Home
last modified time | relevance | path

Searched +full:6 +full:a0000 (Results 1 – 25 of 119) sorted by relevance

12345

/linux-6.12.1/Documentation/devicetree/bindings/crypto/
Dfsl-sec6.txt1 SEC 6 is as Freescale's Cryptographic Accelerator and Assurance Module (CAAM).
2 Currently Freescale powerpc chip C29X is embedded with SEC 6.
3 SEC 6 device tree binding include:
4 -SEC 6 Node
9 SEC 6 Node
13 Node defines the base address of the SEC 6 block.
15 configuration registers for the SEC 6 block.
16 For example, In C293, we could see three SEC 6 node.
48 address and length of the SEC 6 configuration registers.
62 crypto@a0000 {
[all …]
/linux-6.12.1/arch/arm/boot/dts/marvell/
Dkirkwood-linksys-viper.dts109 partition@a0000 {
119 partition@4a0000 {
226 /* eth1 is connected to the switch at port 6. However DSA only supports a
Darmada-370-seagate-nas-xbay.dtsi37 sata@a0000 {
63 rtc@6f {
Darmada-370-netgear-rn102.dts44 sata@a0000 {
144 gpios = <&gpio0 6 GPIO_ACTIVE_LOW>;
261 reg = <0x0200000 0x600000>; /* 6MB */
Dkirkwood-l-50.dts78 * 6: Express card reset (active low)
102 gpios = <&gpio1 6 GPIO_ACTIVE_LOW>;
257 port@6 {
258 reg = <6>;
310 port@6 {
311 reg = <6>;
348 partition@a0000 {
Darmada-xp-db.dts89 sata@a0000 {
188 * All 6 slots are physically present as
Darmada-370-rd.dts49 sata@a0000 {
91 gpios = <&gpio0 6 GPIO_ACTIVE_LOW>;
Darmada-370-synology-ds213j.dts99 sata@a0000 {
115 alarm-gpios = <&gpio1 6 GPIO_ACTIVE_HIGH>;
122 <1750 6>,
Dorion5x.dtsi76 interrupts = <6>, <7>, <8>, <9>;
221 ehci1: ehci@a0000 {
/linux-6.12.1/Documentation/devicetree/bindings/dma/
Dmarvell,xor-v2.yaml54 xor0@6a0000 {
/linux-6.12.1/Documentation/devicetree/bindings/pci/
Dnvidia,tegra194-pcie-ep.yaml92 - const: p2u-6
139 6 : C6
219 pcie-ep@141a0000 {
260 "p2u-5", "p2u-6", "p2u-7";
276 pcie-ep@141a0000 {
317 "p2u-5", "p2u-6", "p2u-7";
/linux-6.12.1/arch/arm/boot/dts/ti/omap/
Domap3-cm-t3x.dtsi287 gpmc,we-on-ns = <6>;
290 gpmc,oe-on-ns = <6>;
293 gpmc,page-burst-access-ns = <6>;
317 partition@2a0000 {
321 partition@6a0000 {
/linux-6.12.1/Documentation/devicetree/bindings/pinctrl/
Dsprd,sc9860-pinctrl.txt14 - drive-strength: Drive strength in mA. Supported values: 2, 4, 6, 8, 10,
40 pin_controller: pinctrl@402a0000 {
/linux-6.12.1/arch/arm64/boot/dts/nvidia/
Dtegra234-p3737-0000+p3701-0000.dts95 pwm@32a0000 {
357 pcie@141a0000 {
368 "p2u-5", "p2u-6", "p2u-7";
371 pcie-ep@141a0000 {
386 "p2u-5", "p2u-6", "p2u-7";
