| /linux-6.12.1/drivers/zorro/ |
| D | zorro.ids | 18 0000 Golem RAM Box 2MB [RAM Expansion]
22 1300 Warp Engine [Accelerator, SCSI Host Adapter and RAM Expansion]
24 0200 Megamix 2000 [RAM Expansion]
36 0a00 A590/A2052/A2058/A2091 [RAM Expansion]
37 2000 A560 [RAM Expansion]
40 5000 A2620 68020 [Accelerator and RAM Expansion]
41 5100 A2630 68030 [Accelerator and RAM Expansion]
45 6100 A3000 Test Fixture [Miscellaneous Expansion Card]
51 0200 EXP8000 [RAM Expansion]
64 0100 AX2000 [RAM Expansion]
[all …]
|
| /linux-6.12.1/Documentation/devicetree/bindings/memory-controllers/ |
| D | intel,ixp4xx-expansion-bus-controller.yaml | 4 $id: http://devicetree.org/schemas/memory-controllers/intel,ixp4xx-expansion-bus-controller.yaml#
7 title: Intel IXP4xx Expansion Bus Controller
10 The IXP4xx expansion bus controller handles access to devices on the
11 memory-mapped expansion bus on the Intel IXP4xx family of system on chips,
24 - intel,ixp42x-expansion-bus-controller
25 - intel,ixp43x-expansion-bus-controller
26 - intel,ixp45x-expansion-bus-controller
27 - intel,ixp46x-expansion-bus-controller
31 description: Control registers for the expansion bus, these are not
32 inside the memory range handled by the expansion bus.
[all …]
|
| D | intel,ixp4xx-expansion-peripheral-props.yaml | 4 $id: http://devicetree.org/schemas/memory-controllers/intel,ixp4xx-expansion-peripheral-props.yaml#
7 title: Peripheral properties for Intel IXP4xx Expansion Bus
10 The IXP4xx expansion bus controller handles access to devices on the
11 memory-mapped expansion bus on the Intel IXP4xx family of system on chips,
44 description: The type of cycles to use on the expansion bus for this
75 description: Expansion bus uses only 8 bits. The default is to use
|
| /linux-6.12.1/arch/arm/boot/dts/intel/socfpga/ |
| D | socfpga_cyclone5_chameleon96.dts | 73 /* On Low speed expansion */
79 /* On Low speed expansion */
89 /* On High speed expansion */
101 /* On High speed expansion */
107 /* On Low speed expansion */
113 /* On Low speed expansion */
119 /* On Low speed expansion */
|
| /linux-6.12.1/arch/mips/include/uapi/asm/ |
| D | stat.h | 54 unsigned long st_pad0[3]; /* Reserved for st_dev expansion */
65 unsigned long st_pad1[3]; /* Reserved for st_rdev expansion */
74 unsigned long st_atime_nsec; /* Reserved for st_atime expansion */
77 unsigned long st_mtime_nsec; /* Reserved for st_mtime expansion */
80 unsigned long st_ctime_nsec; /* Reserved for st_ctime expansion */
95 unsigned int st_pad0[3]; /* Reserved for st_dev expansion */
106 unsigned int st_pad1[3]; /* Reserved for st_rdev expansion */
|
| /linux-6.12.1/arch/mips/include/asm/mach-loongson2ef/cs5536/ |
| D | cs5536_pci.h | 36 /********** STANDARD PCI-2.2 EXPANSION ****************/
99 /* EXPANSION ROM BAR */
115 /*********** EXPANSION PCI REG ************************/
118 * ISA EXPANSION
125 * IDE EXPANSION
136 * ACC EXPANSION
141 * OHCI EXPANSION : INTTERUPT IS IMPLEMENTED BY THE OHCI
147 * EHCI EXPANSION
|
| /linux-6.12.1/arch/arm64/boot/dts/marvell/ |
| D | armada-8040-db.dts | 104 /* CON6 on CP0 expansion */
111 /* CON5 on CP0 expansion */
142 /* CON4 on CP0 expansion */
156 /* CON9 on CP0 expansion */
176 /* CON10 on CP0 expansion */
212 /* CON6 on CP1 expansion */
219 /* CON7 on CP1 expansion */
226 /* CON5 on CP1 expansion */
303 /* CON4 on CP1 expansion */
321 /* CON9 on CP1 expansion */
[all …]
|
| /linux-6.12.1/arch/arm/boot/dts/st/ |
| D | stih410-b2260.dts | 94 /* Low speed expansion connector */
