Searched full:mx53 (Results 1 – 25 of 32) sorted by relevance
12
| /linux-6.12.1/Documentation/devicetree/bindings/display/imx/ |
| D | ldb.txt | 16 - gpr : should be <&gpr> on i.MX53 and i.MX6q.
22 The following clocks are expected on i.MX53:
37 - pinctrl-names : should be "default" on i.MX53, not used on i.MX6q
38 - pinctrl-0 : a phandle pointing to LVDS pin settings on i.MX53,
|
| /linux-6.12.1/drivers/gpu/drm/imx/ipuv3/ |
| D | Kconfig | 25 found on i.MX53 processors.
34 found on i.MX53 and i.MX6 processors.
|
| D | imx-ldb.c | 650 * i.MX53: ipu1_di0_sel, ipu1_di1_sel in imx_ldb_probe()
|
| /linux-6.12.1/arch/arm/mach-imx/ |
| D | Kconfig | 115 bool "i.MX53 support"
120 This enables support for Freescale i.MX53 processor.
|
| D | mach-imx53.c | 34 DT_MACHINE_START(IMX53_DT, "Freescale i.MX53 (Device Tree Support)")
|
| D | hardware.h | 73 * mx53:
|
| D | pm-imx5.c | 142 * mx5 because it can be used for mx51, and mx53.
|
| /linux-6.12.1/Documentation/devicetree/bindings/rtc/ |
| D | rtc-mxc_v2.yaml | 7 title: i.MX53 Secure Real Time Clock (SRTC)
|
| /linux-6.12.1/Documentation/devicetree/bindings/nvmem/ |
| D | imx-iim.yaml | 16 i.MX25, i.MX27, i.MX31, i.MX35, i.MX51 and i.MX53 SoCs.
|
| /linux-6.12.1/Documentation/networking/device_drivers/can/freescale/ |
| D | flexcan.rst | 19 and i.MX53 SOCs) only receive RTR frames if the controller is
|
| /linux-6.12.1/arch/arm/boot/dts/nxp/imx/ |
| D | imx53-qsb.dts | 10 model = "Freescale i.MX53 Quick Start Board";
|
| D | imx53-qsrb.dts | 11 model = "Freescale i.MX53 Quick Start-R Board";
|
| D | imx53-ard.dts | 12 model = "Freescale i.MX53 Automotive Reference Design Board";
|
| D | imx53-usbarmory.dts | 79 * Not every i.MX53 P/N supports clock > 800MHz.
|
| D | imx53-voipac-dmm-668.dtsi | 9 model = "Voipac i.MX53 X53-DMM-668";
|
| D | imx53-smd.dts | 11 model = "Freescale i.MX53 Smart Mobile Reference Design Board";
|
| /linux-6.12.1/drivers/rtc/ |
| D | rtc-mxc_v2.c | 3 * Real Time Clock (RTC) Driver for i.MX53
390 MODULE_DESCRIPTION("Real Time Clock (RTC) Driver for i.MX53");
|
| D | Kconfig | 1804 tristate "Freescale MXC Real Time Clock for i.MX53"
1810 SRTC module in i.MX53 processor.
|
| /linux-6.12.1/drivers/net/can/flexcan/ |
| D | flexcan.h | 28 * MX53 FlexCAN2 03.00.00.00 yes no no no no no 64
|
| /linux-6.12.1/drivers/soc/imx/ |
| D | soc-imx.c | 83 soc_id = "i.MX53"; in imx_soc_device_init()
|
| /linux-6.12.1/Documentation/devicetree/bindings/arm/ |
| D | fsl.yaml | 220 - description: i.MX53 based Boards
227 - fsl,imx53-qsrb # Freescale i.MX53 Quick Start-R Board
234 - menlo,m53menlo # i.MX53 Menlo board
236 - voipac,imx53-dmm-668 # Voipac i.MX53 X53-DMM-668
239 - description: i.MX53 based Aries/DENX M53EVK Board
245 - description: i.MX53 based TQ MBa53 Board
|
| /linux-6.12.1/drivers/gpu/ipu-v3/ |
| D | ipu-di.c | 360 /* PIN4: HSYNC for VGA via TVEv2 on i.MX53-QSB */ in ipu_di_sync_config_noninterlaced()
369 /* PIN6: VSYNC for VGA via TVEv2 on i.MX53-QSB */ in ipu_di_sync_config_noninterlaced()
|
| /linux-6.12.1/drivers/clk/imx/ |
| D | clk-imx5.c | 305 * it comes closest in scope to the main_bus_clk of i.MX51 and i.MX53 in mx50_clocks_init()
606 imx_print_silicon_rev("i.MX53", mx53_revision()); in mx53_clocks_init()
|
| /linux-6.12.1/arch/arm/ |
| D | Kconfig.debug | 467 bool "i.MX53 Debug UART"
471 on i.MX53.
|
| /linux-6.12.1/drivers/ata/ |
| D | ahci_imx.c | 961 * TIMER1MS register on i.MX53, i.MX6Q and i.MX6QP only. in imx_ahci_probe()
|
12