Searched +full:100 +full:c0000 (Results 1 – 25 of 98) sorted by relevance
1234
| /linux-6.12.1/arch/arm/boot/dts/nxp/imx/ |
| D | imxrt1050.dtsi | 85 usdhc1: mmc@402c0000 {
122 gpio3: gpio@401c0000 {
142 gpio5: gpio@400c0000 {
155 interrupts = <100>;
|
| D | imx6sx-nitrogen6sx.dts | 122 partition@c0000 {
572 pinctrl_usdhc4_100mhz: usdhc4-100mhzgrp {
|
| /linux-6.12.1/arch/arm64/boot/dts/arm/ |
| D | juno-scmi.dtsi | 26 funnel@220c0000 {
30 funnel@230c0000 {
214 cpu_scp_hpri0: scp-sram@100 {
|
| D | juno-base.dtsi | 305 funnel@220c0000 { /* cluster0 funnel */
414 funnel@230c0000 { /* cluster1 funnel */
751 polling-delay-passive = <100>;
764 polling-delay-passive = <100>;
777 polling-delay-passive = <100>;
784 polling-delay-passive = <100>;
791 polling-delay-passive = <100>;
798 polling-delay-passive = <100>;
|
| /linux-6.12.1/Documentation/devicetree/bindings/i2c/ |
| D | i2c-exynos5.yaml | 14 at various speeds ranging from 100kHz to 3.4MHz.
53 If not specified, the bus operates in fast-speed mode at 100kHz.
129 hsi2c_2: i2c@138c0000 {
|
| /linux-6.12.1/Documentation/devicetree/bindings/display/tegra/ |
| D | nvidia,tegra20-host1x.yaml | 279 resets = <&tegra_car 100>;
283 epp@540c0000 {
362 tvo@542c0000 {
|
| /linux-6.12.1/arch/arm64/boot/dts/broadcom/northstar2/ |
| D | ns2-xmc.dts | 100 partition@2c0000 {
114 reg = <0x04000000 0x06400000>; /* 100MB */
|
| /linux-6.12.1/Documentation/devicetree/bindings/thermal/ |
| D | samsung,exynos-thermal.yaml | 149 tmu@100c0000 {
|
| /linux-6.12.1/arch/arm/boot/dts/samsung/ |
| D | exynos5260.dtsi | 77 cpu2: cpu@100 {
234 clock_aud: clock-controller@128c0000 {
248 clock_isp: clock-controller@133c0000 {
335 mct: timer@100b0000 {
|
| D | exynos3250.dtsi | 406 cmu_dmc: clock-controller@105c0000 {
421 tmu: tmu@100c0000 {
615 adc: adc@126c0000 {
790 i2c_6: i2c@138c0000 {
887 ppmu_cpu: ppmu@106c0000 {
|
| D | exynos4.dtsi | 309 keypad: keypad@100a0000 {
570 i2c_6: i2c@138c0000 {
715 tmu: tmu@100c0000 {
759 hdmicec: cec@100b0000 {
797 ppmu_cpu: ppmu@106c0000 {
|
| /linux-6.12.1/arch/arm64/boot/dts/amlogic/ |
| D | meson-gxm.dtsi | 61 cpu4: cpu@100 {
148 mali: gpu@c0000 {
|
| /linux-6.12.1/Documentation/networking/ |
| D | arcnet-hardware.rst | 28 (slower than Ethernet) and 100 Mbps (faster than normal Ethernet). In fact,
31 100 Mbps card to a 2.5 Mbps card, and so on. From what I hear, my driver does
32 work with 100 Mbps cards, but I haven't been able to verify this myself,
34 your 100 Mbps card. Stop complaining. :)
100 (100 Mbps TCNS and 320 kbps - 32 Mbps ARCnet Plus) use different types of
252 IBM Type 3 100 Ohm up to 100 m
336 C0000 \ One of these is your VGA BIOS - usually C0000.
543 DO NOT SET THIS TO C0000, F0000, OR LESS THAN A0000!
679 0 0 0 0 0 | C0000 | C2000
1094 100 290-29f
[all …]
|
| /linux-6.12.1/arch/arm64/boot/dts/renesas/ |
| D | draak.dtsi | 258 * 100Mbps for reliable communication.
260 max-speed = <100>;
667 bl31@1c0000 {
682 kernel@7c0000 {
|
| D | salvator-common.dtsi | 13 * amixer set "DVC Out" 100%
14 * amixer set "DVC In" 100%
28 * amixer set "DVC Out" 100% // Volume Up
898 bl31@1c0000 {
913 kernel@7c0000 {
|
| D | ebisu.dtsi | 325 * 100Mbps for reliable communication.
327 max-speed = <100>;
761 bl31@1c0000 {
776 kernel@7c0000 {
|
| /linux-6.12.1/arch/arm64/boot/dts/freescale/ |
| D | imx8ulp.dtsi | 242 cgc1: clock-controller@292c0000 {
335 interrupts = <GIC_SPI 100 IRQ_TYPE_LEVEL_HIGH>;
356 lpspi5: spi@293c0000 {
445 iomuxc1: pinctrl@298c0000 {
|
| /linux-6.12.1/arch/arm/boot/dts/microchip/ |
| D | at91-nattis-2-natte-2.dts | 57 100>;
267 bareboxenv@c0000 {
|
| D | at91-tse850-3.dts | 41 pwm-dutycycle-range = <100 1000>;
160 bareboxenv@c0000 {
|
| /linux-6.12.1/arch/mips/boot/dts/ralink/ |
| D | mt7628a.dtsi | 137 watchdog: watchdog@100 {
278 usb@101c0000 {
|
| /linux-6.12.1/arch/arm/boot/dts/rockchip/ |
| D | rk322x.dtsi | 139 i2s1: i2s1@100b0000 {
152 i2s0: i2s0@100c0000 {
163 spdif: spdif@100d0000 {
176 i2s2: i2s2@100e0000 {
480 timer: timer@110c0000 {
523 polling-delay-passive = <100>; /* milliseconds */
837 usb_host1_ehci: usb@300c0000 {
|
| /linux-6.12.1/arch/arm64/boot/dts/exynos/ |
| D | exynos850.dtsi | 117 cpu4: cpu@100 {
191 pdma0: dma-controller@120c0000 {
570 sysmmu_dpu: sysmmu@130c0000 {
747 hsi2c_2: i2c@138c0000 {
|
| /linux-6.12.1/arch/arm64/boot/dts/nuvoton/ |
| D | ma35d1.dtsi | 146 gpioe: gpio@100 {
343 uart12: serial@407c0000 {
|
| /linux-6.12.1/arch/arm/boot/dts/marvell/ |
| D | kirkwood-synology.dtsi | 224 partition@3c0000 {
321 gpio-fan-100-32-35 {
342 gpio-fan-100-15-18 {
363 gpio-fan-100-15-35-1 {
384 gpio-fan-100-15-35-3 {
|
| /linux-6.12.1/arch/arm/boot/dts/socionext/ |
| D | uniphier-ld4.dtsi | 55 l2: cache-controller@500c0000 {
355 efuse@100 {
|
1234