Lines Matching +full:usb +full:- +full:phy

1 # SPDX-License-Identifier: GPL-2.0
3 # Physical Layer USB driver configuration
5 menu "USB Physical Layer drivers"
12 # USB Transceiver Drivers
15 	tristate "AB8500 USB Transceiver Driver"
19 	  Enable this to support the USB OTG transceiver in AB8500 chip.
24 	tristate "Freescale USB OTG Transceiver Driver"
29 	  Enable this to support Freescale USB OTG transceiver.
32 	tristate "Keystone USB PHY Driver"
36 	  Enable this to support Keystone USB phy. This driver provides
37 	  interface to interact with USB 2.0 and USB 3.0 PHY that is part
41 	tristate "NOP USB Transceiver Driver"
42 	depends on USB_GADGET || !USB_GADGET # if USB_GADGET=m, NOP can't be built-in
45 	  This driver is to be used by all the usb transceiver which are either
46 	  built-in with usb ip or which are autonomous and doesn't require any
47 	  phy programming such as ISP1x04 etc.
53 	tristate "AM335x USB PHY Driver"
60 	  This driver provides PHY support for that phy which part for the
64 	tristate "TWL6030 USB Transceiver Driver"
68 	  Enable this to support the USB OTG transceiver on TWL6030
71 	  UTMI PHY is embedded in OMAP4430. The internal PHY configurations APIs
73 	  The definition of internal PHY APIs are in the mach-omap2 layer.
76 	tristate "GPIO based peripheral-only VBUS sensing 'transceiver'"
87 	  (master/peripheral) shall use the USB based connection
91 	tristate "OMAP USB OTG controller driver"
98 	  will be called phy-omap-otg.
101 	tristate "Tahvo USB transceiver driver"
106 	  Enable this to support USB transceiver on Tahvo. This is used
111 	bool "Device in USB host mode by default"
113 	  Say Y here, if you want the device to enter USB host mode
117 	tristate "NXP ISP1301 USB transceiver support"
118 	depends on USB || USB_GADGET
122 	  Say Y here to add support for the NXP ISP1301 USB transceiver driver.
123 	  This chip is typically used as USB transceiver for USB host, gadget
127 	  module will be called phy-isp1301.
130 	tristate "Marvell USB OTG support"
135 	  Say Y here if you want to build Marvell USB OTG transceiver
142 	tristate "Freescale MXS USB PHY support"
147 	  Enable this to support the Freescale MXS USB PHY.
149 	  MXS Phy is used by some of the i.MX SoCs, for example imx23/28/6x.
152 	tristate "NVIDIA Tegra USB PHY Driver"
158 	  This driver provides PHY support for the USB controllers found
166 	  Enable this to support ULPI connected USB OTG transceivers which
172 	  Provides read/write operations to the ULPI phy register set for