Searched +full:5 +full:a000000 (Results 1 – 25 of 52) sorted by relevance
123
/linux-6.12.1/arch/arm/boot/dts/st/ |
D | stm32mp135.dtsi | 11 dcmipp: dcmipp@5a000000 { 23 ltdc: display-controller@5a001000 {
|
D | stm32mp157.dtsi | 20 dsi: dsi@5a000000 {
|
/linux-6.12.1/Documentation/devicetree/bindings/media/ |
D | st,stm32-dcmipp.yaml | 42 enum: [5, 6] 43 default: 5 71 dcmipp@5a000000 {
|
/linux-6.12.1/Documentation/devicetree/bindings/dma/ |
D | socionext,uniphier-mio-dmac.yaml | 55 dmac: dma-controller@5a000000 {
|
/linux-6.12.1/Documentation/devicetree/bindings/display/ |
D | st,stm32-dsi.yaml | 91 dsi: dsi@5a000000 {
|
/linux-6.12.1/Documentation/devicetree/bindings/mmc/ |
D | cdns,sdhci.yaml | 36 # sampling clock. The delay starts from 5ns (for delay parameter equal to 0) 146 emmc: mmc@5a000000 {
|
/linux-6.12.1/arch/arm/boot/dts/arm/ |
D | integrator.dtsi | 42 interrupts = <5>; 111 syscon@1a000000 {
|
/linux-6.12.1/arch/arm64/boot/dts/freescale/ |
D | imx8-ss-dma.dtsi | 18 dma_subsys: bus@5a000000 { 24 lpspi0: spi@5a000000 { 42 lpspi1: spi@5a010000 { 60 lpspi2: spi@5a020000 { 73 dmas = <&edma2 5 0 0>, <&edma2 4 0 FSL_EDMA_RX>; 78 lpspi3: spi@5a030000 { 96 lpuart0: serial@5a060000 { 110 lpuart1: serial@5a070000 { 124 lpuart2: serial@5a080000 { 138 lpuart3: serial@5a090000 { [all …]
|
/linux-6.12.1/Documentation/devicetree/bindings/net/ |
D | qca,ar71xx.yaml | 88 eth1: ethernet@1a000000 { 91 interrupts = <5>;
|
/linux-6.12.1/arch/mips/boot/dts/qca/ |
D | ar9331.dtsi | 135 eth1: ethernet@1a000000 { 138 interrupts = <5>; 268 resets = <&rst 5>;
|
/linux-6.12.1/arch/powerpc/boot/dts/fsl/ |
D | p2020ds.dtsi | 99 kernel@1a000000 { 123 nand@5,0 { 155 interrupts = <5 1 0 0>; 159 interrupts = <5 1 0 0>; 186 fsl,tclk-period = <5>; 239 // IDSEL 0x11 func 5 - PCI slot 1
|
D | mpc8572ds.dtsi | 112 partition@1a000000 { 134 nand@5,0 { 196 fsl,tclk-period = <5>; 279 /* IDSEL 0x11 func 5 - PCI slot 1 */ 327 /* IDSEL 0x12 func 5 - PCI slot 2 */
|
/linux-6.12.1/arch/arm/boot/dts/aspeed/ |
D | aspeed-bmc-asrock-x570d4u.dts | 31 pci_memory: region@9a000000 { 74 <&adc 5>, <&adc 6>, <&adc 7>, <&adc 8>, <&adc 9>, 333 fan@5 { 344 &pinctrl_adc1_default /* 5VSB */ 354 &pinctrl_adc11_default /* 5V */
|
/linux-6.12.1/arch/mips/boot/dts/loongson/ |
D | loongson64-2k1000.dtsi | 115 pci@1a000000 { 313 interrupts = <5 IRQ_TYPE_LEVEL_HIGH>; 316 interrupt-map = <0 0 0 0 &liointc1 5 IRQ_TYPE_LEVEL_HIGH>;
|
D | ls7a-pch.dtsi | 68 pci@1a000000 { 104 ohci@5,0 { 115 ehci@5,1 {
