include/linux/power_supply.h

345 	int resistance;	/* internal resistance percent */  member
350 	int ri_uohm;	/* Internal resistance in microohm */
497  * @factory_internal_resistance_uohm: the internal resistance of the battery
498  *   at fabrication time, expressed in microohms. This resistance will vary
500  *   nominal ballpark figure. This internal resistance is given for the state
502  * @factory_internal_resistance_charging_uohm: the internal resistance of the
504  *   The charging process will affect the internal resistance of the battery
505  *   so this value provides a better resistance under these circumstances.
506  *   This resistance will vary depending on the lifetime and charge of the
537  *   expected internal resistance at this temperature. The resistance is given
539  *   resistance of the battery is usually necessary for calculating the open
542  *   by temperature: highest temperature with lowest resistance first, lowest
543  *   temperature with highest resistance last.
546  *   to internal resistance (Ri). The resistance is given in microohm for the
547  *   corresponding voltage in microvolts. The internal resistance is used to
549  *   of the battery. These voltages to resistance tables apply when the battery
556  *   internal resistance characteristics so a separate table is needed.*
560  * @bti_resistance_ohm: The Battery Type Indicator (BIT) nominal resistance
564  * @bti_resistance_tolerance: The tolerance in percent of the BTI resistance,
566  *   tolerance is 10% we will detect a proper battery if the BTI resistance
672  * with an ideal voltage source (V) in series with an internal resistance (Ri)
687  * If we disconnect the load (here simplified as a fixed resistance Rload)
708  * resistance change, and it will affect the VBAT under load, so correlating
815 					      int resistance);