Lines Matching full:aggregation

24  * DOC: TX A-MPDU aggregation
26  * Aggregation on the TX side requires setting the hardware flag
28  * packets with a flag indicating A-MPDU aggregation. The driver
32  * When TX aggregation is started by some subsystem (usually the rate
40  * start the aggregation session after the peer has also responded.
42  * again right away. Note that it is possible for the aggregation
52  * Similarly, when the aggregation session is stopped by the peer
138  * When multiple aggregation sessions on multiple stations
141  * to not get into a situation where one of the aggregation
268 	 * aggregation, since the OPERATIONAL bit has long been cleared.  in ieee80211_remove_tid_tx()
373 	 * another CPU) that have already gotten past the aggregation  in __ieee80211_stop_tx_ba_session()
381 	 * the aggregation session is no longer OPERATIONAL.  in __ieee80211_stop_tx_ba_session()
501 	 * Start queuing up packets for this aggregation session.  in ieee80211_tx_ba_session_handle_start()
691 	/* check if the TID is not in aggregation flow already */  in ieee80211_start_tx_ba_session()
700 	/* prepare A-MPDU MLME for Tx aggregation */  in ieee80211_start_tx_ba_session()
758 	ht_dbg(sta->sdata, "Aggregation is on for %pM tid %d\n",  in ieee80211_agg_tx_operational()