1 /* SPDX-License-Identifier: (GPL-2.0 OR BSD-3-Clause) */
2 /* Copyright(c) 2015-17 Intel Corporation. */
70 /* sample packaging for block. It can be per port or per channel */
75  * enum sdw_slave_status - Slave status
93  * @SDW_CLK_PRE_DEPREPARE: pre clock stop de-prepare
94  * @SDW_CLK_POST_DEPREPARE: post clock stop de-prepare
104  * enum sdw_command_response - Command response as defined by SDW spec
139  * enum sdw_stream_type: data stream type
141  * @SDW_STREAM_PCM: PCM data stream
142  * @SDW_STREAM_PDM: PDM data stream
190  * enum sdw_p15_behave - Slave Port 15 behaviour when the Master attempts a
201  * enum sdw_dpn_type - Data port types
216  * enum sdw_clk_stop_mode - Clock Stop modes
219  * @SDW_CLK_STOP_MODE1: Slave may have entered a deeper power-saving mode,
228  * struct sdw_dp0_prop - DP0 properties
238  * @ch_prep_timeout: Port-specific timeout value, in milliseconds
240  * implementation-defined interrupts
258  * struct sdw_dpn_audio_mode - Audio mode properties for DPn
290  * struct sdw_dpn_prop - Data Port DPn properties
303  * @ch_prep_timeout: Port-specific timeout value, in milliseconds
305  * implementation-defined interrupts
346  * struct sdw_slave_prop - SoundWire Slave properties
348  * @wake_capable: Wake-up events are supported
350  * @clk_stop_mode1: Clock-Stop Mode 1 is supported
352  * @clk_stop_timeout: Worst-case latency of the Clock Stop Prepare State
354  * @ch_prep_timeout: Worst-case latency of the Channel Prepare State Machine
357  * state machine (P=1 SCSP_SM) after exit from clock-stop mode1
408  * struct sdw_master_prop - Master properties
410  * @clk_stop_modes: Bitmap, bit N set when clock-stop-modeN supported
423  * @hw_disabled: if true, the Master is not functional, typically due to pin-mux
474  * struct sdw_slave_id - Slave ID
497  * Helper macros to extract the MIPI-defined IDs
526  * struct sdw_slave_intr_status - Slave interrupt status
538  * sdw_reg_bank - SoundWire register banks
548  * struct sdw_prepare_ch: Prepare/De-prepare Data Port channel
552  * @prepare: Prepare (true) /de-prepare (false) channel
617  * @clk_stop: handle imp-def sequences before and after prepare and de-prepare
637  * struct sdw_slave - SoundWire Slave
649  * @dev_num_sticky: one-time static Device Number assigned by Bus
656  * @unattach_request: mask field to keep track why the Slave re-attached and
657  * was re-initialized. This is useful to deal with potential race conditions
694  * struct sdw_master_device - SoundWire 'Master Device' representation
741  * This is used to program the Data Port based on Data Port stream
762  * @blk_pkg_mode: Block per channel or block per port
768  * during a bank switch without any artifacts in audio stream.
823  * struct sdw_defer - SDW deffered message
835  * struct sdw_master_ops - Master driver ops
844  * @read_ping_status: Read status from PING frames, reported with two bits per Device.
846  * @get_device_num: Callback for vendor-specific device_number allocation
847  * @put_device_num: Callback for vendor-specific device_number release
871  * struct sdw_bus - SoundWire bus
872  * @dev: Shortcut to &bus->md->dev to avoid changing the entire code.
874  * @controller_id: system-unique controller ID. If set to -1, the bus @id will be used.
876  * @id: bus system-wide unique id
887  * @vendor_specific_prop: pointer to non-standard properties
888  * @m_rt_list: List of Master instance of all stream(s) running on Bus. This
899  * @hw_sync_min_links: Number of links used by a stream above which
900  * hardware-based synchronization is required. This value is only
901  * meaningful if multi_link is set. If set to 1, hardware-based
902  * synchronization will be used even if a stream only uses a single
956  * sdw_stream_config: Master or Slave stream configuration
958  * @frame_rate: Audio frame rate of the stream, in Hz
959  * @ch_count: Channel count of the stream
960  * @bps: Number of bits per audio sample
962  * @type: Stream type PCM or PDM
973  * sdw_stream_state: Stream states
975  * @SDW_STREAM_ALLOCATED: New stream allocated.
976  * @SDW_STREAM_CONFIGURED: Stream configured
977  * @SDW_STREAM_PREPARED: Stream prepared
978  * @SDW_STREAM_ENABLED: Stream enabled
979  * @SDW_STREAM_DISABLED: Stream disabled
980  * @SDW_STREAM_DEPREPARED: Stream de-prepared
981  * @SDW_STREAM_RELEASED: Stream released
994  * sdw_stream_params: Stream parameters
998  * @bps: bits per channel sample
1007  * sdw_stream_runtime: Runtime stream parameters
1009  * @name: SoundWire stream name
1010  * @params: Stream parameters
1011  * @state: Current state of the stream
1012  * @type: Stream type PCM or PDM
1013  * @master_list: List of Master runtime(s) in this stream.
1014  * master_list can contain only one m_rt per Master instance
1015  * for a stream
1016  * @m_rt_count: Count of Master runtime(s) in this stream
1028 void sdw_release_stream(struct sdw_stream_runtime *stream);
1036 		struct sdw_stream_runtime *stream);
1038 		struct sdw_stream_runtime *stream);
1040 int sdw_prepare_stream(struct sdw_stream_runtime *stream);
1041 int sdw_enable_stream(struct sdw_stream_runtime *stream);
1042 int sdw_disable_stream(struct sdw_stream_runtime *stream);
1043 int sdw_deprepare_stream(struct sdw_stream_runtime *stream);
1058 			 struct sdw_stream_runtime *stream);
1060 			    struct sdw_stream_runtime *stream);
1080 				       struct sdw_stream_runtime *stream)  in sdw_stream_add_slave()  argument
1083 	return -EINVAL;  in sdw_stream_add_slave()
1087 					  struct sdw_stream_runtime *stream)  in sdw_stream_remove_slave()  argument
1090 	return -EINVAL;  in sdw_stream_remove_slave()
1097 	return -EINVAL;  in sdw_read()
1103 	return -EINVAL;  in sdw_write()
1109 	return -EINVAL;  in sdw_write_no_pm()
1115 	return -EINVAL;  in sdw_read_no_pm()
1121 	return -EINVAL;  in sdw_nread()
1127 	return -EINVAL;  in sdw_nread_no_pm()
1133 	return -EINVAL;  in sdw_nwrite()
1139 	return -EINVAL;  in sdw_nwrite_no_pm()
1145 	return -EINVAL;  in sdw_update()
1151 	return -EINVAL;  in sdw_update_no_pm()