Lines Matching +full:soc +full:- +full:controller
1 # SPDX-License-Identifier: GPL-2.0
3 # USB Host Controller Drivers
5 comment "USB Host Controller Drivers"
11 The Cypress C67x00 (EZ-Host/EZ-OTG) chips are dual-role
14 Enable this option to support this chip in host controller mode.
24 The eXtensible Host Controller Interface (xHCI) is standard for USB 3.0
25 "SuperSpeed" host controller hardware.
28 module will be called xhci-hcd.
46 tristate "Support for additional Renesas xHCI controller with firmware"
49 Say 'Y' to enable the support for the Renesas xHCI controller with
68 Say 'Y' to enable the support for the xHCI host controller
76 Say 'Y' to enable the support for the xHCI host controller
86 Say 'Y' to enable the support for the xHCI host controller
90 tristate "xHCI support for Renesas R-Car SoCs"
95 Say 'Y' to enable the support for the xHCI host controller
96 found in Renesas R-Car ARM SoCs.
99 bool "xHCI support for Renesas RZ/V2M SoC"
104 Say 'Y' to enable the support for the xHCI host controller
105 found in Renesas RZ/V2M SoC.
113 Say 'Y' to enable the support for the xHCI host controller
129 found in Broadcom STB SoC's.
132 modules will be called ohci-platform.ko, ehci-brcm.ko and
133 xhci-plat-hcd.ko
142 The Enhanced Host Controller Interface (EHCI) is standard for USB 2.0
143 "high speed" (480 Mbit/sec, 60 Mbyte/sec) host controller hardware.
144 If your USB host controller supports USB 2.0, you will likely want to
145 configure this Host Controller Driver.
150 connect to a companion controller. If you configure EHCI, you should
152 Controller Driver or UHCI (for Via motherboards) Host Controller
158 module will be called ehci-hcd.
164 Some EHCI chips have vendor-specific extensions to integrate
166 controller is needed. It's safe to say "y" even if your
167 controller doesn't support this feature.
185 Controller, and some of those devices will not work correctly
186 (possibly due to "ENOSPC" or "-28" errors), say Y. Conversely, if
200 bool "Use Xilinx usb host EHCI controller core"
205 Xilinx xps USB host controller core is EHCI compliant and has
206 transaction translator built-in. It can be configured to either
211 tristate "Support for Freescale on-chip EHCI USB controller"
217 tristate "Support for Nuvoton NPCM on-chip EHCI USB controller"
221 Enables support for the on-chip EHCI controller on
230 Enables support for the on-chip EHCI controller on
234 tristate "Support for Marvell EBU on-chip EHCI USB controller"
238 Enables support for the on-chip EHCI controller on Marvell's
241 on Marvell's mobile PXA and MMP SoC, see "EHCI support for
242 Marvell PXA/MMP USB controller" for those.
245 tristate "Support for ST SPEAr on-chip EHCI USB controller"
249 Enables support for the on-chip EHCI controller on
253 tristate "Support for ST STiHxxx on-chip EHCI USB controller"
258 Enable support for the on-chip EHCI controller found on
259 STMicroelectronics consumer electronics SoC's.
262 tristate "Support for Atmel on-chip EHCI USB controller"
266 Enables support for the on-chip EHCI controller on
284 bool "EHCI support for PPC USB controller on OF platform bus"
288 Enables support for the USB controller present on the PowerPC
292 bool "EHCI support for SuperH USB controller"
295 Enables support for the on-chip EHCI controller on the SuperH.
296 If you use the PCI EHCI controller, this option is not necessary.
299 tristate "EHCI support for Samsung S5P/Exynos SoC Series"
302 Enable support for the Samsung S5Pv210 and Exynos SOC's on-chip EHCI
303 controller.
306 tristate "EHCI support for Marvell PXA/MMP USB controller"
310 Enables support for Marvell (including PXA and MMP series) on-chip
311 USB SPH and OTG controller. SPH is a single port host, and it can
312 only be EHCI host. OTG is controller that can switch to host mode.
314 controller used by the EBU-type SoCs including Orion, Kirkwood,
316 on-chip EHCI USB controller" for those.
322 This driver supports USB host controller on some Cavium
326 will be called octeon-hcd.
