linux/regulator/driver.h

67  *                   selector.
68  * @map_voltage: Convert a voltage into a selector
72  * @get_voltage_sel: Return the currently configured voltage selector for the
76  *	if the selector indicates a voltage that is unusable on this system;
135  *               The function receives the from and to voltage selector as
157 	int (*list_voltage) (struct regulator_dev *, unsigned selector);
161 			    unsigned *selector);
163 	int (*set_voltage_sel) (struct regulator_dev *, unsigned selector);
283  * @min_uV: Voltage given by the lowest selector (if linear mapping)
284  * @uV_step: Voltage increase with each selector (if linear mapping)
285  * @linear_min_sel: Minimal selector for starting linear mapping
293  *                                   must have corresponding selector here.
299  * @vsel_range_reg: Register for range selector when using pickable ranges
301  * @vsel_range_mask: Mask for register bitfield used for range selector
304  * @vsel_reg: Register for selector when using ``regulator_map_*_voltage_*``
305  * @vsel_mask: Mask for register bitfield used for selector
306  * @vsel_step: Specify the resolution of selector stepping when setting
307  *	       voltage. If 0, then no stepping is done (requested selector is
310  *	       selector by the specified step value.
311  * @csel_reg: Register for current limit selector using regmap set_current_limit
312  * @csel_mask: Mask for register bitfield used for current limit selector
721 				  unsigned int selector);
723 						   unsigned int selector);
725 					unsigned int selector);
727 				  unsigned int selector);
770 					     unsigned int selector);
773 				       unsigned int selector);