|
/linux-6.12.1/arch/riscv/boot/dts/starfive/ |
D | jh7100-common.dtsi | 55 linux,dma@107a000000 { 208 <GPIOMUX(5, 323 pmic@5e {
|
/linux-6.12.1/arch/arm64/boot/dts/mediatek/ |
D | mt6779.dtsi | 63 cpu5: cpu@5 { 275 camsys: clock-controller@1a000000 {
|
/linux-6.12.1/arch/arm/boot/dts/socionext/ |
D | uniphier-ld4.dtsi | 162 clocks = <&peri_clk 5>; 163 resets = <&peri_rst 5>; 242 dmac: dma-controller@5a000000 { 257 sd: mmc@5a400000 { 277 emmc: mmc@5a500000 { 295 usb0: usb@5a800100 { 309 usb1: usb@5a810100 { 323 usb2: usb@5a820100 { 337 syscon@5f800000 { 347 syscon@5f900000 {
|
D | uniphier-sld8.dtsi | 166 clocks = <&peri_clk 5>; 167 resets = <&peri_rst 5>; 246 dmac: dma-controller@5a000000 { 261 sd: mmc@5a400000 { 282 emmc: mmc@5a500000 { 300 usb0: usb@5a800100 { 314 usb1: usb@5a810100 { 328 usb2: usb@5a820100 { 342 syscon@5f800000 { 352 syscon@5f900000 {
|
D | uniphier-pro4.dtsi | 144 socionext,interrupt-ranges = <0 48 16>, <16 154 5>; 170 clocks = <&peri_clk 5>; 171 resets = <&peri_rst 5>; 276 dmac: dma-controller@5a000000 { 292 sd: mmc@5a400000 { 313 emmc: mmc@5a500000 { 324 dmas = <&dmac 5>; 331 sd1: mmc@5a600000 { 340 resets = <&mio_rst 2>, <&mio_rst 5>; 347 usb2: usb@5a800100 { [all …]
|
/linux-6.12.1/arch/arm/boot/dts/gemini/ |
D | gemini-dlink-dir-685.dts | 64 sck-gpios = <&gpio1 5 GPIO_ACTIVE_HIGH>; 175 sda-gpios = <&gpio0 5 (GPIO_ACTIVE_HIGH|GPIO_OPEN_DRAIN)>; 236 rtl8366rb_cpu_port: ethernet-port@5 { 237 reg = <5>; 351 * gpio0bgrp cover line 5, 6 used by TK I2C 373 * gpio1bgrp cover line 5,8,7 used by panel SPI 474 display-controller@6a000000 {
|
D | gemini.dtsi | 401 interrupts = <5 IRQ_TYPE_EDGE_RISING>; 428 display-controller@6a000000 {
|
/linux-6.12.1/arch/loongarch/boot/dts/ |
D | loongson-2k1000.dtsi | 53 i2c-gpio,delay-us = <5>; /* ~100 kHz */ 64 i2c-gpio,delay-us = <5>; /* ~100 kHz */ 362 pcie@1a000000 { 493 interrupt-map = <0x0 0x0 0x0 0x0 &liointc1 5 IRQ_TYPE_LEVEL_HIGH>;
|
/linux-6.12.1/arch/arm64/boot/dts/socionext/ |
D | uniphier-ld11.dtsi | 228 socionext,interrupt-ranges = <0 48 16>, <16 154 5>, 275 spdif_port0: port@5 { 352 clocks = <&peri_clk 5>; 353 resets = <&peri_rst 5>; 449 emmc: mmc@5a000000 { 468 usb0: usb@5a800100 { 484 usb1: usb@5a810100 { 500 usb2: usb@5a820100 { 516 syscon@5b3e0000 { 533 soc_glue: syscon@5f800000 { [all …]
|
/linux-6.12.1/arch/arm/boot/dts/ti/omap/ |
D | omap4.dtsi | 131 l4_cfg: interconnect@4a000000 { 728 iva_hd_target: target-module@5a000000 {
|
123