/linux-6.12.1/arch/arm/boot/dts/samsung/
Dexynos4.dtsi309 keypad: keypad@100a0000 {
544 i2c_4: i2c@138a0000 {
616 dmas = <&pdma0 7>, <&pdma0 6>;
632 dmas = <&pdma1 7>, <&pdma1 6>;
781 ppmu_dmc0: ppmu@106a0000 {
805 ppmu_rightbus: ppmu@112a0000 {
813 ppmu_leftbus: ppmu@116a0000 {
898 interrupts = <5 6>;
964 interrupts = <4 6>;
Dexynos3250.dtsi764 i2c_4: i2c@138a0000 {
820 dmas = <&pdma0 7>, <&pdma0 6>;
837 dmas = <&pdma1 7>, <&pdma1 6>;
875 ppmu_dmc0: ppmu@106a0000 {
893 ppmu_rightbus: ppmu@112a0000 {
901 ppmu_leftbus: ppmu@116a0000 {
/linux-6.12.1/arch/arm/boot/dts/microchip/
Dat91-wb45n.dtsi16 bootargs = "ubi.mtd=6 root=ubi0:rootfs rootfstype=ubifs rw";
79 ubootenv@a0000 {
Dat91-wb50n.dtsi16 bootargs = "ubi.mtd=6 root=ubi0:rootfs rootfstype=ubifs rw";
146 ubootenv@a0000 {
176 user@6ae0000 {
/linux-6.12.1/arch/powerpc/boot/dts/fsl/
Dppa8548.dts71 partition@7A0000 {
87 rtc@6f {
/linux-6.12.1/arch/arm64/boot/dts/marvell/
Dac5-98dx25xx.dtsi268 usb1: usb@a0000 {
301 spi0: spi@805a0000 {
339 interrupts = <GIC_PPI 6 IRQ_TYPE_LEVEL_HIGH>;
/linux-6.12.1/arch/arm/boot/dts/arm/
Dvexpress-v2m-rs1.dtsi85 led-6 {
93 gpios = <&v2m_led_gpios 6 0>;
117 <0 6 &gic GIC_SPI 6 IRQ_TYPE_LEVEL_HIGH>,
307 v2m_serial1: serial@a0000 {
310 interrupts = <6>;
393 compact-flash@1a0000 {
/linux-6.12.1/arch/arm64/boot/dts/freescale/
Dimx93.dtsi160 interrupts = <GIC_PPI 13 (GIC_CPU_MASK_SIMPLE(6) | IRQ_TYPE_LEVEL_LOW)>,
161 <GIC_PPI 14 (GIC_CPU_MASK_SIMPLE(6) | IRQ_TYPE_LEVEL_LOW)>,
162 <GIC_PPI 11 (GIC_CPU_MASK_SIMPLE(6) | IRQ_TYPE_LEVEL_LOW)>,
163 <GIC_PPI 10 (GIC_CPU_MASK_SIMPLE(6) | IRQ_TYPE_LEVEL_LOW)>;
268 <GIC_SPI 101 IRQ_TYPE_LEVEL_HIGH>, // 6: I3C1 From Bus
445 flexcan1: can@443a0000 {
690 wdog4: watchdog@424a0000 {
842 lpuart6: serial@425a0000 {
942 lpuart8: serial@426a0000 {
1137 eqos: ethernet@428a0000 {
[all …]
Dfsl-ls1046a.dtsi341 <6 0 &gic GIC_SPI 145 IRQ_TYPE_LEVEL_HIGH>,
529 i2c2: i2c@21a0000 {
679 lpuart5: serial@29a0000 {
786 msi3: msi-controller@15a0000 {
829 num-ib-windows = <6>;
868 num-ib-windows = <6>;
907 num-ib-windows = <6>;
/linux-6.12.1/arch/arm64/boot/dts/arm/
Dfoundation-v8.dtsi145 <0 0 6 &gic 0 GIC_SPI 6 IRQ_TYPE_LEVEL_HIGH>,
208 v2m_serial1: serial@a0000 {
211 interrupts = <6>;
/linux-6.12.1/arch/m68k/ifpsp060/
Dilsp.sa4 dc.l $60ff0000,$055a0000,$60ff0000,$05740000
37 dc.l $44874a85,$5deefffd,$6a0844fc,$00004086
72 dc.l $00104a81,$6a040004,$000844c4,$c34048f6
77 dc.l $44800005,$00014a81,$6c064481,$0a050001

12345