Lines Matching full:temperature

12 	  Each thermal zone contains its own temperature, trip points,
25 	  zones discovery, temperature readings and events such as
130 	  Select this if you want to control temperature based on
161 	  Say 'Y' here if you want to use two point temperature regulation
227 	  directory to support temperature emulation. With emulation sysfs node,
228 	  user can manually input temperature and test the different trip
233 	  flooding this sysfs node with low temperature values.
241 	  memory-mapped reads to get the temperature.  Any HW/System that
242 	  allows temperature reading by a single memory-mapped reading, be it
258 	tristate "Temperature sensor driver for Freescale i.MX SoCs"
264 	  Support for Temperature Monitor (TEMPMON) found on Freescale i.MX SoCs.
270 	tristate "Temperature sensor driver for NXP i.MX SoCs with System Controller"
274 	  Support for Temperature Monitor (TEMPMON) found on NXP i.MX SoCs with
276 	  controller via MU (message unit) IPC to get temperature from thermal
281 	tristate "Temperature sensor driver for Freescale i.MX8MM SoC"
298 	  This includes temperature reading functionality.
301 	tristate "Temperature sensor driver for Maxim MAX77620 PMIC"
305 	  Support for die junction temperature warning alarm for Maxim
307 	  interrupts when PMIC die temperature cross the threshold of
350 	  Rockchip thermal driver provides support for Temperature sensor
353 	  CPUs when the Temperature crosses the passive trip point.
356 	tristate "Temperature sensor on Marvell Kirkwood SoCs"
365 	tristate "Temperature sensor on Marvell Dove SoCs"
398 	  This will report PMIC junction over-temperature for one thermal trip
453 	  This enabled a thermal sysfs driver for the temperature sensor
456 	  to this driver. This driver reports the temperature by reading ADC
457 	  channel and converts it to temperature based on lookup table.
470 	  thermal framework. The driver supports CPU thermal zone temperature
474 	tristate "Temperature sensor on Spreadtrum SoCs"
497 	  are used to obtain the temperature of the current node and set the
498 	  temperature range to trigger the interrupt. When the input temperature
499 	  is higher than the high temperature threshold or lower than the low
500 	  temperature threshold, the interrupt will occur.