Home
last modified time | relevance | path

Searched full:bd71837 (Results 1 – 17 of 17) sorted by relevance

/linux-6.12.1/Documentation/devicetree/bindings/regulator/
Drohm,bd71837-regulator.yaml4 $id: http://devicetree.org/schemas/regulator/rohm,bd71837-regulator.yaml#
7 title: ROHM BD71837 Power Management Integrated Circuit regulators
13 List of regulators provided by this controller. BD71837 regulators node
14 should be sub node of the BD71837 MFD node. See BD71837 MFD bindings at
15 Documentation/devicetree/bindings/mfd/rohm,bd71837-pmic.yaml
20 Note that if BD71837 starts at RUN state you probably want to use
26 # The valid names for BD71837 regulator nodes are:
83 # BD71837:
96 # BD71837 power outputs can either be controlled by the PMIC internal
111 # amongst users of BD71837. (This allows for example scaling down the
Drohm,bd71847-regulator.yaml106 # amongst users of BD71837. (This allows for example scaling down the
/linux-6.12.1/Documentation/devicetree/bindings/mfd/
Drohm,bd71837-pmic.yaml4 $id: http://devicetree.org/schemas/mfd/rohm,bd71837-pmic.yaml#
7 title: ROHM BD71837 Power Management Integrated Circuit
17 Datasheet for BD71837 is available at
22 const: rohm,bd71837
112 $ref: /schemas/regulator/rohm,bd71837-regulator.yaml
135 compatible = "rohm,bd71837";
/linux-6.12.1/include/linux/mfd/
Drohm-bd718x7.h39 /* BD71837 specific voltage configurations */
51 /* Registers specific to BD71837 */
60 /* Registers common for BD71837 and BD71847 */
121 /* BD71837 BUCK ramp rate CTRL reg bits */
178 /* BD71837 specific voltage monitoring masks */
/linux-6.12.1/drivers/mfd/
Drohm-bd718x7.c39 { .name = "bd71837-clk", },
40 { .name = "bd71837-pmic", },
191 .compatible = "rohm,bd71837",
229 MODULE_DESCRIPTION("ROHM BD71837/BD71847 Power Management IC driver");
DKconfig2076 tristate "ROHM BD71837 Power Management IC"
2083 Select this option to get support for the ROHM BD71837
2084 Power Management ICs. BD71837 is designed to power processors like
Drohm-bd71828.c117 * We use BD71837 driver to drive the clock block. Only differences to
/linux-6.12.1/drivers/clk/
Dclk-bd718x7.c20 /* BD71837 and BD71847 */
24 * BD71837, BD71847, and BD71828 all use bit [0] to clk output control
145 { "bd71837-clk", ROHM_CHIP_TYPE_BD71837 },
DKconfig450 This driver supports ROHM BD71837, BD71847, BD71850, BD71815
/linux-6.12.1/drivers/regulator/
Dbd718x7-regulator.c3 // bd71837-regulator.c ROHM BD71837MWV/BD71847MWV regulator driver
100 * them we just return a constant. BD71837 BUCK3 and BUCK4 are exceptions as
262 * BD71837 BUCK1/2/3/4
272 * BD71837 BUCK5
332 * BD71837 BUCK7
391 * LDO5 for BD71837
399 * LDO5 for BD71837
442 * BD71837/47/50 ... (ICs supported by this driver) do not provide in bd718x7_xvp_sanity_check()
609 * OPS for BD71837
644 * BD71837 bucks 3 and 4 support defining their enable/disable state also
[all …]
Drohm-regulator.c121 * BD71837 - only buck 1-4 voltages can be changed when they are enabled.
DKconfig245 tristate "ROHM BD71837 Power Regulator"
249 This driver supports voltage regulators on ROHM BD71837 PMIC.
/linux-6.12.1/arch/arm64/boot/dts/freescale/
Dimx8mq-pico-pi.dts67 compatible = "rohm,bd71837";
Dimx8mq-phanbell.dts121 compatible = "rohm,bd71837";
Dimx8mm-ucm-som.dtsi134 compatible = "rohm,bd71837";
Dimx8mq-librem5-devkit.dts289 compatible = "rohm,bd71837";
Dimx8mq-librem5.dtsi829 compatible = "rohm,bd71837";