| /linux-6.12.1/arch/arm/boot/dts/ti/omap/ |
| D | omap-zoom-common.dtsi | 9 ranges = <3 0 0x10000000 0x1000000>, /* CS3: 16MB for UART */
19 reg = <3 0 8>; /* CS3, offset 0, IO size 8 */
55 reg = <3 0x100 8>; /* CS3, offset 0x100, IO size 8 */
66 reg = <3 0x200 8>; /* CS3, offset 0x200, IO size 8 */
77 reg = <3 0x300 8>; /* CS3, offset 0x300, IO size 8 */
|
| /linux-6.12.1/Documentation/devicetree/bindings/iio/proximity/ |
| D | semtech,sx9310.yaml | 53 List of which sensors are combined and represented by CS3.
55 3 - CS3 (internal)
58 0 1 2 3 - CS0 + CS1 + CS2 + CS3
|
| /linux-6.12.1/Documentation/devicetree/bindings/pinctrl/ |
| D | marvell,armada-38x-pinctrl.txt | 24 mpp6 6 gpio, ge0(txclkout), ge0(crs), dev(cs3)
32 mpp14 14 gpio, ge0(rxd2), ptp(clk), dram(vttctrl), spi0(cs3), dev(we1), pcie3(clkreq)
45 mpp27 27 gpio, spi0(cs3), ge1(txclkout), i2c1(sda), sd0(d7), dev(cs2)
59 mpp41 41 gpio, ua1(rxd), ge1(rxctl), ua0(cts), spi1(cs3), dev(burst/last), nand(rb0)
|
| D | marvell,armada-370-pinctrl.txt | 36 spi0(cs3)
82 mpp56 56 gpio, dev(cs2), uart1(cts), uart0(cts), spi0(cs3),
84 mpp57 57 gpio, dev(cs3), uart1(rxd), tdm(fsync), sata0(prsnt),
|
| D | marvell,armada-39x-pinctrl.txt | 24 mpp6 6 gpio, dev(cs3), xsmi(mdio)
46 mpp27 27 gpio, spi0(cs3), i2c1(sda), sd0(d7), dev(cs2), ge(txclkout)
60 mpp41 41 gpio, ua1(rxd), ua0(cts), spi1(cs3), dev(burst/last), nand(rb0), ge(rxctl)
|
| D | marvell,armada-xp-pinctrl.txt | 66 mpp43 43 gpio, uart2(txd), uart0(rts), spi0(cs3), pcie(rstout),
67 spi1(cs3)
|
| /linux-6.12.1/drivers/bus/ |
| D | imx-weim.c | 97 05, /* CS0(128M) CS1(0M) CS2(0M) CS3(0M) */ in imx_weim_gpr_setup()
98 033, /* CS0(64M) CS1(64M) CS2(0M) CS3(0M) */ in imx_weim_gpr_setup()
99 0113, /* CS0(64M) CS1(32M) CS2(32M) CS3(0M) */ in imx_weim_gpr_setup()
100 01111, /* CS0(32M) CS1(32M) CS2(32M) CS3(32M) */ in imx_weim_gpr_setup()
|
| D | qcom-ebi2.c | 26 * CS0, CS1, CS4 and CS5 are two bits wide, CS2 and CS3 are one bit.
