Home
last modified time | relevance | path

Searched full:ib1 (Results 1 – 21 of 21) sorted by relevance

/linux-6.12.1/drivers/net/ethernet/mediatek/
Dmtk_ppe.c149 switch (mtk_get_ib1_pkt_type(eth, e->ib1)) { in mtk_ppe_hash_entry()
187 int type = mtk_get_ib1_pkt_type(eth, entry->ib1); in mtk_foe_entry_l2()
201 int type = mtk_get_ib1_pkt_type(eth, entry->ib1); in mtk_foe_entry_ib2()
226 entry->ib1 = val; in mtk_foe_entry_prepare()
237 entry->ib1 = val; in mtk_foe_entry_prepare()
302 int type = mtk_get_ib1_pkt_type(eth, entry->ib1); in mtk_foe_entry_set_ipv4_tuple()
342 int type = mtk_get_ib1_pkt_type(eth, entry->ib1); in mtk_foe_entry_set_ipv6_tuple()
377 if (!(entry->ib1 & mtk_get_ib1_vlan_layer_mask(eth))) in mtk_foe_entry_set_dsa()
378 entry->ib1 |= mtk_prep_ib1_vlan_layer(eth, 1); in mtk_foe_entry_set_dsa()
382 entry->ib1 &= ~mtk_get_ib1_vlan_tag_mask(eth); in mtk_foe_entry_set_dsa()
[all …]
Dmtk_ppe_debugfs.c93 state = FIELD_GET(MTK_FOE_IB1_STATE, entry->ib1); in mtk_ppe_debugfs_foe_show()
102 type = mtk_get_ib1_pkt_type(ppe->eth, entry->ib1); in mtk_ppe_debugfs_foe_show()
160 " vlan=%d,%d ib1=%08x ib2=%08x" in mtk_ppe_debugfs_foe_show()
163 l2->vlan1, l2->vlan2, entry->ib1, ib2, in mtk_ppe_debugfs_foe_show()
Dmtk_ppe.h240 u32 ib1; member
/linux-6.12.1/drivers/gpu/drm/panel/
Dpanel-arm-versatile.c10 * named "IB1" or "IB2" (Interface Board 1 & 2 respectively.) They
14 * - The IB1 is a passive board where the display connector defines a
128 * found on the Versatile AB IB1 connector or the Versatile
151 * found on the Versatile AB IB1 connector or the Versatile
/linux-6.12.1/Documentation/devicetree/bindings/arm/
Darm,versatile.yaml32 to an IB1 interface board for a touchscreen-type use case or an IB2
/linux-6.12.1/drivers/gpu/drm/amd/include/ivsrcid/gfx/
Dirqsrcs_gfx_10_1.h29 #define GFX_10_1__SRCID__CP_IB1_INTERRUPT_PKT 177 // B1 CP_INTERRUPT pkt in IB1
Dirqsrcs_gfx_9_0.h31 #define GFX_9_0__SRCID__CP_IB1_INTERRUPT_PKT 177 /* B1 CP_INTERRUPT pkt in IB1 */
/linux-6.12.1/drivers/gpu/drm/msm/
DKconfig52 that are run from RB instead of IB1. This essentially gives
/linux-6.12.1/drivers/infiniband/hw/qib/
Dqib_sd7220.c523 * RxEq and DDS in tables used by IBC in IB1.2 mode in qib_sd7220_init()
956 * Set the "negotiation" values for SERDES. These are used by the IB1.2
1187 * Set the Tx values normally modified by IBC in IB1.2 mode to default
1210 * Set the Rx values normally modified by IBC in IB1.2 mode to default
Dqib.h282 #define QIB_IB_CFG_LINKLATENCY 8 /* Link Latency (IB1.2 only) */
Dqib_iba7322.c2952 * only works for single port if IB1 != pidx1 in unknown_7322_gpio_intr()
8332 /* used for IB1 or IB2, only one in use */
8344 /* used when both IB1 and IB2 are in use */
8356 /* used when only IB1 is in use */
8380 /* used when both IB1 and IB2 are in use */
Dqib_iba7220.c2451 * If we turn off IB1.2, need to preset SerDes defaults, in qib_7220_set_ib_cfg()
3491 * Required for older non-IB1.2 DDR switches. Newer in try_7220_autoneg()
/linux-6.12.1/drivers/gpu/drm/msm/registers/adreno/
Dadreno_common.xml144 <bitfield name="IB1" low="8" high="14" type="uint"/>
Dadreno_pm4.xml610 to loop any sequence of IB1 commands, but in practice they are
612 prefix, used to set per-bin state, and then the following IB1
2143 executed in an IB2 before the IB1 commands following
Da6xx.xml13 roughly corresponds to registers used in ib1 for Freedreno
18 the start of the command buffer (ib1), while "rp_blit" usage indicates that register
2320 b16..23 identifies where IB1 data starts (and RB data ends)
2321 b24..31 identifies where IB2 data starts (and IB1 data ends)
/linux-6.12.1/drivers/gpu/drm/msm/adreno/
Da3xx_gpu.c342 /* CP ROQ queue sizes (bytes) - RB:16, ST:16, IB1:32, IB2:64 */ in a3xx_hw_init()
Da5xx_gpu.c1245 …DRM_DEV_ERROR(dev->dev, "gpu fault ring %d fence %x status %8.8X rb %4.4x/%4.4x ib1 %16.16llX/%4.4… in a5xx_fault_detect_irq()
Da6xx_gpu.c1499 …"gpu fault ring %d fence %x status %8.8X rb %4.4x/%4.4x ib1 %16.16llX/%4.4x ib2 %16.16llX/%4.4x\n", in a6xx_fault_detect_irq()
/linux-6.12.1/drivers/gpu/drm/radeon/
Dr600.c4083 * 177 - CP_INT IB1
4288 case 177: /* CP_INT in IB1 */ in r600_irq_process()
Devergreen.c4858 case 177: /* CP_INT in IB1 */ in evergreen_irq_process()
/linux-6.12.1/drivers/infiniband/hw/hfi1/
Dhfi.h556 #define HFI1_IB_CFG_LINKLATENCY 8 /* Link Latency (IB1.2 only) */