105 /* Low speed expansion connector */
111 /* Low speed expansion connector */
118 /* Low speed expansion connector */
124 /* Low speed expansion connector */
130 /* high speed expansion connector */
137 /* high speed expansion connector */
150 /* high speed expansion connector */
|
| D | stm32mp135f-dhcor-dhsbc.dts | 69 /* Expansion connector: INP12:pin29 */
231 &i2c1 { /* Expansion connector: SDA:pin27 SCL:pin28 */
244 &i2c5 { /* Expansion connector: SDA:pin3 SCL:pin5 */
257 &m_can1 { /* Expansion connector: TX:pin16 RX:pin18 */
264 &m_can2 { /* Expansion connector: TX:pin22 RX:pin26 */
277 &sai1 { /* Expansion connector: SCK-A:pin12 FS-A:pin35 SD-A:pin38 SD-B:pin40 */
303 &spi3 { /* Expansion connector: MOSI:pin19 MISO:pin21 SCK:pin22 nCS:pin24 */
311 &timers5 { /* Expansion connector: CH3:pin31 */
327 &timers13 { /* Expansion connector: CH1:pin32 */
343 &usart1 { /* Expansion connector: RX:pin33 TX:pin37 */
[all …]
|
| /linux-6.12.1/Documentation/devicetree/bindings/ata/ |
| D | intel,ixp4xx-compact-flash.yaml | 15 device is always connected to the expansion bus of the IXP4xx SoCs using one
17 node must be placed inside a chip select node on the IXP4xx expansion bus.
38 - $ref: /schemas/memory-controllers/intel,ixp4xx-expansion-peripheral-props.yaml#
47 compatible = "intel,ixp43x-expansion-bus-controller", "syscon";
|
| /linux-6.12.1/include/linux/ |
| D | brcmphy.h | 90 #define MII_BCM54XX_EXP_DATA 0x15 /* Expansion register data */
91 #define MII_BCM54XX_EXP_SEL 0x17 /* Expansion register select */
92 #define MII_BCM54XX_EXP_SEL_TOP 0x0d00 /* TOP_MISC expansion register select */
94 #define MII_BCM54XX_EXP_SEL_WOL 0x0e00 /* Wake-on-LAN expansion select register */
95 #define MII_BCM54XX_EXP_SEL_ER 0x0f00 /* Expansion register select */
96 #define MII_BCM54XX_EXP_SEL_ETC 0x0d00 /* Expansion register spare + 2k mem */
125 /* legacy access control via rdb/expansion register */
169 * Broadcom Multicolor LED configurations (expansion register 4)
237 * EXPANSION SHADOW ACCESS REGISTERS. (PHY REG 0x15, 0x16, and 0x17)
256 /* Top-MISC expansion registers */
[all …]
|
| /linux-6.12.1/arch/arm/mach-rpc/ |
| D | ecard.c | 7 * Find all installed expansion cards, and handle interrupts from them.
11 * 08-Dec-1996 RMK Added code for the 9'th expansion card - the ether
17 * 29-Sep-1997 RMK Expansion card interrupt hardware not being re-enabled
107 /* ===================== Expansion card daemon ======================== */
109 * Since the loader programs on the expansion cards need to be run
196 * expansion card loader programs. in ecard_task_readbytes()
212 * Set up the expansion card daemon's page tables.
287 * Wake the expansion card daemon to action our request.
423 * Enable and disable interrupts from expansion cards.
497 printk("Expansion card IRQ state:\n"); in ecard_dump_irq_state()
[all …]
|
| D | ecard-loader.S | 16 @ Purpose: call an expansion card loader to read bytes.
29 @ Purpose: call an expansion card loader to reset the card
|
| /linux-6.12.1/arch/arm/boot/dts/intel/ixp/ |
| D | intel-ixp42x-arcom-vulcan.dts | 54 /* Expansion bus settings */
70 /* Expansion bus settings */
89 /* Expansion bus settings */
101 /* Expansion bus settings */
108 /* Expansion bus settings */
|
| /linux-6.12.1/arch/m68k/ |
| D | Kconfig.bus | 11 Say Y here to enable support for the "DIO" expansion bus used in
25 expansion cards in your Amiga that conform to the Amiga
27 expansion cards that do not fit in the Zorro slots but fit in e.g.
