Lines Matching +full:fsi +full:- +full:slave +full:- +full:engine
1 # SPDX-License-Identifier: GPL-2.0-only
13 dynamic device discovery; some are even write-only or read-only.
17 chips, analog to digital (and d-to-a) converters, and more.
36 # MASTER side ... talking to discrete SPI slave chips including microcontrollers
44 If your system has an master-capable SPI controller (which
46 controller and the protocol drivers for the SPI slave chips
56 by providing a high-level interface to send memory-like commands.
66 This enables support for SPI-NAND mode on the Airoha NAND
68 is implemented as a SPI-MEM controller.
90 to a SPI slave to Avalon bridge in a Intel MAX BMC.
155 supports spi-mem interface.
166 tristate "Analog Devices AXI SPI Engine controller"
169 This enables support for the Analog Devices AXI SPI Engine SPI controller.
170 It is part of the SPI Engine framework that is used in some Analog Devices
182 is for the regular SPI controller. Slave mode operation is not also
234 this code to manage the per-word or per-transfer accesses to the
264 Flash over 1/2/4-bit wide bus. Enable this option if you have a
276 Flash over up to 8-bit wide bus. Enable this option if you have a
290 This enables dedicated general purpose SPI/Microwire1-compatible
291 master mode interface (SSI1) for CLPS711X-based CPUs.
309 tristate "Texas Instruments DaVinci/DA8x/OMAP-L/AM1x SoC SPI controller"
313 SPI master controller for DaVinci/DA8x/OMAP-L/AM1x SPI modules.
331 tristate "Memory-mapped io interface driver for DW SPI core"
335 tristate "Baikal-T1 SPI driver for DW SPI core"
339 Baikal-T1 SoC is equipped with three DW APB SSI-based MMIO SPI
342 part of the Baikal-T1 System Boot Controller has got a very
344 chip-select and Tx/Rx FIFO with just 8 words depth available.
345 The later one is normally connected to an external SPI-nor flash
349 bool "Directly mapped Baikal-T1 Boot SPI flash support"
353 Baikal-T1 System Boot Controller. It is a 16MB MMIO region, which
358 time-critical tasks (like the SPI memory operations implemented
364 tristate "Diolan DLN-2 USB SPI adapter"
371 will be called spi-dln2.
384 The external bus unit (EBU) found on the FALC-ON SoC has SPI
390 tristate "FSI SPI driver"
391 depends on FSI
393 This enables support for the driver for FSI bus attached SPI
411 supports the high-level SPI memory interface.
428 will be called hisi-kunpeng-spi.
444 Up to four slave devices can be connected on two buses with two
447 supports the high-level SPI memory interface.
450 tristate "GPIO-based bitbanging SPI Master"
454 This simple GPIO bitbanging SPI master uses the arch-neutral GPIO
485 will be called spi-ingenic.
506 will be called spi-intel-pci.
518 exposes the low level SPI-NOR opcodes to the software. Using
525 will be called spi-intel-platform.
528 tristate "J-Core SPI Master"
531 This enables support for the SPI master controller in the J-Core
570 tristate "ICP DAS LP-8841 SPI Controller for RTC"
574 DS-1302 real time clock.
577 LP-8x4x industrial computer.
580 tristate "Freescale MPC52xx SPI (non-PSC) controller support"
645 will be called spi-ljca.
670 If built as a module, it will be called spi-microchip-core.
679 If built as a module, it will be called spi-microchip-core-qspi.
711 This enables support for SPI-NAND mode on the MediaTek NAND
713 is implemented as a SPI-MEM controller with pipelined ECC
725 supports the spi-mem interface.
735 supports spi-mem interface.
803 called as spi-pci1xxxx.
877 tristate "Renesas RPC-IF SPI driver"
880 SPI driver for Renesas R-Car Gen3 or RZ/G2 RPC-IF.
905 Qualcomm Universal Peripheral (QUP) core is an AHB slave that
907 for serial peripheral interface (SPI) mini-core. SPI in master
918 This driver supports GENI serial engine based SPI controller in
920 yes to this option, support will be included for the built-in SPI
924 will be called spi-geni-qcom.
972 tristate "MediaTek SPI slave device"
976 This selects the MediaTek(R) SPI slave device driver.
977 If you want to use MediaTek(R) SPI slave interface,
979 SPI slave drivers for Mediatek MT27XX series ARM SoCs.
987 for connecting an SPI Flash memory over up to 8-bit wide bus.
1022 supports spi-mem interface.
1025 tristate "STMicroelectronics SPI SSC-based driver"
1050 called as spi-sunplus-sp7021.
1061 that use the de-facto standard SPI protocol.
1063 It also supports the new dual-bit and quad-bit SPI protocol.
1145 tristate "Analog Devices AD-FMCOMMS1-EBZ SPI-I2C-bridge driver"
1148 Support for the SPI-I2C bridge found on the Analog Devices
1149 AD-FMCOMMS1-EBZ board.
1220 select one or more specific mux-controller drivers.
1258 # SLAVE side ... listening to other SPI masters
1262 bool "SPI slave protocol handlers"
1264 If your system has a slave-capable SPI controller, you can enable
1265 slave protocol handlers.
1270 tristate "SPI slave handler reporting boot up time"
1272 SPI slave handler responding with the time of reception of the last
1276 tristate "SPI slave handler controlling system state"
1278 SPI slave handler to allow remote control of system reboot, power