134 /* CS3 */
|
| /linux-6.12.1/arch/arm/boot/dts/marvell/ |
| D | armada-370-xp.dtsi | 90 devbus_cs3: devbus-cs3 {
272 <MBUS_ID(0x01, 0xde) 0 0xffffffff>, /* CS3 */
290 <MBUS_ID(0x01, 0xda) 0 0xffffffff>, /* CS3 */
|
| /linux-6.12.1/tools/testing/selftests/net/netfilter/ |
| D | nft_flowtable.sh | 193 ip dscp cs3 counter name ip4dscp3 accept
386 ip dscp set cs3
403 ip dscp set cs3
416 # partial. If flowtable really works, then both dscp-is-0 and dscp-is-cs3
418 ip netns exec "$nsr1" nft -a insert rule inet filter forward ip dscp set cs3
|
| /linux-6.12.1/arch/mips/boot/dts/img/ |
| D | pistachio.dtsi | 441 spim0_cs3_pin: spim0-cs3-pin {
442 spim0-cs3 {
448 spim0_cs3_alt_pin: spim0-cs3-alt-pin {
449 spim0-cs3 {
533 spim1_cs3_pin: spim1-cs3-pin {
534 spim1-cs3 {
|
| /linux-6.12.1/arch/arm/mach-omap1/ |
| D | board-osk.c | 110 /* this is on CS3, wherever it's mapped */
386 /* Workaround for wrong CS3 (NOR flash) timing in osk_init()
388 * wrong CS3 memory timings. This mainly leads to CRC in osk_init()
|
| /linux-6.12.1/drivers/pinctrl/mvebu/ |
| D | pinctrl-armada-38x.c | 55 MPP_VAR_FUNCTION(5, "dev", "cs3", V_88F6810_PLUS)),
96 MPP_VAR_FUNCTION(4, "spi0", "cs3", V_88F6810_PLUS),
180 MPP_VAR_FUNCTION(1, "spi0", "cs3", V_88F6810_PLUS),
253 MPP_VAR_FUNCTION(4, "spi1", "cs3", V_88F6810_PLUS),
|
| D | pinctrl-armada-370.c | 108 MPP_FUNCTION(0x5, "spi0", "cs3")),
305 MPP_FUNCTION(0x4, "spi0", "cs3"),
310 MPP_FUNCTION(0x1, "dev", "cs3"),
|
| D | pinctrl-armada-39x.c | 53 MPP_VAR_FUNCTION(5, "dev", "cs3", V_88F6920_PLUS),
163 MPP_VAR_FUNCTION(1, "spi0", "cs3", V_88F6920_PLUS),
232 MPP_VAR_FUNCTION(4, "spi1", "cs3", V_88F6920_PLUS),
|
| /linux-6.12.1/arch/m68k/include/asm/ |
| D | m5272sim.h | 52 #define MCFSIM_CSBR3 (MCF_MBAR + 0x58) /* CS3 Base Address */
53 #define MCFSIM_CSOR3 (MCF_MBAR + 0x5c) /* CS3 Option */
|
| /linux-6.12.1/arch/arm/mach-s3c/ |
| D | map-base.h | 38 * ioremap CS3.
|
| /linux-6.12.1/arch/sh/include/mach-common/mach/ |
| D | sh7785lcr.h | 15 * 0x0c000000 - 0x0fffffff(CS3) | SD | DDR SDRAM
|
| D | urquell.h | 12 * CS3 |
|
| /linux-6.12.1/arch/powerpc/boot/dts/ |
| D | motionpro.dts | 107 // 8-bit custom Anybus Module on LocalPlus Bus CS3
|
| /linux-6.12.1/drivers/comedi/drivers/ |
| D | plx9052.h | 46 #define PLX9052_CNTRL_CS3 BIT(9) /* UIO3 or CS3# select */
|
| /linux-6.12.1/arch/arm/boot/dts/nxp/imx/ |
| D | imx6dl-colibri-eval-v3.dts | 131 /* weim memory map: 32MB on CS0, CS1, CS2 and CS3 */
|
| /linux-6.12.1/Documentation/devicetree/bindings/spi/ |
| D | spi-orion.txt | 53 <MBUS_ID(0x01, 0xde) 0 0xffffffff>, /* CS3 */
|
| /linux-6.12.1/arch/mips/boot/dts/mscc/ |
| D | jaguar2.dtsi | 125 cs3_pins: cs3-pins {
|
| /linux-6.12.1/net/netfilter/ |
| D | xt_u32.c | 5 * Original author: Don Cohen <don@isis.cs3-inc.com>
|