2 RX antenna */ in iwl_mvm_update_smps()
300 /* SMPS is handled by firmware */ in iwl_mvm_update_smps()
321 /* SMPS is disabled in eSR */ in iwl_mvm_update_smps()
|
| /linux-6.12.1/drivers/net/wireless/intel/iwlwifi/dvm/ |
| D | lib.c | 441 priv->current_ht_config.smps = smps_request; in iwlagn_bt_traffic_change_work()
697 return priv->current_ht_config.smps == IEEE80211_SMPS_STATIC || in is_single_rx_stream()
741 /* # Rx chains when idling, depending on SMPS mode */ in iwl_get_idle_rx_chain_count()
742 switch (priv->current_ht_config.smps) { in iwl_get_idle_rx_chain_count()
750 WARN(1, "invalid SMPS mode %d", in iwl_get_idle_rx_chain_count()
751 priv->current_ht_config.smps); in iwl_get_idle_rx_chain_count()
|
| /linux-6.12.1/arch/hexagon/mm/ |
| D | vm_tlb.c | 22 * or it's a no-op. This operation is messy on true SMPs where other
|
| /linux-6.12.1/drivers/net/wireless/intel/iwlwifi/ |
| D | iwl-config.h | 179 * @dynamic_smps_entry: Dynamic SMPS entry threshold
180 * @dynamic_smps_exit: Dynamic SMPS exit threshold
185 * @support_dynamic_smps: Support dynamic SMPS?
|
| /linux-6.12.1/drivers/regulator/ |
| D | palmas-regulator.c | 689 * setup the hardware based sleep configuration of the SMPS/LDO regulators
1222 * ranges. Read the current smps mode for later use. in palmas_smps_registration()
1246 /* Read the smps mode for later use. */ in palmas_smps_registration()
1327 * ranges. Read the current smps mode for later use. in tps65917_smps_registration()
1352 /* Read the smps mode for later use. */ in tps65917_smps_registration()
1540 ret = of_property_read_bool(np, "ti,smps-range"); in palmas_dt_to_pdata()
|
| D | twl6030-regulator.c | 74 /* Flags for SMPS Voltage reading and LDO reading*/
79 /* twl6032 SMPS EPROM values */
309 * SMPS status and control
|
| /linux-6.12.1/drivers/net/wireless/ath/ath12k/ |
| D | mac.c | 2336 int *smps) in ath12k_get_smps_from_capa() argument
2339 *smps = u16_get_bits(ht_cap->cap, IEEE80211_HT_CAP_SM_PS); in ath12k_get_smps_from_capa()
2341 *smps = le16_get_bits(he_6ghz_capa->capa, in ath12k_get_smps_from_capa()
2344 if (*smps >= ARRAY_SIZE(ath12k_smps_map)) in ath12k_get_smps_from_capa()
2355 int smps; in ath12k_peer_assoc_h_smps() local
2360 if (ath12k_get_smps_from_capa(ht_cap, he_6ghz_capa, &smps)) in ath12k_peer_assoc_h_smps()
2363 switch (smps) { in ath12k_peer_assoc_h_smps()
2837 int smps, ret = 0; in ath12k_setup_peer_smps() local
2842 ret = ath12k_get_smps_from_capa(ht_cap, he_6ghz_capa, &smps); in ath12k_setup_peer_smps()
2848 ath12k_smps_map[smps]); in ath12k_setup_peer_smps()
[all …]
|
| /linux-6.12.1/drivers/infiniband/hw/hfi1/ |
| D | ud.c | 710 * checks for SMPs specified in OPAv1 rev 1.0, 9/19/2016 update, section
717 * - These checks are specifically for "non-local" SMPs (i.e., SMPs
718 * which originated on another node). SMPs which are sent from, and
753 * SMPs fall into one of four (disjoint) categories: in opa_smp_check()
|
| /linux-6.12.1/drivers/input/misc/ |
| D | pmic8xxx-pwrkey.c | 153 * Set an SMPS regulator to be disabled in its CTRL register, but enabled
287 /* Disable SMPS's 0,1,3 locally and set pulldown enable bits. */ in pm8058_pwrkey_shutdown()
|
| /linux-6.12.1/drivers/net/wireless/ath/ath11k/ |
| D | mac.c | 2636 int smps; in ath11k_peer_assoc_h_smps() local
2642 smps = ht_cap->cap & IEEE80211_HT_CAP_SM_PS; in ath11k_peer_assoc_h_smps()
2643 smps >>= IEEE80211_HT_CAP_SM_PS_SHIFT; in ath11k_peer_assoc_h_smps()
2645 smps = le16_get_bits(sta->deflink.he_6ghz_capa.capa, in ath11k_peer_assoc_h_smps()
2649 switch (smps) { in ath11k_peer_assoc_h_smps()
2944 int smps; in ath11k_setup_peer_smps() local
2950 smps = ht_cap->cap & IEEE80211_HT_CAP_SM_PS; in ath11k_setup_peer_smps()
2951 smps >>= IEEE80211_HT_CAP_SM_PS_SHIFT; in ath11k_setup_peer_smps()
2953 smps = FIELD_GET(IEEE80211_HE_6GHZ_CAP_SM_PS, he_6ghz_capa); in ath11k_setup_peer_smps()
2956 if (smps >= ARRAY_SIZE(ath11k_smps_map)) in ath11k_setup_peer_smps()
[all …]
|
| /linux-6.12.1/drivers/net/wireless/realtek/rtlwifi/ |
| D | base.h | 123 enum ieee80211_smps_mode smps);
|
| /linux-6.12.1/arch/arm/boot/dts/qcom/ |
| D | qcom-apq8064-cm-qs600.dts | 109 /* Buck SMPS */
|
| D | qcom-mdm9615-wp8548.dtsi | 147 /* Buck SMPS */
|
| /linux-6.12.1/drivers/net/wireless/ath/ath10k/ |
| D | mac.c | 2823 int smps; in ath10k_setup_peer_smps() local
2828 smps = ht_cap->cap & IEEE80211_HT_CAP_SM_PS; in ath10k_setup_peer_smps()
2829 smps >>= IEEE80211_HT_CAP_SM_PS_SHIFT; in ath10k_setup_peer_smps()
2831 if (smps >= ARRAY_SIZE(ath10k_smps_map)) in ath10k_setup_peer_smps()
2836 ath10k_smps_map[smps]); in ath10k_setup_peer_smps()
3109 ath10k_warn(ar, "failed to setup peer SMPS for vdev %i: %d\n", in ath10k_bss_assoc()
3288 ath10k_warn(ar, "failed to setup peer SMPS for vdev %d: %d\n", in ath10k_station_assoc()
4943 u32 smps; in ath10k_get_ht_cap() local
4945 smps = WLAN_HT_CAP_SM_PS_DYNAMIC; in ath10k_get_ht_cap()
4946 smps <<= IEEE80211_HT_CAP_SM_PS_SHIFT; in ath10k_get_ht_cap()
[all …]
|
| /linux-6.12.1/drivers/gpu/drm/panel/ |
| D | panel-widechips-ws2401.c | 26 #define WS2401_PSMPS 0xbd /* SMPS positive control */
27 #define WS2401_NSMPS 0xbe /* SMPS negative control */
|
| /linux-6.12.1/drivers/net/wireless/mediatek/mt76/mt7603/ |
| D | mt7603.h | 80 u8 smps; member
|
| /linux-6.12.1/Documentation/driver-api/80211/ |
| D | mac80211-advanced.rst | 150 Spatial Multiplexing Powersave (SMPS)
|