include/linux/power_supply.h

355  * @charge_current_max_ua: maintenance charging current that is used to keep
358  *   reach this voltage the maintenance charging current is turned off. It is
360  * @charge_voltage_max_uv: maintenance charging voltage that is usually a bit
363  * @safety_timer_minutes: maintenance charging safety timer, with an expiry
364  *   time in minutes. We will only use maintenance charging in this setting
366  *   maintenance charge current and voltage pair in respective array and wait
391  * To prolong the life of the battery, maintenance charging is applied after
402  * Maintenance charging uses the voltages from this table: a table of settings
404  * CC/CV charging. The maintenance charging will for safety reasons not go on
405  * indefinately: we lower the current and voltage with successive maintenance
412  * at 900mA to 4340mV, then maintenance charged at 600mA and 4150mV for up to
413  * 60 hours, then maintenance charged at 600mA and 4100mV for up to 200 hours.
417  * For most mobile electronics this type of maintenance charging is enough for
418  * the user to disconnect the device and make use of it before both maintenance
423  * If the voltage anyway drops to charge_restart_voltage_uv during maintenance
463  *   poles reach charge_restart_voltage_uv unless we use maintenance charging.
480  * @maintenance_charge: an array of maintenance charging settings to be used
482  * @maintenance_charge_size: the number of maintenance charging settings in
645  * After this the battery is fully charged, and if we do not support maintenance
651  * If we support maintenance charging the voltage is however kept high after