337 bool "Octeon on-chip EHCI support (DEPRECATED)"
345 Enable support for the Octeon II SOC's on-chip EHCI
346 controller. It is needed for high-speed (480Mbit/sec)
356 The OXU210HP is an USB host/OTG/device controller. Enable this
363 module will be called oxu210hp-hcd.
375 module will be called isp116x-hcd.
382 Supports the Philips ISP1362 chip as a host controller
387 module will be called isp1362-hcd.
390 tristate "MAX3421 HCD (USB-over-SPI) support"
393 The Maxim MAX3421E chip supports standard USB 2.0-compliant
394 full-speed devices either in host or peripheral mode. This
395 driver supports the host-mode of the MAX3421E only.
398 be called max3421-hcd.
404 The Open Host Controller Interface (OHCI) is a standard for accessing
405 USB 1.1 host controller hardware. It does more in hardware than Intel's
406 UHCI specification. If your USB host controller follows the OHCI spec,
407 say Y. On most non-x86 systems, and on x86 hardware that's not using a
408 USB controller from Intel or VIA, this is appropriate. If your host
409 controller doesn't use PCI, this is probably appropriate. For a PCI
410 based system where you're not sure, the "lspci -v" entry will list the
411 right "prog-if" for your USB controller(s): EHCI, OHCI, or UHCI.
414 module will be called ohci-hcd.
423 Enables support for the OHCI controller on OMAP1/2 chips.
426 tristate "Support for ST SPEAr on-chip OHCI USB controller"
430 Enables support for the on-chip OHCI controller on
434 tristate "Support for ST STiHxxx on-chip OHCI USB controller"
439 Enable support for the on-chip OHCI controller found on
440 STMicroelectronics consumer electronics SoC's.
443 tristate "OHCI support for Samsung S3C64xx SoC series"
447 Enables support for the on-chip OHCI controller on
451 tristate "Support for LPC on-chip OHCI USB controller"
457 Enables support for the on-chip OHCI controller on
461 tristate "Support for PXA27X/PXA3XX on-chip OHCI USB controller"
465 Enables support for the on-chip OHCI controller on
469 tristate "Support for Atmel on-chip OHCI USB controller"
473 Enables support for the on-chip OHCI controller on
485 Enables support for the on-chip OHCI controller on
496 controller. This driver cannot currently be a loadable
505 Enables support for big-endian USB controllers present on the
513 Enables support for little-endian USB controllers present on the
522 tristate "OHCI support for PCI-bus USB controllers"
527 Enables support for PCI-bus plug-in USB controller cards.
548 tristate "OHCI support for Samsung S5P/Exynos SoC Series"
551 Enable support for the Samsung S5Pv210 and Exynos SOC's on-chip OHCI
552 controller.
563 bool "Octeon on-chip OHCI support (DEPRECATED)"
573 Enable support for the Octeon II SOC's on-chip OHCI
574 controller. It is needed for low-speed USB 1.0 device
583 The Universal Host Controller Interface is a standard by Intel for
585 host controller). If your USB host controller conforms to this
590 133) and LEON/GRLIB SoCs with the GRUSBHC controller.
594 module will be called uhci-hcd.
609 tristate "Freescale QE USB Host Controller support"
614 This driver enables support for Freescale QE USB Host Controller
619 bool "Freescale QE USB Host Controller debug support"
629 The SL811HS is a single-port USB controller that supports either
631 board has this chip, and you want to use it as a host controller.
635 module will be called sl811-hcd.
652 REX-CFU1U CF card (often used with PDAs). If unsure, say N.
661 The R8A66597 is a USB 2.0 host and peripheral controller.
664 to use it as a host controller. If unsure, say N.
667 module will be called r8a66597-hcd.
673 The Renesas USBHS is a USB 2.0 host and peripheral controller.
676 to use it as a host controller. If unsure, say N.
679 module will be called renesas-usbhs.
687 Enable support for the EHCI and OCHI host controller on an bcma bus.
699 Enable support for the EHCI and OCHI host controller on an bcma bus.
709 supported by the host controller drivers.
711 One such test mode is the Embedded High-speed Host Electrical Test
712 (EHSET) for EHCI host controller hardware, specifically the "Single
713 Step Set Feature" test. Typically this will be enabled for On-the-Go
714 or embedded hosts that need to undergo USB-IF compliance testing with