Searched full:convst (Results 1 – 8 of 8) sorted by relevance
45 convst-gpios:47 GPIO connected to the CONVST pin.90 - convst-gpios122 convst-gpios = <&gpio 25 GPIO_ACTIVE_LOW>;
55 Must be the device tree identifier of the CONVST pin(s). This logic input
190 st->convst_gpio = devm_gpiod_get(st->dev, "convst", GPIOD_OUT_LOW); in ad7091r8_gpio_setup()193 "Error getting convst GPIO\n"); in ad7091r8_gpio_setup()
32 /* channels used when convst gpio is defined */84 udelay(1); /* CONVST pulse width: 10 ns min */ in ad7091_convst()
702 unsigned int convst; in xadc_trigger_set_state() local716 convst = XADC_CONF0_EC; in xadc_trigger_set_state()718 convst = 0; in xadc_trigger_set_state()721 convst); in xadc_trigger_set_state()1366 xadc->convst_trigger = xadc_alloc_trigger(indio_dev, "convst"); in xadc_probe()
78 * @gpio_convst GPIO descriptor for conversion start signal (CONVST)
111 /* The rising edge of the CONVST signal starts a new conversion. */ in ad7606_trigger_handler()433 * edge of CONVST is applied, BUSY goes logic high and transitions low at the
441 * In order to disable the convst trigger, start acquisition on in max1027_set_cnvst_trigger_state()