|
| /linux-6.12.1/arch/arm/boot/dts/ti/omap/ |
| D | am3517-craneboard.dts | 47 /* goes to expansion connector */
53 /* goes to expansion connector */
63 /* goes to expansion connector */
68 /* goes to expansion connector */
|
| /linux-6.12.1/drivers/bus/ |
| D | intel-ixp4xx-eb.c | 3 * Intel IXP4xx Expansion Bus Controller
359 eb->is_42x = of_device_is_compatible(np, "intel,ixp42x-expansion-bus-controller"); in ixp4xx_exp_probe()
360 eb->is_43x = of_device_is_compatible(np, "intel,ixp43x-expansion-bus-controller"); in ixp4xx_exp_probe()
374 dev_info(dev, "expansion bus at %08x\n", eb->bus_base); in ixp4xx_exp_probe()
409 { .compatible = "intel,ixp42x-expansion-bus-controller", },
410 { .compatible = "intel,ixp43x-expansion-bus-controller", },
411 { .compatible = "intel,ixp45x-expansion-bus-controller", },
412 { .compatible = "intel,ixp46x-expansion-bus-controller", },
|
| /linux-6.12.1/arch/arm/include/asm/ |
| D | ecard.h | 5 * definitions for expansion cards
137 * This contains all the info needed on an expansion card
180 * Read a chunk from an expansion card
182 * ec : expansion card info struct
|
| /linux-6.12.1/Documentation/virt/kvm/x86/ |
| D | nested-vmx.rst | 93 u32 padding[7]; /* room for future expansion */
116 u64 padding64[8]; /* room for future expansion */
156 natural_width paddingl[8]; /* room for future expansion */
203 u32 padding32[8]; /* room for future expansion */
|
| /linux-6.12.1/drivers/scsi/qla2xxx/ |
| D | qla_devtbl.h | 61 "QMC2462", "IBM eServer BC 4Gb FC Expansion Card", /* 0x135 */
62 "QMC2462S", "IBM eServer BC 4Gb FC Expansion Card SFF", /* 0x136 */
84 "QMC2432M", "IBM eServer BC 4Gb FC Expansion Card CFFE", /* 0x14c */
85 "QMC2422M", "IBM eServer BC 4Gb FC Expansion Card CFFX", /* 0x14d */
|
| /linux-6.12.1/arch/arm64/boot/dts/hisilicon/ |
| D | hi3660-hikey960.dts | 213 * from Huawei. The 40 pin low speed expansion connector is named
218 * Appendix "Expansion Connector Signal Description".
522 /* On Low speed expansion */
591 /* On Low speed expansion */
597 /* On Low speed expansion */
613 /* On Low speed expansion */
619 /* On Low speed expansion */
625 /* On High speed expansion */
|
| /linux-6.12.1/scripts/kconfig/ |
| D | preprocess.c | 269 pperror("Too deep recursive expansion"); in variable_expand()
455 * and returns a new string containing the expansion (note that the string is
506 char *expansion, *out; in __expand_string() local
519 expansion = expand_dollar_with_args(&p, argc, argv); in __expand_string()
520 out_len += in_len + strlen(expansion); in __expand_string()
523 strcat(out, expansion); in __expand_string()
524 free(expansion); in __expand_string()
|
| /linux-6.12.1/drivers/parisc/ |
| D | README.dino | 6 ** equipped with third-party or customer-installed PCI I/O expansion
9 ** when data is transmitted through PCI I/O expansion cards on the
|
| /linux-6.12.1/drivers/comedi/drivers/ |
| D | plx9080.h | 135 /* Direct Slave Expansion ROM Big Endian Mode */
149 * Note: The Expansion ROM stuff is only relevant to the PC environment.
150 * This expansion ROM code is executed by the host CPU at boot time.
154 /* Expansion ROM Range Register */
156 /* Expansion ROM Local Base Address (Remap) Register */
159 /* Local Address Space 0/Expansion ROM Bus Region Descriptor Register */
182 /* Expansion ROM Space Prefetch Disable (LBRD0 only) */
192 /* Expansion ROM Space Local Bus Width (LBRD0 only) */
198 /* Expansion ROM Space Internal Wait States (LBRD0 only) */
202 /* Expansion ROM Space Ready Input Enable (LBDR0 only) */
[all …]
|
| /linux-6.12.1/Documentation/networking/devlink/ |
| D | sfc.rst | 52 - Expansion ROM version. For boards where the expansion ROM is split between
|